#define MACH_TYPE_M28EVK 3613
#define CONFIG_MACH_TYPE MACH_TYPE_M28EVK
-#define CONFIG_FIT
-
#define CONFIG_TIMESTAMP /* Print image info with timestamp */
/* U-Boot Commands */
#define CONFIG_SYS_NO_FLASH
-#include <config_cmd_default.h>
-#define CONFIG_DISPLAY_CPUINFO
#define CONFIG_DOS_PARTITION
#define CONFIG_FAT_WRITE
-#define CONFIG_CMD_ASKENV
#define CONFIG_CMD_BMP
-#define CONFIG_CMD_CACHE
#define CONFIG_CMD_DATE
-#define CONFIG_CMD_DHCP
#define CONFIG_CMD_EEPROM
-#define CONFIG_CMD_EXT4
-#define CONFIG_CMD_EXT4_WRITE
-#define CONFIG_CMD_FAT
-#define CONFIG_CMD_GPIO
-#define CONFIG_CMD_GREPENV
-#define CONFIG_CMD_I2C
-#define CONFIG_CMD_MII
-#define CONFIG_CMD_MMC
#define CONFIG_CMD_NAND
#define CONFIG_CMD_NAND_TRIMFFS
-#define CONFIG_CMD_NET
-#define CONFIG_CMD_NFS
-#define CONFIG_CMD_PING
-#define CONFIG_CMD_SETEXPR
-#define CONFIG_CMD_SF
-#define CONFIG_CMD_SPI
-#define CONFIG_CMD_USB
-#define CONFIG_VIDEO
-
-#define CONFIG_REGEX /* Enable regular expression support */
/* Memory configuration */
#define CONFIG_NR_DRAM_BANKS 1 /* 1 bank of DRAM */
#if defined(CONFIG_CMD_NAND) && defined(CONFIG_ENV_IS_IN_NAND)
#define CONFIG_ENV_SIZE_REDUND CONFIG_ENV_SIZE
#define CONFIG_ENV_SECT_SIZE (128 * 1024)
-#define CONFIG_ENV_RANGE (512 * 1024)
-#define CONFIG_ENV_OFFSET 0x300000
+#define CONFIG_ENV_RANGE (4 * CONFIG_ENV_SECT_SIZE)
+#define CONFIG_ENV_OFFSET (24 * CONFIG_ENV_SECT_SIZE) /* 3 MiB */
#define CONFIG_ENV_OFFSET_REDUND \
(CONFIG_ENV_OFFSET + CONFIG_ENV_RANGE)
-#define CONFIG_CMD_UBI
#define CONFIG_CMD_UBIFS
#define CONFIG_CMD_MTDPARTS
#define CONFIG_RBTREE
#define MTDIDS_DEFAULT "nand0=gpmi-nand"
#define MTDPARTS_DEFAULT \
"mtdparts=gpmi-nand:" \
- "3m(bootloader)ro," \
- "512k(environment)," \
- "512k(redundant-environment)," \
- "4m(kernel)," \
- "128k(fdt)," \
- "8m(ramdisk)," \
- "-(filesystem)"
+ "3m(u-boot)," \
+ "512k(env1)," \
+ "512k(env2)," \
+ "14m(boot)," \
+ "238m(data)," \
+ "-@4096k(UBI)"
#else
#define CONFIG_ENV_IS_NOWHERE
#endif
/* EEPROM */
#ifdef CONFIG_CMD_EEPROM
-#define CONFIG_SYS_I2C_MULTI_EEPROMS
#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 2
#endif
#define CONFIG_EHCI_MXS_PORT0
#define CONFIG_EHCI_MXS_PORT1
#define CONFIG_USB_MAX_CONTROLLER_COUNT 2
-#define CONFIG_USB_STORAGE
#endif
/* SPI */
/* SPI FLASH */
#ifdef CONFIG_CMD_SF
-#define CONFIG_SPI_FLASH
-#define CONFIG_SPI_FLASH_STMICRO
#define CONFIG_SF_DEFAULT_BUS 2
#define CONFIG_SF_DEFAULT_CS 0
#define CONFIG_SF_DEFAULT_SPEED 40000000
#endif
/* Booting Linux */
-#define CONFIG_BOOTDELAY 3
-#define CONFIG_BOOTFILE "uImage"
+#define CONFIG_BOOTFILE "fitImage"
#define CONFIG_BOOTARGS "console=ttyAMA0,115200n8 "
-#define CONFIG_BOOTCOMMAND "run bootcmd_net"
+#define CONFIG_BOOTCOMMAND "run mmc_mmc"
#define CONFIG_LOADADDR 0x42000000
#define CONFIG_SYS_LOAD_ADDR CONFIG_LOADADDR
/* Extra Environment */
+#define CONFIG_PREBOOT "run try_bootscript"
+#define CONFIG_HOSTNAME m28evk
+
#define CONFIG_EXTRA_ENV_SETTINGS \
+ "consdev=ttyAMA0\0" \
+ "baudrate=115200\0" \
+ "bootscript=boot.scr\0" \
+ "bootdev=/dev/mmcblk0p2\0" \
