#define CONFIG_SYS_DA850_PLL1_PLLDIV2 0x8001
#define CONFIG_SYS_DA850_PLL1_PLLDIV3 0x8003
-#define CONFIG_SYS_DA850_PLL0_PLLM 24
+#define CONFIG_SYS_DA850_PLL0_PLLM 37
#define CONFIG_SYS_DA850_PLL1_PLLM 21
/*
+ * DDR2 memory configuration
+ */
+#define CONFIG_SYS_DA850_DDR2_DDRPHYCR (DV_DDR_PHY_PWRDNEN | \
+ DV_DDR_PHY_EXT_STRBEN | \
+ (0x5 << DV_DDR_PHY_RD_LATENCY_SHIFT))
+
+#define CONFIG_SYS_DA850_DDR2_SDBCR ( \
+ (1 << DV_DDR_SDCR_DDR2EN_SHIFT) | \
+ (1 << DV_DDR_SDCR_DDREN_SHIFT) | \
+ (1 << DV_DDR_SDCR_SDRAMEN_SHIFT) | \
+ (1 << DV_DDR_SDCR_BUS_WIDTH_SHIFT) | \
+ (4 << DV_DDR_SDCR_CL_SHIFT) | \
+ (3 << DV_DDR_SDCR_IBANK_SHIFT) | \
+ (2 << DV_DDR_SDCR_PAGESIZE_SHIFT))
+
+/* SDBCR2 is only used if IBANK_POS bit in SDBCR is set */
+#define CONFIG_SYS_DA850_DDR2_SDBCR2 0
+
+#define CONFIG_SYS_DA850_DDR2_SDTIMR ( \
+ (19 << DV_DDR_SDTMR1_RFC_SHIFT) | \
+ (1 << DV_DDR_SDTMR1_RP_SHIFT) | \
+ (1 << DV_DDR_SDTMR1_RCD_SHIFT) | \
+ (2 << DV_DDR_SDTMR1_WR_SHIFT) | \
+ (6 << DV_DDR_SDTMR1_RAS_SHIFT) | \
+ (8 << DV_DDR_SDTMR1_RC_SHIFT) | \
+ (1 << DV_DDR_SDTMR1_RRD_SHIFT) | \
+ (1 << DV_DDR_SDTMR1_WTR_SHIFT))
+
+#define CONFIG_SYS_DA850_DDR2_SDTIMR2 ( \
+ (7 << DV_DDR_SDTMR2_RASMAX_SHIFT) | \
+ (2 << DV_DDR_SDTMR2_XP_SHIFT) | \
+ (0 << DV_DDR_SDTMR2_ODT_SHIFT) | \
+ (10 << DV_DDR_SDTMR2_XSNR_SHIFT) | \
+ (199 << DV_DDR_SDTMR2_XSRD_SHIFT) | \
+ (1 << DV_DDR_SDTMR2_RTP_SHIFT) | \
+ (2 << DV_DDR_SDTMR2_CKE_SHIFT))
+
+#define CONFIG_SYS_DA850_DDR2_SDRCR 0x00000492
+#define CONFIG_SYS_DA850_DDR2_PBBPR 0x30
+
+/*
* Serial Driver info
*/
#define CONFIG_SYS_NS16550_SERIAL
#define CONFIG_SYS_NAND_USE_FLASH_BBT
#define CONFIG_SYS_NAND_4BIT_HW_ECC_OOBFIRST
#define CONFIG_SYS_NAND_PAGE_2K
-#define CONFIG_SYS_NAND_BUSWIDTH_16_BIT
+#define CONFIG_SYS_NAND_BUSWIDTH_16BIT
#define CONFIG_SYS_NAND_CS 3
#define CONFIG_SYS_NAND_BASE DAVINCI_ASYNC_EMIF_DATA_CE3_BASE
-#define CONFIG_SYS_CLE_MASK 0x10
-#define CONFIG_SYS_ALE_MASK 0x8
+#define CONFIG_SYS_NAND_MASK_CLE 0x10
+#define CONFIG_SYS_NAND_MASK_ALE 0x8
#undef CONFIG_SYS_NAND_HW_ECC
#define CONFIG_SYS_MAX_NAND_DEVICE 1 /* Max number of NAND devices */
-#define NAND_MAX_CHIPS 1
+#define CONFIG_SYS_NAND_HW_ECC_OOBFIRST
