#define __SW_BOOT_SD 0x9c
#define __SW_BOOT_NAND 0xec
#define __SW_BOOT_PCIE 0x6c
+#define __SW_NOR_BANK_MASK 0xfd
+#define __SW_NOR_BANK_UP 0x00
+#define __SW_NOR_BANK_LO 0x02
#define CONFIG_SYS_L2_SIZE (256 << 10)
#endif
#define __SW_BOOT_SD 0x24
#define __SW_BOOT_NAND 0x44
#define __SW_BOOT_PCIE 0x74
+#define __SW_NOR_BANK_MASK 0xfd
+#define __SW_NOR_BANK_UP 0x00
+#define __SW_NOR_BANK_LO 0x02
#define CONFIG_SYS_L2_SIZE (256 << 10)
/*
* Dynamic MTD Partition support with mtdparts
#define __SW_BOOT_MASK 0x03
#define __SW_BOOT_NOR 0xc8
#define __SW_BOOT_SPI 0x28
-#define __SW_BOOT_SD 0x68 /* or 0x18 */
+#define __SW_BOOT_SD 0x68
+#define __SW_BOOT_SD2 0x18
#define __SW_BOOT_NAND 0xe8
#define __SW_BOOT_PCIE 0xa8
+#define __SW_NOR_BANK_MASK 0xfd
+#define __SW_NOR_BANK_UP 0x00
+#define __SW_NOR_BANK_LO 0x02
#define CONFIG_SYS_L2_SIZE (512 << 10)
/*
* Dynamic MTD Partition support with mtdparts
#endif
#ifdef CONFIG_SDCARD
-#define CONFIG_SPL_FLUSH_IMAGE
#define CONFIG_SPL_TARGET "u-boot-with-spl.bin"
-#define CONFIG_SPL_PAD_TO 0x20000
-#define CONFIG_SPL_MAX_SIZE (128 * 1024)
#define CONFIG_SYS_MMC_U_BOOT_SIZE (768 << 10)
#define CONFIG_SYS_MMC_U_BOOT_DST (0x11000000)
#define CONFIG_SYS_MMC_U_BOOT_START (0x11000000)
#endif
#elif defined(CONFIG_SPIFLASH)
#define CONFIG_SPL_SPI_FLASH_MINIMAL
-#define CONFIG_SPL_FLUSH_IMAGE
#define CONFIG_SPL_TARGET "u-boot-with-spl.bin"
-#define CONFIG_SPL_PAD_TO 0x20000
-#define CONFIG_SPL_MAX_SIZE (128 * 1024)
#define CONFIG_SYS_SPI_FLASH_U_BOOT_SIZE (768 << 10)
#define CONFIG_SYS_SPI_FLASH_U_BOOT_DST (0x11000000)
#define CONFIG_SYS_SPI_FLASH_U_BOOT_START (0x11000000)
#endif
#elif defined(CONFIG_MTD_RAW_NAND)
#ifdef CONFIG_TPL_BUILD
-#define CONFIG_SPL_FLUSH_IMAGE
#define CONFIG_SPL_NAND_INIT
#define CONFIG_SPL_COMMON_INIT_DDR
-#define CONFIG_SPL_MAX_SIZE (128 << 10)
#define CONFIG_SYS_MPC85XX_NO_RESETVEC
#define CONFIG_SYS_NAND_U_BOOT_SIZE (832 << 10)
#define CONFIG_SYS_NAND_U_BOOT_DST (0x11000000)
#define CONFIG_SYS_NAND_U_BOOT_START (0x11000000)
#elif defined(CONFIG_SPL_BUILD)
-#define CONFIG_SPL_INIT_MINIMAL
-#define CONFIG_SPL_FLUSH_IMAGE
#define CONFIG_SPL_TARGET "u-boot-with-spl.bin"
-#define CONFIG_SPL_MAX_SIZE 4096
#define CONFIG_SYS_NAND_U_BOOT_SIZE (128 << 10)
#define CONFIG_SYS_NAND_U_BOOT_DST 0xf8f80000
#define CONFIG_SYS_NAND_U_BOOT_START 0xf8f80000
+#else
+#ifndef CONFIG_MPC85XX_HAVE_RESET_VECTOR
+#define CONFIG_SYS_MPC85XX_NO_RESETVEC
+#endif
#endif /* not CONFIG_TPL_BUILD */
-#define CONFIG_SPL_PAD_TO 0x20000
-#define CONFIG_TPL_PAD_TO 0x20000
#define CONFIG_SPL_TARGET "u-boot-with-spl.bin"
#endif
/* Vsc7385 switch */
#ifdef CONFIG_VSC7385_ENET
-#define __VSCFW_ADDR "vscfw_addr=ef000000"
+#define __VSCFW_ADDR "vscfw_addr=ef000000\0"
#define CONFIG_SYS_VSC7385_BASE 0xffb00000
#ifdef CONFIG_PHYS_64BIT
#define CONFIG_VSC7385_IMAGE_SIZE 8192