+ "rootdev=/dev/mmcblk0p3\0" \
+ "netdev=eth0\0" \
+ "hostname=m28evk\0" \
+ "rootpath=/opt/eldk-5.5/armv5te/rootfs-qte-sdk\0" \
+ "kernel_addr_r=0x42000000\0" \
+ "videomode=video=ctfb:x:800,y:480,depth:18,mode:0,pclk:30066," \
+ "le:0,ri:256,up:0,lo:45,hs:1,vs:1,sync:100663296," \
+ "vmode:0\0" \
"update_nand_full_filename=u-boot.nand\0" \
"update_nand_firmware_filename=u-boot.sb\0" \
"update_sd_firmware_filename=u-boot.sd\0" \
"if tftp ${update_nand_full_filename} ; then " \
"run update_nand_get_fcb_size ; " \
"nand scrub -y 0x0 ${filesize} ; " \
- "nand write.raw ${loadaddr} 0x0 ${fcb_sz} ; " \
+ "nand write.raw ${loadaddr} 0x0 ${fcb_sz} ; " \
"setexpr update_off ${loadaddr} + ${update_nand_fcb} ; " \
"setexpr update_sz ${filesize} - ${update_nand_fcb} ; " \
"nand write ${update_off} ${update_nand_fcb} ${update_sz} ; " \
"setexpr fw_sz ${fw_sz} + 1 ; " \
"mmc write ${loadaddr} 0x800 ${fw_sz} ; " \
"fi ; " \
+ "fi\0" \
+ "addcons=" \
+ "setenv bootargs ${bootargs} " \
+ "console=${consdev},${baudrate}\0" \
+ "addip=" \
+ "setenv bootargs ${bootargs} " \
+ "ip=${ipaddr}:${serverip}:${gatewayip}:" \
+ "${netmask}:${hostname}:${netdev}:off\0" \
+ "addmisc=" \
+ "setenv bootargs ${bootargs} ${miscargs}\0" \
+ "adddfltmtd=" \
+ "if test \"x${mtdparts}\" == \"x\" ; then " \
+ "mtdparts default ; " \
+ "fi\0" \
+ "addmtd=" \
+ "run adddfltmtd ; " \
+ "setenv bootargs ${bootargs} ${mtdparts}\0" \
+ "addargs=run addcons addmtd addmisc\0" \
+ "mmcload=" \
+ "mmc rescan ; " \
+ "load mmc 0:2 ${kernel_addr_r} ${bootfile}\0" \
+ "ubiload=" \
+ "ubi part UBI ; ubifsmount ubi0:rootfs ; " \
+ "ubifsload ${kernel_addr_r} /boot/${bootfile}\0" \
+ "netload=" \
+ "tftp ${kernel_addr_r} ${hostname}/${bootfile}\0" \
+ "miscargs=nohlt panic=1\0" \
+ "mmcargs=setenv bootargs root=${rootdev} rw rootwait\0" \
+ "ubiargs=" \
+ "setenv bootargs ubi.mtd=5 " \
+ "root=ubi0:rootfs rootfstype=ubifs\0" \
+ "nfsargs=" \
+ "setenv bootargs root=/dev/nfs rw " \
+ "nfsroot=${serverip}:${rootpath},v3,tcp\0" \
+ "mmc_mmc=" \
+ "run mmcload mmcargs addargs ; " \
+ "bootm ${kernel_addr_r}\0" \
+ "mmc_ubi=" \
+ "run mmcload ubiargs addargs ; " \
+ "bootm ${kernel_addr_r}\0" \
+ "mmc_nfs=" \
+ "run mmcload nfsargs addip addargs ; " \
+ "bootm ${kernel_addr_r}\0" \
+ "ubi_mmc=" \
+ "run ubiload mmcargs addargs ; " \
+ "bootm ${kernel_addr_r}\0" \
+ "ubi_ubi=" \
+ "run ubiload ubiargs addargs ; " \
+ "bootm ${kernel_addr_r}\0" \
+ "ubi_nfs=" \
+ "run ubiload nfsargs addip addargs ; " \
+ "bootm ${kernel_addr_r}\0" \
+ "net_mmc=" \
+ "run netload mmcargs addargs ; " \
+ "bootm ${kernel_addr_r}\0" \
+ "net_ubi=" \
+ "run netload ubiargs addargs ; " \
+ "bootm ${kernel_addr_r}\0" \
+ "net_nfs=" \
+ "run netload nfsargs addip addargs ; " \
+ "bootm ${kernel_addr_r}\0" \
+ "try_bootscript=" \
+ "mmc rescan;" \
+ "if test -e mmc 0:2 ${bootscript} ; then " \
+ "if load mmc 0:2 ${kernel_addr_r} ${bootscript};" \
+ "then ; " \
+ "echo Running bootscript... ; " \
+ "source ${kernel_addr_r} ; " \
+ "fi ; " \
"fi\0"
/* The rest of the configuration is shared */