#define AHB_CLK_FREQ (CONFIG_SYS_CLK_FREQ/4)
#define BBUS_CLK_FREQ (CONFIG_SYS_CLK_FREQ/8)
-#undef CONFIG_USE_IRQ /* we don't need IRQ/FIQ stuff */
/*@TODO #define CONFIG_STATUS_LED*/
#define CONFIG_USE_IRQ
/*
* Size of malloc() pool
*/
-#define CFG_MALLOC_LEN (CFG_ENV_SIZE + 128*1024)
-#define CFG_GBL_DATA_SIZE 128 /* size in bytes reserved for initial
- * data */
+#define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128*1024)
/*
* Hardware drivers
*/
-#define CFG_NS9750_UART 1 /* use on-chip UART */
-#define CONFIG_DRIVER_NS9750_ETHERNET 1 /* use on-chip ethernet */
+#define CONFIG_NS9750_UART 1 /* use on-chip UART */
/*
* select serial console configuration
*/
-#define CONFIG_CONS_INDEX 1 /* Port B */
+#define CONFIG_CONS_INDEX 1 /* Port B */
/* allow to overwrite serial and ethaddr */
#define CONFIG_ENV_OVERWRITE
#define CONFIG_BAUDRATE 38400
-/***********************************************************
- * Command definition
- ***********************************************************/
-#if 0 /* @TODO */
-#define CONFIG_COMMANDS \
- (CONFIG_CMD_DFL | \
- CFG_CMD_CACHE | \
- /*CFG_CMD_NAND |*/ \
- /*CFG_CMD_EEPROM |*/ \
- /*CFG_CMD_I2C |*/ \
- /*CFG_CMD_USB |*/ \
- CFG_CMD_REGINFO | \
- CFG_CMD_DATE | \
- CFG_CMD_ELF)
-#else
-#define CONFIG_COMMANDS \
- (CONFIG_CMD_BDI | \
- CFG_CMD_NET | \
- CFG_CMD_PING | \
- CFG_CMD_CONSOLE | \
- CFG_CMD_LOADB | \
- CFG_CMD_LOADS | \
- CFG_CMD_MEMORY)
-#endif
-/* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
-#include <cmd_confdefs.h>
+/*
+ * BOOTP options
+ */
+#define CONFIG_BOOTP_BOOTFILESIZE
+#define CONFIG_BOOTP_BOOTPATH
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_HOSTNAME
+
+
+/*
+ * Command line configuration.
+ */
+
+#define CONFIG_CMD_BDI
+#define CONFIG_CMD_CONSOLE
+#define CONFIG_CMD_LOADB
+#define CONFIG_CMD_LOADS
+#define CONFIG_CMD_MEMORY
+#define CONFIG_CMD_PING
+
#define CONFIG_BOOTDELAY 3
-/*#define CONFIG_BOOTARGS "root=ramfs devfs=mount console=ttySA0,9600" */
+/*#define CONFIG_BOOTARGS "root=ramfs devfs=mount console=ttySA0,9600" */
#define CONFIG_ETHADDR 00:04:f3:ff:ff:fb /*@TODO unset */
#define CONFIG_NETMASK 255.255.255.0
/*#define CONFIG_BOOTFILE "elinos-lart" */
/*#define CONFIG_BOOTCOMMAND "tftp; bootm" */
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
+#if defined(CONFIG_CMD_KGDB)
#define CONFIG_KGDB_BAUDRATE 115200 /* speed to run kgdb serial port */
/* what's this ? it's not used anywhere */
#define CONFIG_KGDB_SER_INDEX 1 /* which serial port to use */
/*
* Miscellaneous configurable options
*/
-#define CFG_LONGHELP /* undef to save memory */
-#define CFG_PROMPT "NS9750DEV # " /* Monitor Command Prompt */
-#define CFG_CBSIZE 256 /* Console I/O Buffer Size */
-#define CFG_PBSIZE (CFG_CBSIZE+sizeof(CFG_PROMPT)+16) /* Print Buffer Size */
-#define CFG_MAXARGS 16 /* max number of command args */
-#define CFG_BARGSIZE CFG_CBSIZE /* Boot Argument Buffer Size */
+#define CONFIG_SYS_LONGHELP /* undef to save memory */
+#define CONFIG_SYS_PROMPT "NS9750DEV # " /* Monitor Command Prompt */
+#define CONFIG_SYS_CBSIZE 256 /* Console I/O Buffer Size */
