/*
- * (C) Copyright 2007 Czech Technical University.
+ * (C) Copyright 2007-2008 Michal Simek
*
- * Michal SIMEK <monstr@seznam.cz>
+ * Michal SIMEK <monstr@monstr.eu>
*
* See file CREDITS for list of people who contributed to this
* project.
#define CONFIG_ML401 1 /* ML401 Board */
/* uart */
-#define XILINX_UARTLITE
-#define CONFIG_SERIAL_BASE XILINX_UART_BASEADDR
-#define CONFIG_BAUDRATE XILINX_UART_BAUDRATE
+#ifdef XILINX_UARTLITE_BASEADDR
+#define CONFIG_XILINX_UARTLITE
+#define CONFIG_SERIAL_BASE XILINX_UARTLITE_BASEADDR
+#define CONFIG_BAUDRATE XILINX_UARTLITE_BAUDRATE
#define CFG_BAUDRATE_TABLE { CONFIG_BAUDRATE }
+#else
+#ifdef XILINX_UART16550_BASEADDR
+#define CFG_NS16550
+#define CFG_NS16550_SERIAL
+#define CFG_NS16550_REG_SIZE 4
+#define CONFIG_CONS_INDEX 1
+#define CFG_NS16550_COM1 XILINX_UART16550_BASEADDR
+#define CFG_NS16550_CLK XILINX_UART16550_CLOCK_HZ
+#define CONFIG_BAUDRATE 115200
+#define CFG_BAUDRATE_TABLE { 9600, 115200 }
+#endif
+#endif
/* setting reset address */
/*#define CFG_RESET_ADDRESS TEXT_BASE*/
/* ethernet */
-#define CONFIG_EMACLITE 1
-#define XPAR_EMAC_0_DEVICE_ID XPAR_OPB_ETHERNET_0_DEVICE_ID
+#ifdef XILINX_EMAC_BASEADDR
+#define CONFIG_XILINX_EMAC 1
+#define CFG_ENET
+#else
+#ifdef XILINX_EMACLITE_BASEADDR
+#define CONFIG_XILINX_EMACLITE 1
+#define CFG_ENET
+#endif
+#endif
+#undef ET_DEBUG
/* gpio */
+#ifdef XILINX_GPIO_BASEADDR
#define CFG_GPIO_0 1
#define CFG_GPIO_0_ADDR XILINX_GPIO_BASEADDR
+#endif
/* interrupt controller */
+#ifdef XILINX_INTC_BASEADDR
#define CFG_INTC_0 1
#define CFG_INTC_0_ADDR XILINX_INTC_BASEADDR
#define CFG_INTC_0_NUM XILINX_INTC_NUM_INTR_INPUTS
+#endif
/* timer */
+#ifdef XILINX_TIMER_BASEADDR
+#if (XILINX_TIMER_IRQ != -1)
#define CFG_TIMER_0 1
#define CFG_TIMER_0_ADDR XILINX_TIMER_BASEADDR
#define CFG_TIMER_0_IRQ XILINX_TIMER_IRQ
#define FREQUENCE XILINX_CLOCK_FREQ
#define CFG_TIMER_0_PRELOAD ( FREQUENCE/1000 )
-
+#endif
+#else
+#ifdef XILINX_CLOCK_FREQ
+#define CONFIG_XILINX_CLOCK_FREQ XILINX_CLOCK_FREQ
+#else
+#error BAD CLOCK FREQ
+#endif
+#endif
/* FSL */
-#define CFG_FSL_2
-#define FSL_INTR_2 1
+/* #define CFG_FSL_2 */
+/* #define FSL_INTR_2 1 */
/*
* memory layout - Example
#else /* !RAMENV */
#define CFG_ENV_IS_IN_FLASH 1
- #define CFG_ENV_ADDR 0x40000
#define CFG_ENV_SECT_SIZE 0x40000 /* 256K(one sector) for env */
- #define CFG_ENV_SIZE 0x2000
+ #define CFG_ENV_ADDR (CFG_FLASH_BASE + (2 * CFG_ENV_SECT_SIZE))
+ #define CFG_ENV_SIZE 0x40000
#endif /* !RAMBOOT */
#else /* !FLASH */
/* ENV in RAM */
#define CFG_FLASH_PROTECTION /* hardware flash protection */
#endif /* !FLASH */
-#ifdef FLASH
- #ifdef RAMENV
- #define CONFIG_COMMANDS (CONFIG__CMD_DFL |\
- CFG_CMD_MEMORY |\
- CFG_CMD_MISC |\
- CFG_CMD_AUTOSCRIPT |\
- CFG_CMD_IRQ |\
- CFG_CMD_ASKENV |\
- CFG_CMD_BDI |\
- CFG_CMD_RUN |\
- CFG_CMD_LOADS |\
- CFG_CMD_LOADB |\
- CFG_CMD_IMI |\
- CFG_CMD_NET |\
- CFG_CMD_CACHE |\
- CFG_CMD_FAT |\
- CFG_CMD_EXT2 |\
- CFG_CMD_JFFS2 |\
