+/* SPDX-License-Identifier: GPL-2.0+ */
/*
* Copyright 2016 Freescale Semiconductor, Inc.
- *
- * SPDX-License-Identifier: GPL-2.0+
*/
#ifndef __LS1012AQDS_H__
/* DDR */
#define CONFIG_DIMM_SLOTS_PER_CTLR 1
#define CONFIG_CHIP_SELECTS_PER_CTRL 1
-#define CONFIG_NR_DRAM_BANKS 2
#define CONFIG_SYS_SDRAM_SIZE 0x40000000
-#define CONFIG_CMD_MEMINFO
-#define CONFIG_CMD_MEMTEST
-#define CONFIG_SYS_MEMTEST_START 0x80000000
-#define CONFIG_SYS_MEMTEST_END 0x9fffffff
/*
* QIXIS Definitions
* RTC configuration
*/
#define RTC
-#define CONFIG_RTC_PCF8563 1
#define CONFIG_SYS_I2C_RTC_ADDR 0x51 /* Channel 3*/
/* EEPROM */
/* DSPI */
#define CONFIG_FSL_DSPI1
-#define CONFIG_DEFAULT_SPI_BUS 1
-#define CONFIG_CMD_SPI
#define MMAP_DSPI DSPI1_BASE_ADDR
#define CONFIG_SYS_DSPI_CTAR0 1
DSPI_CTAR_DT(0))
#define CONFIG_SPI_FLASH_EON /* cs3 */
-#define CONFIG_SF_DEFAULT_SPEED 10000000
-#define CONFIG_SF_DEFAULT_MODE SPI_MODE_0
-#define CONFIG_SF_DEFAULT_BUS 1
-#define CONFIG_SF_DEFAULT_CS 0
-
-/*
-* USB
-*/
-/* EHCI Support - disbaled by default */
-/*#define CONFIG_HAS_FSL_DR_USB*/
-
-#ifdef CONFIG_HAS_FSL_DR_USB
-#define CONFIG_USB_EHCI_FSL
-#define CONFIG_EHCI_HCD_INIT_AFTER_RESET
-#endif
-
-/*XHCI Support - enabled by default*/
-#define CONFIG_HAS_FSL_XHCI_USB
-
-#ifdef CONFIG_HAS_FSL_XHCI_USB
-#define CONFIG_USB_XHCI_FSL
-#define CONFIG_USB_MAX_CONTROLLER_COUNT 1
-#endif
-
/* MMC */
#ifdef CONFIG_MMC
-#define CONFIG_FSL_ESDHC
#define CONFIG_SYS_FSL_MMC_HAS_CAPBLT_VS33
#endif
-/* SATA */
-#define CONFIG_LIBATA
-#define CONFIG_SCSI_AHCI
-#define CONFIG_SCSI_AHCI_PLAT
-
-#define CONFIG_SYS_SATA AHCI_BASE_ADDR
-
-#define CONFIG_SYS_SCSI_MAX_SCSI_ID 1
-#define CONFIG_SYS_SCSI_MAX_LUN 1
-#define CONFIG_SYS_SCSI_MAX_DEVICE (CONFIG_SYS_SCSI_MAX_SCSI_ID * \
- CONFIG_SYS_SCSI_MAX_LUN)
-
#define CONFIG_PCIE1 /* PCIE controller 1 */
#define CONFIG_PCI_SCAN_SHOW
-#define CONFIG_CMD_MEMINFO
-#define CONFIG_CMD_MEMTEST
-#define CONFIG_SYS_MEMTEST_START 0x80000000
-#define CONFIG_SYS_MEMTEST_END 0x9fffffff
-
-#define CONFIG_MISC_INIT_R
+#undef CONFIG_EXTRA_ENV_SETTINGS
+#define CONFIG_EXTRA_ENV_SETTINGS \
+ "verify=no\0" \
+ "fdt_addr=0x00f00000\0" \
+ "kernel_addr=0x01000000\0" \
+ "kernelheader_addr=0x600000\0" \
+ "scriptaddr=0x80000000\0" \
+ "scripthdraddr=0x80080000\0" \
+ "fdtheader_addr_r=0x80100000\0" \
+ "kernelheader_addr_r=0x80200000\0" \
+ "kernel_addr_r=0x96000000\0" \
+ "fdt_addr_r=0x90000000\0" \
+ "load_addr=0xa0000000\0" \
+ "kernel_size=0x2800000\0" \
+ "kernelheader_size=0x40000\0" \
+ "console=ttyS0,115200\0" \
+ BOOTENV \
+ "boot_scripts=ls1012aqds_boot.scr\0" \
+ "boot_script_hdr=hdr_ls1012aqds_bs.out\0" \
+ "scan_dev_for_boot_part=" \
+ "part list ${devtype} ${devnum} devplist; " \
+ "env exists devplist || setenv devplist 1; " \
+ "for distro_bootpart in ${devplist}; do " \
+ "if fstype ${devtype} " \
+ "${devnum}:${distro_bootpart} " \
+ "bootfstype; then " \
+ "run scan_dev_for_boot; " \
+ "fi; " \
+ "done\0" \
+ "scan_dev_for_boot=" \
+ "echo Scanning ${devtype} " \
+ "${devnum}:${distro_bootpart}...; " \
+ "for prefix in ${boot_prefixes}; do " \
+ "run scan_dev_for_scripts; " \
+ "done;" \
+ "\0" \
+ "boot_a_script=" \
+ "load ${devtype} ${devnum}:${distro_bootpart} " \
+ "${scriptaddr} ${prefix}${script}; " \
+ "env exists secureboot && load ${devtype} " \
+ "${devnum}:${distro_bootpart} " \
+ "${scripthdraddr} ${prefix}${boot_script_hdr}; " \
+ "env exists secureboot " \
+ "&& esbc_validate ${scripthdraddr};" \
+ "source ${scriptaddr}\0" \
+ "qspi_bootcmd=pfe stop; echo Trying load from qspi..;" \
+ "sf probe 0:0 && sf read $load_addr " \
+ "$kernel_addr $kernel_size; env exists secureboot " \
+ "&& sf read $kernelheader_addr_r $kernelheader_addr " \
+ "$kernelheader_size && esbc_validate ${kernelheader_addr_r}; " \
+ "bootm $load_addr#$board\0"
+
+#undef CONFIG_BOOTCOMMAND
+#ifdef CONFIG_TFABOOT
+#undef QSPI_NOR_BOOTCOMMAND
+#define QSPI_NOR_BOOTCOMMAND "pfe stop; run distro_bootcmd; run qspi_bootcmd; "\
+ "env exists secureboot && esbc_halt;"
+#else
+#define CONFIG_BOOTCOMMAND "pfe stop; run distro_bootcmd; run qspi_bootcmd; "\
+ "env exists secureboot && esbc_halt;"
+#endif
+#include <asm/fsl_secure_boot.h>
#endif /* __LS1012AQDS_H__ */