#ifndef __CONFIG_H
#define __CONFIG_H
-#define CONFIG_ARMV7_SECURE_BASE OCRAM_BASE_S_ADDR
-
-#define CONFIG_SYS_FSL_CLK
-
-#define CONFIG_SKIP_LOWLEVEL_INIT
-
-#define CONFIG_DEEP_SLEEP
-
-/*
- * Size of malloc() pool
- */
-#define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 16 * 1024 * 1024)
-
#define CONFIG_SYS_INIT_RAM_ADDR OCRAM_BASE_ADDR
#define CONFIG_SYS_INIT_RAM_SIZE OCRAM_SIZE
-#ifndef __ASSEMBLY__
-unsigned long get_board_sys_clk(void);
-unsigned long get_board_ddr_clk(void);
-#endif
-
-#if defined(CONFIG_QSPI_BOOT) || defined(CONFIG_SD_BOOT_QSPI)
-#define CONFIG_SYS_CLK_FREQ 100000000
-#define CONFIG_DDR_CLK_FREQ 100000000
-#define CONFIG_QIXIS_I2C_ACCESS
-#else
-#define CONFIG_SYS_CLK_FREQ get_board_sys_clk()
-#define CONFIG_DDR_CLK_FREQ get_board_ddr_clk()
-#endif
-
-#ifdef CONFIG_RAMBOOT_PBL
-#define CONFIG_SYS_FSL_PBL_PBI board/freescale/ls1021aqds/ls102xa_pbi.cfg
-#endif
-
#ifdef CONFIG_SD_BOOT
-#ifdef CONFIG_SD_BOOT_QSPI
-#define CONFIG_SYS_FSL_PBL_RCW \
- board/freescale/ls1021aqds/ls102xa_rcw_sd_qspi.cfg
-#else
-#define CONFIG_SYS_FSL_PBL_RCW \
- board/freescale/ls1021aqds/ls102xa_rcw_sd_ifc.cfg
-#endif
-
-#define CONFIG_SPL_MAX_SIZE 0x1a000
-#define CONFIG_SPL_STACK 0x1001d000
-#define CONFIG_SPL_PAD_TO 0x1c000
-
-#define CONFIG_SYS_SPL_MALLOC_START (CONFIG_SYS_TEXT_BASE + \
- CONFIG_SYS_MONITOR_LEN)
-#define CONFIG_SYS_SPL_MALLOC_SIZE 0x100000
-#define CONFIG_SPL_BSS_START_ADDR 0x80100000
-#define CONFIG_SPL_BSS_MAX_SIZE 0x80000
#define CONFIG_SYS_MONITOR_LEN 0xc0000
#endif
#ifdef CONFIG_NAND_BOOT
-#define CONFIG_SYS_FSL_PBL_RCW board/freescale/ls1021aqds/ls102xa_rcw_nand.cfg
-
-#define CONFIG_SPL_MAX_SIZE 0x1a000
-#define CONFIG_SPL_STACK 0x1001d000
-#define CONFIG_SPL_PAD_TO 0x1c000
-
#define CONFIG_SYS_NAND_U_BOOT_SIZE (400 << 10)
-#define CONFIG_SYS_NAND_U_BOOT_OFFS CONFIG_SPL_PAD_TO
-#define CONFIG_SYS_NAND_PAGE_SIZE 2048
#define CONFIG_SYS_NAND_U_BOOT_DST CONFIG_SYS_TEXT_BASE
#define CONFIG_SYS_NAND_U_BOOT_START CONFIG_SYS_TEXT_BASE
-#define CONFIG_SYS_SPL_MALLOC_START 0x80200000
-#define CONFIG_SYS_SPL_MALLOC_SIZE 0x100000
-#define CONFIG_SPL_BSS_START_ADDR 0x80100000
-#define CONFIG_SPL_BSS_MAX_SIZE 0x80000
#define CONFIG_SYS_MONITOR_LEN 0x80000
#endif
-#define CONFIG_DDR_SPD
#define SPD_EEPROM_ADDRESS 0x51
#define CONFIG_SYS_SPD_BUS_NUM 0
#ifndef CONFIG_SYS_FSL_DDR4
#define CONFIG_SYS_DDR_RAW_TIMING
#endif
-#define CONFIG_DIMM_SLOTS_PER_CTLR 1
-#define CONFIG_CHIP_SELECTS_PER_CTRL 4
#define CONFIG_SYS_DDR_SDRAM_BASE 0x80000000UL
#define CONFIG_SYS_SDRAM_BASE CONFIG_SYS_DDR_SDRAM_BASE
-#define CONFIG_DDR_ECC
#ifdef CONFIG_DDR_ECC
-#define CONFIG_ECC_INIT_VIA_DDRCONTROLLER
#define CONFIG_MEM_INIT_VALUE 0xdeadbeef
#endif
* IFC Definitions
*/
#if !defined(CONFIG_QSPI_BOOT) && !defined(CONFIG_SD_BOOT_QSPI)
-#define CONFIG_FSL_IFC
#define CONFIG_SYS_FLASH_BASE 0x60000000
#define CONFIG_SYS_FLASH_BASE_PHYS CONFIG_SYS_FLASH_BASE
#define CONFIG_SYS_FLASH_QUIET_TEST
