#ifdef CONFIG_LCD
#define CONFIG_SHARP_LM8V31
#endif
-#define CONFIG_MMC 1
+#define CONFIG_MMC
#define BOARD_LATE_INIT 1
#define CONFIG_DOS_PARTITION
#undef CONFIG_USE_IRQ /* we don't need IRQ/FIQ stuff */
+/* we will never enable dcache, because we have to setup MMU first */
+#define CONFIG_SYS_NO_DCACHE
+
/*
* Size of malloc() pool
*/
/*
* Hardware drivers
*/
-#define CONFIG_DRIVER_LAN91C96
+#define CONFIG_NET_MULTI
+#define CONFIG_LAN91C96
#define CONFIG_LAN91C96_BASE 0x0C000000
/*
* select serial console configuration
*/
+#define CONFIG_PXA_SERIAL
#define CONFIG_FFUART 1 /* we use FFUART on LUBBOCK */
/* allow to overwrite serial and ethaddr */
*/
#include <config_cmd_default.h>
-#define CONFIG_CMD_MMC
#define CONFIG_CMD_FAT
#define CONFIG_SYS_MEMTEST_START 0xa0400000 /* memtest works on */
#define CONFIG_SYS_MEMTEST_END 0xa0800000 /* 4 ... 8 MB in DRAM */
-#undef CONFIG_SYS_CLKS_IN_HZ /* everything, incl board info, in Hz */
-
#define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_DRAM_BASE + 0x8000) /* default load address */
#define CONFIG_SYS_HZ 1000
/* valid baudrates */
#define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
+#ifdef CONFIG_MMC
+#define CONFIG_PXA_MMC
+#define CONFIG_CMD_MMC
#define CONFIG_SYS_MMC_BASE 0xF0000000
+#endif
/*
* Stack sizes
#define CONFIG_SYS_FLASH_BASE PHYS_FLASH_1
+#define CONFIG_SYS_SDRAM_BASE PHYS_SDRAM_1
+#define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_GBL_DATA_SIZE + PHYS_SDRAM_1)
+
#define FPGA_REGS_BASE_PHYSICAL 0x08000000
/*