sh7763rdp: change config for new sh_eth driver

[platform/kernel/u-boot.git] / include / configs / p3mx.h

diff --git a/include/configs/p3mx.h b/include/configs/p3mx.h
index 17ec08f..e44009e 100644 (file)
--- a/include/configs/p3mx.h
+++ b/include/configs/p3mx.h
@@ -40,6 +40,8 @@
  *----------------------------------------------------------------------*/
 #define CONFIG_P3Mx                    /* used for both board versions */
 
+#define        CONFIG_SYS_TEXT_BASE    0xfff00000
+
 #if defined (CONFIG_P3M750)
 #define CONFIG_750FX                   /* 750GL/GX/FX                  */
 #define CONFIG_HIGH_BATS               /* High BATs supported          */
@@ -96,9 +98,8 @@
 */
 #undef CONFIG_SYS_INIT_RAM_LOCK
 #define CONFIG_SYS_INIT_RAM_ADDR       0x42000000
-#define CONFIG_SYS_INIT_RAM_END        0x1000
-#define CONFIG_SYS_GBL_DATA_SIZE       128  /* size in bytes reserved for init data */
-#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_END - CONFIG_SYS_GBL_DATA_SIZE)
+#define CONFIG_SYS_INIT_RAM_SIZE       0x1000
+#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 
 
 /*-----------------------------------------------------------------------
@@ -116,7 +117,6 @@
  *----------------------------------------------------------------------*/
 /* Change the default ethernet port, use this define (options: 0, 1, 2) */
 #define CONFIG_SYS_ETH_PORT            ETH_0
-#define CONFIG_NET_MULTI
 #define MV_ETH_DEVS            2
 #define CONFIG_PHY_RESET        1      /* reset phy upon startup         */
 #define CONFIG_PHY_GIGE                1       /* Include GbE speed/duplex detection */
@@ -447,12 +447,8 @@
 
 #define L2_ENABLE      (L2_INIT | L2CR_L2E)
 
-/*
- * Internal Definitions
- *
- * Boot Flags
- */
-#define BOOTFLAG_COLD  0x01            /* Normal Power-On: Boot from FLASH */
-#define BOOTFLAG_WARM  0x02            /* Software reboot                  */
+#ifndef __ASSEMBLY__
+#include <../board/Marvell/include/core.h>
+#endif
 
 #endif /* __CONFIG_H */