#define CONFIG_HIGH_BATS /* High BATs supported */
#define CONFIG_ALTIVEC /* undef to disable */
+#define CONFIG_SYS_TEXT_BASE 0xFF000000
+
#define CONFIG_SYS_BOARD_NAME "MPC7448 HPC II"
#define CONFIG_IDENT_STRING " Freescale MPC7448 HPC II"
#define CONFIG_SYS_OCN_CLK 133000000 /* 133 MHz */
-#define CONFIG_SYS_CONFIG_BUS_CLK 133000000
+#define CONFIG_SYS_BUS_CLK 133000000
#define CONFIG_SYS_CLK_SPREAD /* Enable Spread-Spectrum Clock generation */
#define CONFIG_OF_LIBFDT 1
#define CONFIG_OF_BOARD_SETUP 1
-#define OF_CPU "PowerPC,7448@0"
#define OF_TSI "tsi108@c0000000"
#define OF_TBCLK (bd->bi_busfreq / 8)
#define OF_STDOUT_PATH "/tsi108@c0000000/serial@7808"
/* Networking Configuration */
-#define KSEG1ADDR(a) (a) /* Needed by the rtl8139 driver */
-
#define CONFIG_TSI108_ETH
#define CONFIG_TSI108_ETH_NUM_PORTS 2
#define CONFIG_CMD_SDRAM
#define CONFIG_CMD_EEPROM
#define CONFIG_CMD_FLASH
-#define CONFIG_CMD_ENV
+#define CONFIG_CMD_SAVEENV
#define CONFIG_CMD_BSP
#define CONFIG_CMD_DHCP
#define CONFIG_CMD_PING
*/
#define CONFIG_VERSION_VARIABLE 1
#define CONFIG_TSI108_I2C
+#define CONFIG_SYS_I2C_SPEED 100000 /* I2C speed */
#define CONFIG_SYS_I2C_EEPROM_ADDR 0x50 /* I2C EEPROM page 1 */
#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1 /* Bytes of address */
#define CONFIG_SYS_RESET_ADDRESS 0x3fffff00
#define CONFIG_SYS_MONITOR_LEN (256 << 10) /* Reserve 256 kB for Monitor */
-#define CONFIG_SYS_MONITOR_BASE TEXT_BASE /* u-boot code base */
+#define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_TEXT_BASE /* u-boot code base */
#define CONFIG_SYS_MALLOC_LEN (256 << 10) /* Reserve 256 kB for malloc */
/* Peripheral Device section */
#define CONFIG_SYS_PCI_IO_SIZE 0x01000000 /* 16MB */
-#define _IO_BASE 0x00000000 /* points to PCI I/O space */
-
/* PCI Config Space mapping */
#define CONFIG_SYS_PCI_CFG_BASE 0xfb000000 /* Changed from FE000000 */
#define CONFIG_SYS_PCI_CFG_SIZE 0x01000000 /* 16MB */
#define L2_INIT 0
#define L2_ENABLE (L2_INIT | L2CR_L2E)
-
-/*
- * Internal Definitions
- *
- * Boot Flags
- */
-#define BOOTFLAG_COLD 0x01 /* Normal Power-On: Boot from FLASH */
-#define BOOTFLAG_WARM 0x02 /* Software reboot */
#define CONFIG_SYS_SERIAL_HANG_IN_EXCEPTION
#endif /* __CONFIG_H */