*/
#define CONFIG_PCI 1
#define CONFIG_PCI_PNP 1
-#define CONFIG_PCI_SCAN_SHOW 1
+/* #define CONFIG_PCI_SCAN_SHOW 1 */
#define CONFIG_PCI_MEM_BUS 0x40000000
#define CONFIG_PCI_MEM_PHYS CONFIG_PCI_MEM_BUS
#define CFG_XLB_PIPELINING 1
#define CONFIG_NET_MULTI 1
-#define CONFIG_EEPRO100 1
+#define CONFIG_EEPRO100
#define CFG_RX_ETH_BUFFER 8 /* use 8 rx buffer on eepro100 */
#define CONFIG_NS8382X 1
CFG_CMD_FAT | \
CFG_CMD_I2C | \
CFG_CMD_NFS | \
- CFG_CMD_SNTP | \
CFG_CMD_MII | \
CFG_CMD_PING | \
ADD_PCI_CMD )
#define CONFIG_EXTRA_ENV_SETTINGS \
"netdev=eth0\0" \
"nfsargs=setenv bootargs root=/dev/nfs rw " \
- "nfsroot=$(serverip):$(rootpath)\0" \
+ "nfsroot=${serverip}:${rootpath}\0" \
"ramargs=setenv bootargs root=/dev/ram rw\0" \
- "addip=setenv bootargs $(bootargs) " \
- "ip=$(ipaddr):$(serverip):$(gatewayip):$(netmask)" \
- ":$(hostname):$(netdev):off panic=1\0" \
+ "addip=setenv bootargs ${bootargs} " \
+ "ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}" \
+ ":${hostname}:${netdev}:off panic=1\0" \
"flash_nfs=run nfsargs addip;" \
- "bootm $(kernel_addr)\0" \
+ "bootm ${kernel_addr}\0" \
"flash_self=run ramargs addip;" \
- "bootm $(kernel_addr) $(ramdisk_addr)\0" \
- "net_nfs=tftp 200000 $(bootfile);run nfsargs addip;bootm\0" \
+ "bootm ${kernel_addr} ${ramdisk_addr}\0" \
+ "net_nfs=tftp 200000 ${bootfile};run nfsargs addip;bootm\0" \
"rootpath=/opt/eldk/ppc_82xx\0" \
"bootfile=/tftpboot/MPC5200/uImage\0" \
""
/*
* IPB Bus clocking configuration.
*/
-#undef CFG_IPBSPEED_133 /* define for 133MHz speed */
+#define CFG_IPBSPEED_133 /* define for 133MHz speed */
+
+#if defined(CFG_IPBSPEED_133)
+/*
+ * PCI Bus clocking configuration
+ *
+ * Actually a PCI Clock of 66 MHz is only set (in cpu_init.c) if
+ * CFG_IPBSPEED_133 is defined. This is because a PCI Clock of 66 MHz yet hasn't
+ * been tested with a IPB Bus Clock of 66 MHz.
+ */
+#define CFG_PCISPEED_66 /* define for 66MHz speed */
+#endif
#endif
+
/*
* I2C configuration
*/
/*
* GPIO configuration
*/
-//#define CFG_GPS_PORT_CONFIG 0x10002004
-#define CFG_GPS_PORT_CONFIG 0x00002004 //no CAN
+/*#define CFG_GPS_PORT_CONFIG 0x10002004 */
+#define CFG_GPS_PORT_CONFIG 0x00002006 /* no CAN */
/*
* Miscellaneous configurable options
#define CFG_BOOTCS_START CFG_FLASH_BASE
#define CFG_BOOTCS_SIZE CFG_FLASH_SIZE
-#define CFG_BOOTCS_CFG 0x00047801
+
+#ifdef CFG_PCISPEED_66
+/*
+ * For 66 MHz PCI clock additional Wait State is needed for CS0 (flash).
+ */
+#define CFG_BOOTCS_CFG 0x00057801 /* for pci_clk = 66 MHz */
+#else
+#define CFG_BOOTCS_CFG 0x00047801 /* for pci_clk = 33 MHz */
+#endif
+
#define CFG_CS0_START CFG_FLASH_BASE
#define CFG_CS0_SIZE CFG_FLASH_SIZE