* Serial console configuration
*/
#define CONFIG_PSC_CONSOLE 5 /* console is on PSC5 */
-#define CONFIG_BAUDRATE 115200 /* ... at 115200 bps */
#define CONFIG_SYS_BAUDRATE_TABLE \
{ 9600, 19200, 38400, 57600, 115200, 230400 }
* 0x40000000 - 0x4fffffff - PCI Memory
* 0x50000000 - 0x50ffffff - PCI IO Space
*/
-#undef CONFIG_PCI
-#define CONFIG_PCI_PNP 1
#define CONFIG_PCI_MEM_BUS 0x40000000
#define CONFIG_PCI_MEM_PHYS CONFIG_PCI_MEM_BUS
#define CONFIG_SYS_XLB_PIPELINING 1
/* Partitions */
-#define CONFIG_MAC_PARTITION
-#define CONFIG_DOS_PARTITION
-#define CONFIG_ISO_PARTITION
#define CONFIG_TIMESTAMP /* Print image info with timestamp */
/*
* Supported commands
*/
-#define CONFIG_CMD_EEPROM
#ifdef CONFIG_PCI
#define CONFIG_CMD_PCI
#endif
-#ifdef CONFIG_POST
-#define CONFIG_CMD_DIAG
-#endif
#if (CONFIG_SYS_TEXT_BASE == 0xFC000000) || (CONFIG_SYS_TEXT_BASE == 0xFF000000)
/* Boot low with 16 or 32 MB Flash */
#undef CONFIG_BOOTARGS
-#if !defined(CONFIG_CONSOLE_DEV)
-#define CONFIG_CONSOLE_DEV "ttyPSC1"
+#if !defined(CONSOLE_DEV)
+#define CONSOLE_DEV "ttyPSC1"
#endif
/*
"addmem=setenv bootargs ${bootargs} ${memlimit}\0" \
"addmisc=sete bootargs ${bootargs} ${miscargs}\0" \
"addtty=sete bootargs ${bootargs} console=" \
- CONFIG_CONSOLE_DEV ",${baudrate}\0" \
+ CONSOLE_DEV ",${baudrate}\0" \
"bootfile="CONFIG_BOARD_NAME"/uImage_"CONFIG_BOARD_NAME"_act\0" \
"kernel_addr_r=600000\0" \
"initrd_high=0x03e00000\0" \
#endif
/*
- * I2C configuration
- */
-#define CONFIG_HARD_I2C 1 /* I2C with hardware support */
-#define CONFIG_SYS_I2C_MODULE 1 /* Select I2C module #1 or #2 */
-#define CONFIG_SYS_I2C_SPEED 100000 /* 100 kHz */
-#define CONFIG_SYS_I2C_SLAVE 0x7F
-
-/*
- * EEPROM configuration:
- *
- * O2DNT board is equiped with Ramtron FRAM device FM24CL16
- * 16 Kib Ferroelectric Nonvolatile serial RAM memory
- * organized as 2048 x 8 bits and addressable as eight I2C devices
- * 0x50 ... 0x57 each 256 bytes in size
- *
- */
-#define CONFIG_SYS_I2C_FRAM
-#define CONFIG_SYS_I2C_EEPROM_ADDR 0x50 /* 1010000x */
-#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
-#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
-/*
* There is no write delay with FRAM, write operations are performed at bus
* speed. Thus, no status polling or write delay is needed.
*/