Remove various unused interrupt related code

[platform/kernel/u-boot.git] / include / configs / ls1043aqds.h

diff --git a/include/configs/ls1043aqds.h b/include/configs/ls1043aqds.h
index 820adc4..b14e944 100644 (file)
--- a/include/configs/ls1043aqds.h
+++ b/include/configs/ls1043aqds.h
@@ -38,9 +38,8 @@ unsigned long get_board_ddr_clk(void);
 #define SPD_EEPROM_ADDRESS             0x51
 #define CONFIG_SYS_SPD_BUS_NUM         0
 
+#ifndef CONFIG_SPL
 #define CONFIG_FSL_DDR_INTERACTIVE     /* Interactive debugging */
-#ifndef CONFIG_SYS_FSL_DDR4
-#define CONFIG_SYS_FSL_DDR3            /* Use DDR3 memory */
 #endif
 
 #define CONFIG_DDR_ECC
@@ -49,8 +48,6 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_MEM_INIT_VALUE           0xdeadbeef
 #endif
 
-#define CONFIG_SYS_HAS_SERDES
-
 #ifdef CONFIG_SYS_DPAA_FMAN
 #define CONFIG_FMAN_ENET
 #define CONFIG_PHYLIB
@@ -102,8 +99,6 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_SCSI_AHCI
 #define CONFIG_SCSI_AHCI_PLAT
 #define CONFIG_SCSI
-#define CONFIG_DOS_PARTITION
-#define CONFIG_BOARD_LATE_INIT
 
 /* EEPROM */
 #define CONFIG_ID_EEPROM
@@ -219,7 +214,6 @@ unsigned long get_board_ddr_clk(void);
 #if defined(CONFIG_QSPI_BOOT) || defined(CONFIG_SD_BOOT_QSPI)
 #define CONFIG_QIXIS_I2C_ACCESS
 #define CONFIG_SYS_I2C_EARLY_INIT
-#define CONFIG_SYS_NO_FLASH
 #endif
 
 /*
@@ -402,12 +396,6 @@ unsigned long get_board_ddr_clk(void);
 
 #define CONFIG_SYS_HZ                  1000
 
-/*
- * Stack sizes
- * The stack sizes are set up in start.S using the settings below
- */
-#define CONFIG_STACKSIZE               (30 * 1024)
-
 #define CONFIG_SYS_INIT_SP_OFFSET \
        (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)