+#define CONFIG_SYS_NAND_5_ADDR_CYCLE
+#define CONFIG_SYS_NAND_PAGE_SIZE (2 << 10)
+#define CONFIG_SYS_NAND_BLOCK_SIZE (128 << 10)
+#define CONFIG_SYS_NAND_U_BOOT_SIZE 0x200 /*0x60000*/
+#define CONFIG_SYS_NAND_U_BOOT_DST 0xc1080000
+#define CONFIG_SYS_NAND_U_BOOT_START CONFIG_SYS_NAND_U_BOOT_DST
+#define CONFIG_SYS_NAND_U_BOOT_RELOC_SP (CONFIG_SYS_NAND_U_BOOT_DST - \
+ CONFIG_SYS_NAND_U_BOOT_SIZE - \
+ CONFIG_SYS_MALLOC_LEN - \
+ GENERATED_GBL_DATA_SIZE)
+#define CONFIG_SYS_NAND_ECCPOS { \
+ 24, 25, 26, 27, 28, \
+ 29, 30, 31, 32, 33, 34, 35, 36, 37, 38, \
+ 39, 40, 41, 42, 43, 44, 45, 46, 47, 48, \
+ 49, 50, 51, 52, 53, 54, 55, 56, 57, 58, \
+ 59, 60, 61, 62, 63 }
+#define CONFIG_SYS_NAND_PAGE_COUNT 64
+#define CONFIG_SYS_NAND_BAD_BLOCK_POS 0
+#define CONFIG_SYS_NAND_ECCSIZE 512
+#define CONFIG_SYS_NAND_ECCBYTES 10
+#define CONFIG_SYS_NAND_OOBSIZE 64
+#define CONFIG_SPL_NAND_BASE
+#define CONFIG_SPL_NAND_DRIVERS
+#define CONFIG_SPL_NAND_ECC
+#define CONFIG_SPL_NAND_SIMPLE
+#define CONFIG_SPL_NAND_LOAD
#endif
#ifdef CONFIG_SYS_USE_NOR
#define CONFIG_REVISION_TAG
#define CONFIG_SETUP_MEMORY_TAGS
#define CONFIG_BOOTARGS "console=ttyS2,115200n8 root=/dev/mmcblk0p2 rw rootwait ip=off"
-#define CONFIG_BOOTCOMMAND "if mmc rescan; then if fatload mmc 0 0xc0600000 boot.scr; then source 0xc0600000; else fatload mmc 0 0xc0700000 uImage; bootm c0700000; fi; else sf probe 0; sf read 0xc0700000 0x80000 0x220000; bootm 0xc0700000; fi"
+#define CONFIG_BOOTCOMMAND \
+ "if mmc rescan; then " \
+ "run mmcboot; " \
+ "else " \
+ "run spiboot; " \
+ "fi"
+#define CONFIG_EXTRA_ENV_SETTINGS \
+ "fdtaddr=0xc0600000\0" \
+ "fdtfile=da850-lcdk.dtb\0" \
+ "fdtboot=bootm 0xc0700000 - ${fdtaddr};\0" \
+ "mmcboot=" \
+ "if fatload mmc 0 0xc0600000 boot.scr; then " \
+ "source 0xc0600000; " \
+ "else " \
+ "fatload mmc 0 0xc0700000 uImage; " \
+ "fatload mmc 0 ${fdtaddr} ${fdtfile}; " \
+ "run fdtboot; " \
+ "fi;\0" \
+ "spiboot=" \
+ "sf probe 0; " \
+ "sf read 0xc0700000 0x80000 0x220000; " \
+ "bootm 0xc0700000;\0"
/*
* U-Boot commands
#define CONFIG_MTD_PARTITIONS
#define CONFIG_LZO
#define CONFIG_RBTREE
-#define CONFIG_CMD_UBI
#define CONFIG_CMD_UBIFS
#endif