#define AHB_CLK_FREQ (CONFIG_SYS_CLK_FREQ/4)
#define BBUS_CLK_FREQ (CONFIG_SYS_CLK_FREQ/8)
-#undef CONFIG_USE_IRQ /* we don't need IRQ/FIQ stuff */
/*@TODO #define CONFIG_STATUS_LED*/
#define CONFIG_USE_IRQ
* Size of malloc() pool
*/
#define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128*1024)
-#define CONFIG_SYS_GBL_DATA_SIZE 128 /* size in bytes reserved for initial
- * data */
/*
* Hardware drivers
*/
#define CONFIG_NS9750_UART 1 /* use on-chip UART */
-#define CONFIG_DRIVER_NS9750_ETHERNET 1 /* use on-chip ethernet */
/*
* select serial console configuration
#define CONFIG_CMD_LOADB
#define CONFIG_CMD_LOADS
#define CONFIG_CMD_MEMORY
-#define CONFIG_CMD_NET
#define CONFIG_CMD_PING
#define CONFIG_SYS_MEMTEST_START 0x00000000 /* memtest works on */
#define CONFIG_SYS_MEMTEST_END 0x00780000 /* 7,5 MB in DRAM */ /* @TODO */
-#undef CONFIG_SYS_CLKS_IN_HZ /* everything, incl board info, in Hz */
-
#define CONFIG_SYS_LOAD_ADDR 0x00600000 /* default load address */ /* @TODO */
#define CONFIG_SYS_HZ (CPU_CLK_FREQ/64)
-/* valid baudrates */
-#define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
-
#define NS9750_ETH_PHY_ADDRESS (0x0000)
/*-----------------------------------------------------------------------
* Stack sizes
- *
- * The stack sizes are set up in start.S using the settings below
*/
-#define CONFIG_STACKSIZE (128*1024) /* regular stack */
#ifdef CONFIG_USE_IRQ
#define CONFIG_STACKSIZE_IRQ (4*1024) /* IRQ stack */
#define CONFIG_STACKSIZE_FIQ (4*1024) /* FIQ stack */