- CFG_CMD_ECHO |\
- CFG_CMD_IMLS |\
- CFG_CMD_FLASH |\
- CFG_CMD_MFSL |\
- CFG_CMD_PING \
- )
- #else /* !RAMENV */
- #define CONFIG_COMMANDS (CONFIG__CMD_DFL |\
- CFG_CMD_MEMORY |\
- CFG_CMD_MISC |\
- CFG_CMD_AUTOSCRIPT |\
- CFG_CMD_IRQ |\
- CFG_CMD_ASKENV |\
- CFG_CMD_BDI |\
- CFG_CMD_RUN |\
- CFG_CMD_LOADS |\
- CFG_CMD_LOADB |\
- CFG_CMD_IMI |\
- CFG_CMD_NET |\
- CFG_CMD_CACHE |\
- CFG_CMD_IMLS |\
- CFG_CMD_FLASH |\
- CFG_CMD_PING |\
- CFG_CMD_ENV |\
- CFG_CMD_FAT |\
- CFG_CMD_EXT2 |\
- CFG_CMD_JFFS2 |\
- CFG_CMD_ECHO |\
- CFG_CMD_MFSL |\
- CFG_CMD_SAVES \
- )
+/* system ace */
+#ifdef XILINX_SYSACE_BASEADDR
+ #define CONFIG_SYSTEMACE
+ /* #define DEBUG_SYSTEMACE */
+ #define SYSTEMACE_CONFIG_FPGA
+ #define CFG_SYSTEMACE_BASE XILINX_SYSACE_BASEADDR
+ #define CFG_SYSTEMACE_WIDTH XILINX_SYSACE_MEM_WIDTH
+ #define CONFIG_DOS_PARTITION
+#endif
+
+/*
+ * BOOTP options
+ */
+#define CONFIG_BOOTP_BOOTFILESIZE
+#define CONFIG_BOOTP_BOOTPATH
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_HOSTNAME
+
+/*
+ * Command line configuration.
+ */
+#include <config_cmd_default.h>
+
+#define CONFIG_CMD_ASKENV
+#define CONFIG_CMD_CACHE
+#define CONFIG_CMD_IRQ
+#define CONFIG_CMD_MFSL
+
+#ifndef CFG_ENET
+ #undef CONFIG_CMD_NET
+#else
+ #define CONFIG_CMD_PING
+#endif
+#if defined(CONFIG_SYSTEMACE)
+ #define CONFIG_CMD_EXT2
+ #define CONFIG_CMD_FAT
+#endif
+
+#if defined(FLASH)
+ #define CONFIG_CMD_ECHO
+ #define CONFIG_CMD_FLASH
+ #define CONFIG_CMD_IMLS
+ #define CONFIG_CMD_JFFS2
+
+ #if !defined(RAMENV)
+ #define CONFIG_CMD_ENV
+ #define CONFIG_CMD_SAVES
#endif
+#else
+ #undef CONFIG_CMD_FLASH
+#endif
-#else /* !FLASH */
- #define CONFIG_COMMANDS (CONFIG__CMD_DFL |\
- CFG_CMD_MEMORY |\
- CFG_CMD_MISC |\
- CFG_CMD_AUTOSCRIPT |\
- CFG_CMD_IRQ |\
- CFG_CMD_ASKENV |\
- CFG_CMD_BDI |\
- CFG_CMD_RUN |\
- CFG_CMD_LOADS |\
- CFG_CMD_FAT |\
- CFG_CMD_EXT2 |\
- CFG_CMD_LOADB |\
- CFG_CMD_IMI |\
- CFG_CMD_NET |\
- CFG_CMD_CACHE |\
- CFG_CMD_MFSL |\
- CFG_CMD_PING \
- )
-#endif /* !FLASH */
-/* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
-#include <cmd_confdefs.h>
-
-#if (CONFIG_COMMANDS & CFG_CMD_JFFS2)
+#if defined(CONFIG_CMD_JFFS2)
/* JFFS2 partitions */
#define CONFIG_JFFS2_CMDLINE /* mtdparts command line support */
#define MTDIDS_DEFAULT "nor0=ml401-0"
#define CFG_USR_EXCEP /* user exception */
#define CFG_HZ 1000
-/* system ace */
-#define CONFIG_SYSTEMACE
-/* #define DEBUG_SYSTEMACE */
-#define SYSTEMACE_CONFIG_FPGA
-#define CFG_SYSTEMACE_BASE XILINX_SYSACE_BASEADDR
-#define CFG_SYSTEMACE_WIDTH XILINX_SYSACE_MEM_WIDTH
-#define CONFIG_DOS_PARTITION
-
#define CONFIG_PREBOOT "echo U-BOOT for ML401;setenv preboot;echo"
#define CONFIG_EXTRA_ENV_SETTINGS "unlock=yes\0" /* hardware flash protection */\
"256k(u-boot),256k(env),3m(kernel),"\
"1m(romfs),1m(cramfs),-(jffs2)\0"
+#define CONFIG_CMDLINE_EDITING
+#define CONFIG_OF_LIBFDT 1
+
#endif /* __CONFIG_H */
projects / platform / kernel / u-boot.git / blobdiff