ppc4xx: Remove implementations of testdram()

[platform/kernel/u-boot.git] / include / configs / luan.h

diff --git a/include/configs/luan.h b/include/configs/luan.h
index 72aae09..41999d3 100644 (file)
--- a/include/configs/luan.h
+++ b/include/configs/luan.h
@@ -39,7 +39,6 @@
 
 #define CONFIG_BOARD_EARLY_INIT_F 1    /* call board_early_init_f()    */
 #define CONFIG_MISC_INIT_R     1       /* call misc_init_r()           */
-#define CONFIG_ADD_RAM_INFO    1       /* Print additional info        */
 
 /*-----------------------------------------------------------------------
  * Base addresses -- Note these are effective addresses where the
@@ -69,7 +68,6 @@
 #define CFG_FLASH_BASE         CFG_SMALL_FLASH
 #endif
 
-#undef CFG_DRAM_TEST
 #if CFG_SRAM_BASE
 #define CFG_KBYTES_SDRAM       1024*2
 #else
@@ -136,7 +134,6 @@
 #define CONFIG_SPD_EEPROM      1       /* Use SPD EEPROM for setup     */
 #define SPD_EEPROM_ADDRESS     {0x53, 0x52}    /* SPD i2c spd addresses*/
 #define CONFIG_DDR_ECC         1       /* with ECC support             */
-#define CFG_44x_DDR2_CKTR_180  1       /* use 180 deg advance          */
 
 /*-----------------------------------------------------------------------
  * I2C
@@ -154,7 +151,7 @@
 #define CFG_EEPROM_PAGE_WRITE_DELAY_MS 10
 
 #define CONFIG_PREBOOT "echo;" \
-       "echo Type \"run flash_nfs\" to mount root filesystem over NFS;" \
+       "echo Type \\\"run flash_nfs\\\" to mount root filesystem over NFS;" \
        "echo"
 
 #undef CONFIG_BOOTARGS
@@ -184,7 +181,7 @@
        "update=protect off fffc0000 ffffffff;era fffc0000 ffffffff;"   \
                "cp.b 100000 fffc0000 40000;"                           \
                "setenv filesize;saveenv\0"                             \
-       "upd=run load;run update\0"                                     \
+       "upd=run load update\0"                                         \
        ""
 #define CONFIG_BOOTCOMMAND     "run flash_self"
 
@@ -197,6 +194,7 @@
 #define CONFIG_LOADS_ECHO      1       /* echo on for serial download  */
 #define CFG_LOADS_BAUD_CHANGE  1       /* allow baudrate change        */
 
+#define CONFIG_HAS_ETH0
 #define CONFIG_MII             1       /* MII PHY management           */
 #define CONFIG_PHY_ADDR                1
 #define CONFIG_CIS8201_PHY     1       /* Enable 'special' RGMII mode for Cicada phy */
@@ -213,7 +211,6 @@
 #define CONFIG_HW_WATCHDOG                     /* watchdog */
 #endif
 
-
 /*
  * BOOTP options
  */
@@ -222,7 +219,6 @@
 #define CONFIG_BOOTP_GATEWAY
 #define CONFIG_BOOTP_HOSTNAME
 
-
 /*
  * Command line configuration.
  */
@@ -230,7 +226,6 @@
 
 #define CONFIG_CMD_ASKENV
 #define CONFIG_CMD_DHCP
-#define CONFIG_CMD_ELF
 #define CONFIG_CMD_EEPROM
 #define CONFIG_CMD_I2C
 #define CONFIG_CMD_IRQ
@@ -242,7 +237,6 @@
 #define CONFIG_CMD_REGINFO
 #define CONFIG_CMD_SDRAM
 
-
 /*
  * Miscellaneous configurable options
  */
@@ -299,15 +293,6 @@
  */
 #define CFG_BOOTMAPSZ          (8 << 20)       /* Initial Memory map for Linux */
 
-/*-----------------------------------------------------------------------
- * Cache Configuration
- */
-#define CFG_DCACHE_SIZE                (32<<10) /* For AMCC 440 CPUs                   */
-#define CFG_CACHELINE_SIZE     32      /* ...                  */
-#if defined(CONFIG_CMD_KGDB)
-#define CFG_CACHELINE_SHIFT    5       /* log base 2 of the above value        */
-#endif
-
 /*
  * Internal Definitions
  *
@@ -321,4 +306,8 @@
 #define CONFIG_KGDB_SER_INDEX  2       /* which serial port to use */
 #endif
 
+/* pass open firmware flat tree */
+#define CONFIG_OF_LIBFDT       1
+#define CONFIG_OF_BOARD_SETUP  1
+
 #endif /* __CONFIG_H */