#ifndef __CONFIG_H
#define __CONFIG_H
+/*
+ * Valid values for CONFIG_SYS_TEXT_BASE are:
+ *
+ * Standard configuration - all models
+ * 0xFFF00000 boot from flash
+ *
+ * Test configuration (boot from RAM using uloader.o)
+ * LinkStation HD-HLAN and KuroBox Standard
+ * 0x03F00000 boot from RAM
+ * LinkStation HD-HGLAN and KuroBox HG
+ * 0x07F00000 boot from RAM
+ */
+#ifndef CONFIG_SYS_TEXT_BASE
+#define CONFIG_SYS_TEXT_BASE 0xFFF00000
+#endif
+
#if 0
#define DEBUG
#endif
/*-----------------------------------------------------------------------
* Ethernet stuff
*/
-#define CONFIG_NET_MULTI
#if defined(CONFIG_LAN) || defined(CONFIG_HLAN)
#define CONFIG_TULIP
#define CONFIG_SYS_FLASH_BASE 0xFFC00000
#define CONFIG_SYS_FLASH_SIZE 0x00400000
-#define CONFIG_SYS_MONITOR_BASE TEXT_BASE
+#define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_TEXT_BASE
#define CONFIG_SYS_RESET_ADDRESS 0xFFF00100
#define CONFIG_SYS_EUMB_ADDR 0x80000000
#endif
/*-----------------------------------------------------------------------
- * Change TEXT_BASE in bord/linkstation/config.mk to get a RAM build
+ * Change CONFIG_SYS_TEXT_BASE in bord/linkstation/config.mk to get a RAM build
*
* RAM based builds are for testing purposes. A Linux module, uloader.o,
* exists to load U-Boot and pass control to it
#else
#define CONFIG_SYS_INIT_RAM_ADDR 0x40000000
#endif
-#define CONFIG_SYS_INIT_RAM_END 0x1000
-#define CONFIG_SYS_GBL_DATA_SIZE 128
-#define CONFIG_SYS_GBL_DATA_OFFSET (CONFIG_SYS_INIT_RAM_END - CONFIG_SYS_GBL_DATA_SIZE)
+#define CONFIG_SYS_INIT_RAM_SIZE 0x1000
+#define CONFIG_SYS_GBL_DATA_OFFSET (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
/*----------------------------------------------------------------------
* Serial configuration
* taken from the orignal Linkstation boot code
*
* Most of the low level configuration setttings are normally used
- * in cpu/mpc824x/cpu_init.c which is NOT used by this implementation.
+ * in arch/powerpc/cpu/mpc824x/cpu_init.c which is NOT used by this implementation.
* Low level initialisation is done in board/linkstation/early_init.S
* The values below are included for reference purpose only
*/
*/
#define CONFIG_DOS_PARTITION
-/*-----------------------------------------------------------------------
- * Internal Definitions
- *
- * Boot Flags
- */
-#define BOOTFLAG_COLD 0x01 /* Normal Power-On: Boot from FLASH */
-#define BOOTFLAG_WARM 0x02 /* Software reboot */
-
#endif /* __CONFIG_H */