#define CONFIG_DRIVER_OMAP34XX_I2C 1
/*
+ * TWL4030
+ */
+#define CONFIG_TWL4030_POWER 1
+#define CONFIG_TWL4030_LED 1
+
+/*
* Board NAND Info.
*/
#define CONFIG_NAND_OMAP_GPMC
#define CONFIG_SYS_MAX_NAND_DEVICE 1 /* Max number of NAND */
/* devices */
-#define SECTORSIZE 512
-#define NAND_ALLOW_ERASE_ALL
-#define ADDR_COLUMN 1
-#define ADDR_PAGE 2
-#define ADDR_COLUMN_PAGE 3
-
-#define NAND_ChipID_UNKNOWN 0x00
-#define NAND_MAX_FLOORS 1
-#define NAND_MAX_CHIPS 1
-#define NAND_NO_RB 1
-#define CONFIG_SYS_NAND_WP
+#define CONFIG_SYS_64BIT_VSPRINTF /* needed for nand_util.c */
#define CONFIG_JFFS2_NAND
/* nand device jffs2 lives on */
/* address */
/*
- * 2430 has 12 GP timers, they can be driven by the SysClk (12/13/19.2) or by
- * 32KHz clk, or from external sig. This rate is divided by a local divisor.
+ * OMAP3 has 12 GP timers, they can be driven by the system clock
+ * (12/13/16.8/19.2/38.4MHz) or by 32KHz clock. We use 13MHz (V_SCLK).
+ * This rate is divided by a local divisor.
*/
-#define CONFIG_SYS_TIMERBASE (OMAP34XX_GPT2)
-#define CONFIG_SYS_PTV 7 /* 2^(PTV+1) */
-#define CONFIG_SYS_HZ ((V_SCLK) / (2 << CONFIG_SYS_PTV))
+#define CONFIG_SYS_TIMERBASE OMAP34XX_GPT2
+#define CONFIG_SYS_PTV 2 /* Divisor: 2^(PTV+1) => 8 */
+#define CONFIG_SYS_HZ 1000
/*-----------------------------------------------------------------------
* Stack sizes
extern unsigned int boot_flash_type;
#endif
-
-#define WRITE_NAND_COMMAND(d, adr)\
- writel(d, &nand_cs_base->nand_cmd)
-#define WRITE_NAND_ADDRESS(d, adr)\
- writel(d, &nand_cs_base->nand_adr)
-#define WRITE_NAND(d, adr) writew(d, &nand_cs_base->nand_dat)
-#define READ_NAND(adr) readl(&nand_cs_base->nand_dat)
-
-/* Other NAND Access APIs */
-#define NAND_WP_OFF() do {readl(&gpmc_cfg_base->config) |= GPMC_CONFIG_WP; } \
- while (0)
-#define NAND_WP_ON() do {readl(&gpmc_cfg_base->config) &= ~GPMC_CONFIG_WP; } \
- while (0)
-#define NAND_DISABLE_CE(nand)
-#define NAND_ENABLE_CE(nand)
-#define NAND_WAIT_READY(nand) udelay(10)
-
#endif /* __CONFIG_H */