configs: Migrate CMD_NAND*

[platform/kernel/u-boot.git] / include / configs / sbc8548.h

diff --git a/include/configs/sbc8548.h b/include/configs/sbc8548.h
index 008781e..cf9809d 100644 (file)
--- a/include/configs/sbc8548.h
+++ b/include/configs/sbc8548.h
@@ -36,8 +36,6 @@
 /*
  * High Level Configuration Options
  */
-#define CONFIG_BOOKE           1       /* BOOKE */
-#define CONFIG_E500            1       /* BOOKE e500 family */
 #define CONFIG_SBC8548         1       /* SBC8548 board specific */
 
 /*
@@ -69,8 +67,6 @@
 
 #define CONFIG_INTERRUPTS              /* enable pci, srio, ddr interrupts */
 
-#define CONFIG_FSL_LAW         1       /* Use common FSL init code */
-
 /*
  * Below assumes that CCB:SYSCLK remains unchanged at 6:1 via SW2:[1-4]
  */
@@ -90,8 +86,6 @@
  */
 #define CONFIG_ENABLE_36BIT_PHYS       1
 
-#define CONFIG_BOARD_EARLY_INIT_F      1       /* Call board_pre_init */
-
 #undef CONFIG_SYS_DRAM_TEST                    /* memory test, takes time */
 #define CONFIG_SYS_MEMTEST_START       0x00200000      /* memtest works on */
 #define CONFIG_SYS_MEMTEST_END         0x00400000
@@ -100,7 +94,6 @@
 #define CONFIG_SYS_CCSRBAR_PHYS_LOW    CONFIG_SYS_CCSRBAR
 
 /* DDR Setup */
-#define CONFIG_SYS_FSL_DDR2
 #undef CONFIG_FSL_DDR_INTERACTIVE
 #undef CONFIG_DDR_ECC                  /* only for ECC DDR module */
 /*
@@ -121,7 +114,6 @@
 #define CONFIG_SYS_SDRAM_BASE          CONFIG_SYS_DDR_SDRAM_BASE
 #define CONFIG_VERY_BIG_RAM
 
-#define CONFIG_NUM_DDR_CONTROLLERS     1
 #define CONFIG_DIMM_SLOTS_PER_CTLR     1
 #define CONFIG_CHIP_SELECTS_PER_CTRL   2
 
@@ -493,7 +485,6 @@
 /*
  * Environment
  */
-#define CONFIG_ENV_IS_IN_FLASH 1
 #define CONFIG_ENV_SIZE                0x2000
 #if CONFIG_SYS_TEXT_BASE == 0xfff00000 /* Boot from 64MB SODIMM */
 #define CONFIG_ENV_ADDR                (CONFIG_SYS_MONITOR_BASE + 0x80000)
@@ -577,8 +568,6 @@
 
 #undef CONFIG_BOOTARGS         /* the boot command will set bootargs*/
 
-#define CONFIG_BAUDRATE        115200
-
 #define        CONFIG_EXTRA_ENV_SETTINGS                               \
 "netdev=eth0\0"                                                \
 "uboot=" __stringify(CONFIG_UBOOTPATH) "\0"                            \