* so we MUST NOT initialize critical regs like mem-timing ...
*/
#undef CONFIG_SKIP_LOWLEVEL_INIT /* define for developing */
-#undef CONFIG_SKIP_RELOCATE_UBOOT /* define for developing */
+#define CONFIG_SYS_TEXT_BASE 0x0
/*
* define the following to enable debug blinks. A debug blink function
#undef CONFIG_USE_IRQ /* we don't need IRQ/FIQ stuff */
/* we will never enable dcache, because we have to setup MMU first */
-#define CONFIG_SYS_NO_DCACHE
+#define CONFIG_SYS_DCACHE_OFF
/*
* Size of malloc() pool
*/
#define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128*1024)
-#define CONFIG_SYS_GBL_DATA_SIZE 128 /* size in bytes reserved for initial data */
/*
* PXA250 IDP memory map information
/*
* Hardware drivers
*/
-#define CONFIG_DRIVER_SMC91111
+#define CONFIG_SMC91111
#define CONFIG_SMC91111_BASE (PXA_CS5_PHYS + IDP_CS5_ETH_OFFSET + 0x300)
#define CONFIG_SMC_USE_32_BIT 1
/* #define CONFIG_SMC_USE_IOFUNCS */
/*
* Physical Memory Map
*/
-#define CONFIG_NR_DRAM_BANKS 4 /* we have 1 banks of DRAM */
+#define CONFIG_NR_DRAM_BANKS 1 /* we have 1 bank of DRAM */
#define PHYS_SDRAM_1 0xa0000000 /* SDRAM Bank #1 */
#define PHYS_SDRAM_1_SIZE 0x04000000 /* 64 MB */
#define PHYS_SDRAM_2 0xa4000000 /* SDRAM Bank #2 */
#define CONFIG_SYS_FLASH_BASE PHYS_FLASH_1
+#define CONFIG_SYS_SDRAM_BASE PHYS_SDRAM_1
+#define CONFIG_SYS_INIT_SP_ADDR (GENERATED_GBL_DATA_SIZE + PHYS_SDRAM_1)
+
/*
* GPIO settings
*/
#define CONFIG_SYS_PSSR_VAL 0x20
+#define CONFIG_SYS_CCCR CCCR_L27|CCCR_M2|CCCR_N10
+#define CONFIG_SYS_CKEN 0x0
+
/*
* Memory settings
*/
#define CONFIG_SYS_MDCNFG_VAL 0x090009C9
#define CONFIG_SYS_MDREFR_VAL 0x0085C017
#define CONFIG_SYS_MDMRS_VAL 0x00220022
+#define CONFIG_SYS_FLYCNFG_VAL 0x00000000
+#define CONFIG_SYS_SXCNFG_VAL 0x00000000
/*
* PCMCIA and CF Interfaces