#define CONFIG_FLASH_SHOW_PROGRESS 45
-#define CONFIG_CFI_FLASH_USE_WEAK_ACCESSORS
#define CONFIG_SYS_WRITE_SWAPPED_DATA
-#define CONFIG_SYS_MAX_FLASH_BANKS 2 /* number of banks */
#define CONFIG_SYS_MAX_FLASH_SECT 1024 /* sectors per device */
#define CONFIG_SYS_FLASH_ERASE_TOUT 60000 /* Flash Erase Timeout (ms) */
#define CONFIG_SYS_FLASH_WRITE_TOUT 500 /* Flash Write Timeout (ms) */
/*
* NAND Flash Definitions
*/
-#define CONFIG_NAND_FSL_IFC
#define CONFIG_SYS_NAND_BASE 0x7e800000
#define CONFIG_SYS_NAND_BASE_PHYS CONFIG_SYS_NAND_BASE
| CSOR_NAND_SPRZ_64 /* Spare size = 64 */ \
| CSOR_NAND_PB(64)) /* 64 Pages Per Block */
-#define CONFIG_SYS_NAND_ONFI_DETECTION
-
#define CONFIG_SYS_NAND_FTIM0 (FTIM0_NAND_TCCST(0x7) | \
FTIM0_NAND_TWP(0x18) | \
FTIM0_NAND_TWCHT(0x7) | \
#define CONFIG_SYS_NAND_BASE_LIST { CONFIG_SYS_NAND_BASE }
#define CONFIG_SYS_MAX_NAND_DEVICE 1
-
-#define CONFIG_SYS_NAND_BLOCK_SIZE (128 * 1024)
#endif
/*
* QIXIS Definitions
*/
-#define CONFIG_FSL_QIXIS
#ifdef CONFIG_FSL_QIXIS
#define QIXIS_BASE 0x7fb00000
/*
* Serial Port
*/
-#ifdef CONFIG_LPUART
-#define CONFIG_LPUART_32B_REG
-#else
+#ifndef CONFIG_LPUART
#define CONFIG_SYS_NS16550_SERIAL
#ifndef CONFIG_DM_SERIAL
#define CONFIG_SYS_NS16550_REG_SIZE 1
*/
/* GPIO */
-#ifdef CONFIG_DM_GPIO
-#ifndef CONFIG_MPC8XXX_GPIO
-#define CONFIG_MPC8XXX_GPIO
-#endif
-#endif
/* EEPROM */
#define CONFIG_SYS_I2C_EEPROM_NXID
*/
/*
- * Video
- */
-#ifdef CONFIG_VIDEO_FSL_DCU_FB
-#define CONFIG_VIDEO_LOGO
-#define CONFIG_VIDEO_BMP_LOGO
-
-#define CONFIG_FSL_DIU_CH7301
-#define CONFIG_SYS_I2C_DVI_BUS_NUM 0
-#define CONFIG_SYS_I2C_QIXIS_ADDR 0x66
-#define CONFIG_SYS_I2C_DVI_ADDR 0x75
-#endif
-
-/*
* eTSEC
*/
#define TSEC2_PHYIDX 0
#define TSEC3_PHYIDX 0
-#define CONFIG_ETHPRIME "eTSEC1"
-
-#define CONFIG_HAS_ETH0
-#define CONFIG_HAS_ETH1
-#define CONFIG_HAS_ETH2
-
#define CONFIG_FSL_SGMII_RISER 1
#define SGMII_RISER_PHY_OFFSET 0x1b
#define CONFIG_PCI_SCAN_SHOW
#endif
-#define CONFIG_CMDLINE_TAG
-
#define CONFIG_PEN_ADDR_BIG_ENDIAN
#define CONFIG_LAYERSCAPE_NS_ACCESS
#define CONFIG_SMP_PEN_ADDR 0x01ee0200
-#define COUNTER_FREQUENCY 12500000
#define CONFIG_HWCONFIG
#define HWCONFIG_BUFFER_SIZE 256
#define CONFIG_FSL_DEVICE_DISABLE
-
-#define CONFIG_SYS_QE_FW_ADDR 0x60940000
-
#ifdef CONFIG_LPUART
#define CONFIG_EXTRA_ENV_SETTINGS \
"bootargs=root=/dev/ram0 rw console=ttyLP0,115200\0" \
*/
#define CONFIG_SYS_BOOTMAPSZ (256 << 20)
-#define CONFIG_SYS_LOAD_ADDR 0x82000000
-
#define CONFIG_LS102XA_STREAM_ID
-#define CONFIG_SYS_INIT_SP_OFFSET \
- (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
-#define CONFIG_SYS_INIT_SP_ADDR \
- (CONFIG_SYS_INIT_RAM_ADDR + CONFIG_SYS_INIT_SP_OFFSET)
-
-#ifdef CONFIG_SPL_BUILD
-#define CONFIG_SYS_MONITOR_BASE CONFIG_SPL_TEXT_BASE
-#else
-#define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_TEXT_BASE /* start of monitor */
-#endif
-
/*
* Environment
*/
projects / platform / kernel / u-boot.git / blobdiff