* so we MUST NOT initialize critical regs like mem-timing ...
*/
#undef CONFIG_SKIP_LOWLEVEL_INIT /* define for developing */
-#undef CONFIG_SKIP_RELOCATE_UBOOT /* define for developing */
#define CONFIG_SYS_TEXT_BASE 0x0
/*
#define CONFIG_MMC 1
#define CONFIG_DOS_PARTITION 1
-#define BOARD_LATE_INIT 1
+#define CONFIG_BOARD_LATE_INIT
#undef CONFIG_USE_IRQ /* we don't need IRQ/FIQ stuff */
/* we will never enable dcache, because we have to setup MMU first */
-#define CONFIG_SYS_NO_DCACHE
+#define CONFIG_SYS_DCACHE_OFF
/*
* Size of malloc() pool
*/
#define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128*1024)
-#define CONFIG_SYS_GBL_DATA_SIZE 128 /* size in bytes reserved for initial data */
/*
* PXA250 IDP memory map information
/*
* Hardware drivers
*/
-#define CONFIG_NET_MULTI
#define CONFIG_SMC91111
#define CONFIG_SMC91111_BASE (PXA_CS5_PHYS + IDP_CS5_ETH_OFFSET + 0x300)
#define CONFIG_SMC_USE_32_BIT 1
#define CONFIG_SYS_FLASH_BASE PHYS_FLASH_1
#define CONFIG_SYS_SDRAM_BASE PHYS_SDRAM_1
-#define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_GBL_DATA_SIZE + PHYS_SDRAM_1)
+#define CONFIG_SYS_INIT_SP_ADDR (GENERATED_GBL_DATA_SIZE + PHYS_SDRAM_1)
/*
* GPIO settings