+#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16) /* Print Buffer Size */
+#define CONFIG_SYS_MAXARGS 16 /* max number of command args */
+#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot Argument Buffer Size */
-#define CFG_MEMTEST_START 0x00000000 /* memtest works on */
-#define CFG_MEMTEST_END 0x00780000 /* 7,5 MB in DRAM */ /* @TODO */
+#define CONFIG_SYS_MEMTEST_START 0x00000000 /* memtest works on */
+#define CONFIG_SYS_MEMTEST_END 0x00780000 /* 7,5 MB in DRAM */ /* @TODO */
-#undef CFG_CLKS_IN_HZ /* everything, incl board info, in Hz */
+#define CONFIG_SYS_LOAD_ADDR 0x00600000 /* default load address */ /* @TODO */
-#define CFG_LOAD_ADDR 0x00600000 /* default load address */ /* @TODO */
-
-#define CFG_HZ (CPU_CLK_FREQ/64)
-
-/* valid baudrates */
-#define CFG_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
+#define CONFIG_SYS_HZ (CPU_CLK_FREQ/64)
#define NS9750_ETH_PHY_ADDRESS (0x0000)
/*-----------------------------------------------------------------------
* Stack sizes
- *
- * The stack sizes are set up in start.S using the settings below
*/
-#define CONFIG_STACKSIZE (128*1024) /* regular stack */
#ifdef CONFIG_USE_IRQ
#define CONFIG_STACKSIZE_IRQ (4*1024) /* IRQ stack */
#define CONFIG_STACKSIZE_FIQ (4*1024) /* FIQ stack */
#define PHYS_FLASH_1 0x50000000 /* Flash Bank #1 */
-#define CFG_FLASH_BASE PHYS_FLASH_1
+#define CONFIG_SYS_FLASH_BASE PHYS_FLASH_1
/*-----------------------------------------------------------------------
* FLASH and environment organization
#define CONFIG_AMD_LV800 1 /* uncomment this if you have a LV800 flash */
#endif
-#define CFG_MAX_FLASH_BANKS 1 /* max number of memory banks */
+#define CONFIG_SYS_MAX_FLASH_BANKS 1 /* max number of memory banks */
#ifdef CONFIG_AMD_LV800
#define PHYS_FLASH_SIZE 0x00100000 /* 1MB */
-#define CFG_MAX_FLASH_SECT (19) /* max number of sectors on one chip */
-#define CFG_ENV_ADDR (CFG_FLASH_BASE + 0x0F0000) /* addr of environment */
+#define CONFIG_SYS_MAX_FLASH_SECT (19) /* max number of sectors on one chip */
+#define CONFIG_ENV_ADDR (CONFIG_SYS_FLASH_BASE + 0x0F0000) /* addr of environment */
#endif
#ifdef CONFIG_AMD_LV400
#define PHYS_FLASH_SIZE 0x00080000 /* 512KB */
-#define CFG_MAX_FLASH_SECT (11) /* max number of sectors on one chip */
-#define CFG_ENV_ADDR (CFG_FLASH_BASE + 0x070000) /* addr of environment */
+#define CONFIG_SYS_MAX_FLASH_SECT (11) /* max number of sectors on one chip */
+#define CONFIG_ENV_ADDR (CONFIG_SYS_FLASH_BASE + 0x070000) /* addr of environment */
#endif
/* timeout values are in ticks */
-#define CFG_FLASH_ERASE_TOUT (5*CFG_HZ) /* Timeout for Flash Erase */
-#define CFG_FLASH_WRITE_TOUT (5*CFG_HZ) /* Timeout for Flash Write */
+#define CONFIG_SYS_FLASH_ERASE_TOUT (5*CONFIG_SYS_HZ) /* Timeout for Flash Erase */
+#define CONFIG_SYS_FLASH_WRITE_TOUT (5*CONFIG_SYS_HZ) /* Timeout for Flash Write */
/* @TODO */
-/*#define CFG_ENV_IS_IN_FLASH 1*/
-#define CFG_ENV_IS_NOWHERE
-#define CFG_ENV_SIZE 0x10000 /* Total Size of Environment Sector */
+/*#define CONFIG_ENV_IS_IN_FLASH 1*/
+#define CONFIG_ENV_IS_NOWHERE
+#define CONFIG_ENV_SIZE 0x10000 /* Total Size of Environment Sector */
#ifdef CONFIG_STATUS_LED