#endif
+#ifndef __VSCFW_ADDR
+#define __VSCFW_ADDR ""
+#endif
+
/*
* Config the L2 Cache as L2 SRAM
*/
#define CONFIG_SYS_NS16550_SERIAL
#define CONFIG_SYS_NS16550_REG_SIZE 1
#define CONFIG_SYS_NS16550_CLK get_bus_freq(0)
-#if defined(CONFIG_SPL_BUILD) && defined(CONFIG_SPL_INIT_MINIMAL)
+#if defined(CONFIG_SPL_BUILD) && CONFIG_IS_ENABLED(INIT_MINIMAL)
#define CONFIG_NS16550_MIN_FUNCTIONS
#endif
#ifdef __SW_BOOT_NOR
#define __NOR_RST_CMD \
-norboot=i2c dev 1; i2c mw 18 1 __SW_BOOT_NOR 1; \
-i2c mw 18 3 __SW_BOOT_MASK 1; reset
+norboot=i2c dev CONFIG_SYS_SPD_BUS_NUM; i2c mw CONFIG_SYS_I2C_PCA9557_ADDR 1 __SW_BOOT_NOR 1; \
+i2c mw CONFIG_SYS_I2C_PCA9557_ADDR 3 __SW_BOOT_MASK 1; reset
#endif
#ifdef __SW_BOOT_SPI
#define __SPI_RST_CMD \
-spiboot=i2c dev 1; i2c mw 18 1 __SW_BOOT_SPI 1; \
-i2c mw 18 3 __SW_BOOT_MASK 1; reset
+spiboot=i2c dev CONFIG_SYS_SPD_BUS_NUM; i2c mw CONFIG_SYS_I2C_PCA9557_ADDR 1 __SW_BOOT_SPI 1; \
+i2c mw CONFIG_SYS_I2C_PCA9557_ADDR 3 __SW_BOOT_MASK 1; reset
#endif
#ifdef __SW_BOOT_SD
#define __SD_RST_CMD \
-sdboot=i2c dev 1; i2c mw 18 1 __SW_BOOT_SD 1; \
-i2c mw 18 3 __SW_BOOT_MASK 1; reset
+sdboot=i2c dev CONFIG_SYS_SPD_BUS_NUM; i2c mw CONFIG_SYS_I2C_PCA9557_ADDR 1 __SW_BOOT_SD 1; \
+i2c mw CONFIG_SYS_I2C_PCA9557_ADDR 3 __SW_BOOT_MASK 1; reset
#endif
#ifdef __SW_BOOT_NAND
#define __NAND_RST_CMD \
-nandboot=i2c dev 1; i2c mw 18 1 __SW_BOOT_NAND 1; \
-i2c mw 18 3 __SW_BOOT_MASK 1; reset
+nandboot=i2c dev CONFIG_SYS_SPD_BUS_NUM; i2c mw CONFIG_SYS_I2C_PCA9557_ADDR 1 __SW_BOOT_NAND 1; \
+i2c mw CONFIG_SYS_I2C_PCA9557_ADDR 3 __SW_BOOT_MASK 1; reset
#endif
#ifdef __SW_BOOT_PCIE
#define __PCIE_RST_CMD \
-pciboot=i2c dev 1; i2c mw 18 1 __SW_BOOT_PCIE 1; \
-i2c mw 18 3 __SW_BOOT_MASK 1; reset
+pciboot=i2c dev CONFIG_SYS_SPD_BUS_NUM; i2c mw CONFIG_SYS_I2C_PCA9557_ADDR 1 __SW_BOOT_PCIE 1; \
+i2c mw CONFIG_SYS_I2C_PCA9557_ADDR 3 __SW_BOOT_MASK 1; reset
#endif
#define CONFIG_EXTRA_ENV_SETTINGS \
"nandbootaddr=100000\0" \
"nandfdtaddr=80000\0" \
"ramdisk_size=120000\0" \
-"map_lowernorbank=i2c dev 1; i2c mw 18 1 02 1; i2c mw 18 3 fd 1\0" \
-"map_uppernorbank=i2c dev 1; i2c mw 18 1 00 1; i2c mw 18 3 fd 1\0" \
-__stringify(__VSCFW_ADDR)"\0" \
+__VSCFW_ADDR \
+"map_lowernorbank=i2c dev "__stringify(CONFIG_SYS_SPD_BUS_NUM)"; i2c mw "__stringify(CONFIG_SYS_I2C_PCA9557_ADDR)" 1 "__stringify(__SW_NOR_BANK_LO)" 1; i2c mw "__stringify(CONFIG_SYS_I2C_PCA9557_ADDR)" 3 "__stringify(__SW_NOR_BANK_MASK)" 1\0" \
+"map_uppernorbank=i2c dev "__stringify(CONFIG_SYS_SPD_BUS_NUM)"; i2c mw "__stringify(CONFIG_SYS_I2C_PCA9557_ADDR)" 1 "__stringify(__SW_NOR_BANK_UP)" 1; i2c mw "__stringify(CONFIG_SYS_I2C_PCA9557_ADDR)" 3 "__stringify(__SW_NOR_BANK_MASK)" 1\0" \
__stringify(__NOR_RST_CMD)"\0" \
__stringify(__SPI_RST_CMD)"\0" \
__stringify(__SD_RST_CMD)"\0" \
projects / platform / kernel / u-boot.git / blobdiff