#ifndef __OMAP3_CAIRO_CONFIG_H
#define __OMAP3_CAIRO_CONFIG_H
-#define CONFIG_NR_DRAM_BANKS 2 /* CS1 may or may not be populated */
-
/*
* 1MB into the SDRAM to allow for SPL's bss at the beginning of SDRAM
* 64 bytes before this address should be set aside for u-boot.img's
#include <configs/ti_omap3_common.h>
-#define CONFIG_MISC_INIT_R
-
#define CONFIG_REVISION_TAG 1
#define CONFIG_ENV_OVERWRITE
/*
* TWL4030
*/
-#define CONFIG_TWL4030_LED 1
/*
* Board NAND Info.
#define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_FLASH_BASE
#define CONFIG_SYS_ONENAND_BASE ONENAND_MAP
-#define CONFIG_ENV_SIZE (128 << 10) /* 128 KiB */
-#define ONENAND_ENV_OFFSET 0x260000 /* environment starts here */
-
#define CONFIG_SYS_ENV_SECT_SIZE (128 << 10) /* 128 KiB */
-#define CONFIG_ENV_OFFSET 0x260000
#define CONFIG_ENV_ADDR 0x260000
/* Defines for SPL */
/* env defaults */
#define CONFIG_BOOTFILE "uImage"
-/* Override OMAP3 common serial console configuration from UART3
- * to UART2.
- *
- * Attention: for UART2, special MUX settings (MUX_DEFAULT(), MCBSP3)
- * are needed and peripheral clocks for UART2 must be enabled in
- * function per_clocks_enable().
- */
-#ifdef CONFIG_SPL_BUILD
-#undef CONFIG_SERIAL3
-#define CONFIG_SERIAL2
-#endif
-
/* Provide the MACH_TYPE value the vendor kernel requires */
#define CONFIG_MACH_TYPE 3063