#define CONFIG_SYS_PDM360NG_COPROC_BAUDRATE 38400
/*
- * I2C
- */
-#define CONFIG_HARD_I2C /* I2C with hardware support */
-#define CONFIG_I2C_MULTI_BUS
-#define CONFIG_I2C_CMD_TREE
-/* I2C speed and slave address */
-#define CONFIG_SYS_I2C_SPEED 100000
-#define CONFIG_SYS_I2C_SLAVE 0x7F
-
-/*
* IIM - IC Identification Module
*/
#undef CONFIG_FSL_IIM
/*
- * EEPROM configuration
- */
-#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 2 /* 16-bit EEPROM addr */
-#define CONFIG_SYS_I2C_EEPROM_ADDR 0x50 /* ST AT24C01 */
-#define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 10 /* 10ms of delay */
-#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 4 /* 16-Byte Write Mode */
-
-/*
- * MAC addr in EEPROM
- */
-#define CONFIG_SYS_I2C_EEPROM_BUS_NUM 0
-#define CONFIG_SYS_I2C_EEPROM_MAC_OFFSET 0x10
-/*
* Enabled only to delete "ethaddr" before testing
* "ethaddr" setting from EEPROM
*/
#define CONFIG_HAS_ETH0
/*
- * Configure on-board RTC
- */
-#define CONFIG_RTC_M41T62 /* use M41T00 rtc via i2c */
-#define CONFIG_SYS_I2C_RTC_ADDR 0x68 /* at address 0x68 */
-
-/*
* Environment
*/
#define CONFIG_ENV_IS_IN_FLASH 1
#define CONFIG_LOADS_ECHO 1 /* echo on for serial download */
#define CONFIG_SYS_LOADS_BAUD_CHANGE 1 /* allow baudrate change */
-#define CONFIG_CMD_DATE
-#define CONFIG_CMD_EEPROM
#define CONFIG_CMD_REGINFO
-#undef CONFIG_CMD_FUSE
-
-#ifdef CONFIG_VIDEO
-#define CONFIG_CMD_BMP
-#endif
-
/*
* Miscellaneous configurable options
*/