#undef _CONFIG_UART4 /* internal uart 4 */
#undef CONFIG_SILENT_CONSOLE /* use this to disable output */
-
/*
* BOOTP options
*/
#define CONFIG_BOOTP_GATEWAY
#define CONFIG_BOOTP_HOSTNAME
-
/*
* Command line configuration.
*/
#define CONFIG_CMD_JFFS2
-#undef CONFIG_CMD_LOADS
#undef CONFIG_CMD_CONSOLE
-#undef CONFIG_CMD_AUTOSCRIPT
+#undef CONFIG_CMD_DHCP
+#undef CONFIG_CMD_LOADS
#undef CONFIG_CMD_NET
#undef CONFIG_CMD_PING
-#undef CONFIG_CMD_DHCP
-
+#undef CONFIG_CMD_SOURCE
/*
* Boot options. Setting delay to -1 stops autostart count down.
#define CONFIG_SYS_MEMTEST_START 0x08100000 /* memtest test area */
#define CONFIG_SYS_MEMTEST_END 0x08F00000
-#undef CONFIG_SYS_CLKS_IN_HZ /* use HZ for freq. display */
-
#define CONFIG_SYS_HZ 3686400 /* incrementer freq: 3.6864 MHz */
#define CONFIG_SYS_CPUSPEED 0x141 /* core clock - register value */
*/
#define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + (128<<10) )
-
-#define CONFIG_SYS_GBL_DATA_SIZE 128 /* size in bytes reserved for initial data */
-
#define CONFIG_STACKSIZE (120<<10) /* stack size */
#ifdef CONFIG_USE_IRQ
*/
/* No command line, one static partition, whole device */
/*
-#undef CONFIG_JFFS2_CMDLINE
+#undef CONFIG_CMD_MTDPARTS
#define CONFIG_JFFS2_DEV "nor0"
#define CONFIG_JFFS2_PART_SIZE 0xFFFFFFFF
#define CONFIG_JFFS2_PART_OFFSET 0x00050000
/* mtdparts command line support */
/* Note: fake mtd_id used, no linux mtd map file */
-#define CONFIG_JFFS2_CMDLINE
+#define CONFIG_CMD_MTDPARTS
+#define CONFIG_MTD_DEVICE /* needed for mtdparts commands */
+#define CONFIG_FLASH_CFI_MTD
#define MTDIDS_DEFAULT "nor0=mx1fs2-0"
#ifdef BUS32BIT_VERSION
0x000b00b ->3<- -> 64MHz/4=16MHz */
#ifdef _CONFIG_UART1
+#define CONFIG_IMX_SERIAL
#define CONFIG_IMX_SERIAL1
#elif defined _CONFIG_UART2
+#define CONFIG_IMX_SERIAL
#define CONFIG_IMX_SERIAL2
#elif defined _CONFIG_UART3 | defined _CONFIG_UART4
-#define CONFIG_IMX_SERIAL_NONE
#define CONFIG_SYS_NS16550
#define CONFIG_SYS_NS16550_SERIAL
#define CONFIG_SYS_NS16550_CLK 3686400