* (C) Copyright 2002
* Sysgo Real-Time Solutions, GmbH <www.elinos.com>
* Marius Groeger <mgroeger@sysgo.de>
- * Gary Jennejohn <gj@denx.de>
+ * Gary Jennejohn <garyj@denx.de>
* David Mueller <d.mueller@elsoft.ch>
*
* Modified for the friendly-arm SBC-2410X by
/*
* select serial console configuration
*/
+#define CONFIG_S3C24X0_SERIAL
#define CONFIG_SERIAL1 1 /* we use SERIAL 1 on SBC2410X */
/************************************************************
#define CONFIG_SYS_MEMTEST_START 0x30000000 /* memtest works on */
#define CONFIG_SYS_MEMTEST_END 0x33F00000 /* 63 MB in DRAM */
-#undef CONFIG_SYS_CLKS_IN_HZ /* everything, incl board info, in Hz */
-
#define CONFIG_SYS_LOAD_ADDR 0x33000000 /* default load address */
/* the PWM TImer 4 uses a counter of 15625 for 10 ms, so we need */
* NAND flash settings
*/
#if defined(CONFIG_CMD_NAND)
+#define CONFIG_NAND_S3C2410
#define CONFIG_SYS_MAX_NAND_DEVICE 1 /* Max number of NAND devices */
-#define SECTORSIZE 512
-
-#define ADDR_COLUMN 1
-#define ADDR_PAGE 2
-#define ADDR_COLUMN_PAGE 3
-
-#define NAND_ChipID_UNKNOWN 0x00
-#define NAND_MAX_FLOORS 1
-
-#define NAND_WAIT_READY(nand) NF_WaitRB()
-#define NAND_DISABLE_CE(nand) NF_SetCE(NFCE_HIGH)
-#define NAND_ENABLE_CE(nand) NF_SetCE(NFCE_LOW)
-#define WRITE_NAND_COMMAND(d, adr) NF_Cmd(d)
-#define WRITE_NAND_COMMANDW(d, adr) NF_CmdW(d)
-#define WRITE_NAND_ADDRESS(d, adr) NF_Addr(d)
-#define WRITE_NAND(d, adr) NF_Write(d)
-#define READ_NAND(adr) NF_Read()
-/* the following functions are NOP's because S3C24X0 handles this in hardware */
-#define NAND_CTL_CLRALE(nandptr)
-#define NAND_CTL_SETALE(nandptr)
-#define NAND_CTL_CLRCLE(nandptr)
-#define NAND_CTL_SETCLE(nandptr)
-/* #undef CONFIG_MTD_NAND_VERIFY_WRITE */
#endif /* CONFIG_CMD_NAND */
#define CONFIG_SETUP_MEMORY_TAGS