/*
- * (C) Copyright 2006
+ * (C) Copyright 2006-2007
* Stefan Roese, DENX Software Engineering, sr@denx.de.
*
* Configuation settings for the PDNB3 board.
#define CONFIG_BAUDRATE 115200
#define CFG_IXP425_CONSOLE IXP425_UART1 /* we use UART1 for console */
-#define CONFIG_COMMANDS (CONFIG_CMD_DFL | \
- CFG_CMD_DHCP | \
- CFG_CMD_DATE | \
- CFG_CMD_NET | \
- CFG_CMD_MII | \
- CFG_CMD_NAND | \
- CFG_CMD_I2C | \
- CFG_CMD_ELF | \
- CFG_CMD_PING)
-/* This must be included AFTER the definition of CONFIG_COMMANDS (if any) */
-/* These are u-boot generic parameters */
-#include <cmd_confdefs.h>
+/*
+ * BOOTP options
+ */
+#define CONFIG_BOOTP_BOOTFILESIZE
+#define CONFIG_BOOTP_BOOTPATH
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_HOSTNAME
+
+
+/*
+ * Command line configuration.
+ */
+#include <config_cmd_default.h>
+
+#define CONFIG_CMD_DHCP
+#define CONFIG_CMD_DATE
+#define CONFIG_CMD_NET
+#define CONFIG_CMD_MII
+#define CONFIG_CMD_I2C
+#define CONFIG_CMD_ELF
+#define CONFIG_CMD_PING
+
+#if !defined(CONFIG_SCPU)
+#define CONFIG_CMD_NAND
+#endif
+
#define CONFIG_ZERO_BOOTDELAY_CHECK /* check for keypress on bootdelay==0 */
#define CONFIG_BOOTDELAY 5 /* autoboot after 5 seconds */
* Default configuration (environment varibles...)
*----------------------------------------------------------------------*/
#define CONFIG_PREBOOT "echo;" \
- "echo Type \"run flash_nfs\" to mount root filesystem over NFS;" \
+ "echo Type \\\"run flash_nfs\\\" to mount root filesystem over NFS;" \
"echo"
#undef CONFIG_BOOTARGS
"update=protect off 50000000 5007dfff;era 50000000 5007dfff;" \
"cp.b 100000 50000000 ${filesize};" \
"setenv filesize;saveenv\0" \
- "upd=run load;run update\0" \
+ "upd=run load update\0" \
"ipaddr=10.0.0.233\0" \
"serverip=10.0.0.152\0" \
- "netmask=255.255.0.0\0" \
+ "netmask=255.255.0.0\0" \
"ethaddr=c6:6f:13:36:f3:81\0" \
"eth1addr=c6:6f:13:36:f3:82\0" \
"mtdparts=IXP4XX-Flash.0:504k@0(uboot),4k@504k(env)," \
#define CFG_FLASH_BASE 0x50000000
#define CFG_MONITOR_BASE CFG_FLASH_BASE
+#if defined(CONFIG_SCPU)
+#define CFG_MONITOR_LEN (384 << 10) /* Reserve 512 kB for Monitor */
+#else
#define CFG_MONITOR_LEN (504 << 10) /* Reserve 512 kB for Monitor */
+#endif
/*
* Expansion bus settings
*/
+#if defined(CONFIG_SCPU)
+#define CFG_EXP_CS0 0x94d23C42 /* 8bit, max size */
+#else
#define CFG_EXP_CS0 0x94913C43 /* 8bit, max size */
+#endif
#define CFG_EXP_CS1 0x85000043 /* 8bit, 512bytes */
/*
*/
#define CFG_SDR_CONFIG 0x18
#define CFG_SDR_MODE_CONFIG 0x1
-#define CFG_SDRAM_REFRESH_CNT 0x81a
+#define CFG_SDRAM_REFRESH_CNT 0x81a
/*
* FLASH and environment organization
*/
+#if defined(CONFIG_SCPU)
+#define CFG_FLASH_CFI /* The flash is CFI compatible */
+#define CFG_FLASH_CFI_DRIVER /* Use common CFI driver */
+#define CFG_FLASH_CFI_WIDTH FLASH_CFI_16BIT /* no byte writes on IXP4xx */
+#endif
+
#define FLASH_BASE0_PRELIM CFG_FLASH_BASE /* FLASH bank #0 */
#define CFG_MAX_FLASH_BANKS 1 /* max number of memory banks */
#define CFG_ENV_IS_IN_FLASH 1
-#define CFG_ENV_SECT_SIZE 0x1000 /* size of one complete sector */
#define CFG_ENV_ADDR (CFG_FLASH_BASE + CFG_MONITOR_LEN)
+#if defined(CONFIG_SCPU)
+/* no redundant environment on SCPU */
+#define CFG_ENV_SECT_SIZE 0x20000 /* size of one complete sector */
+#define CFG_ENV_SIZE 0x4000 /* Total Size of Environment Sector */
+#else
+#define CFG_ENV_SECT_SIZE 0x1000 /* size of one complete sector */
#define CFG_ENV_SIZE 0x1000 /* Total Size of Environment Sector */
/* Address and size of Redundant Environment Sector */
#define CFG_ENV_ADDR_REDUND (CFG_ENV_ADDR + CFG_ENV_SECT_SIZE)
#define CFG_ENV_SIZE_REDUND (CFG_ENV_SIZE)
+#endif
+#if !defined(CONFIG_SCPU)
/*
* NAND-FLASH stuff
*/
#define CFG_MAX_NAND_DEVICE 1
#define NAND_MAX_CHIPS 1
#define CFG_NAND_BASE 0x51000000 /* NAND FLASH Base Address */
+#endif
/*
* GPIO settings
/*
* I2C RTC
*/
+#if 0 /* test-only */
+#define CONFIG_RTC_DS1340 1
+#define CFG_I2C_RTC_ADDR 0x68
+#else
+/* M41T11 Serial Access Timekeeper(R) SRAM */
#define CONFIG_RTC_M41T11 1
#define CFG_I2C_RTC_ADDR 0x68
#define CFG_M41T11_BASE_YEAR 1900 /* play along with the linux driver */
+#endif
/*
* Spartan3 FPGA configuration support