powerpc: Cleanup BOOTFLAG_* references

[platform/kernel/u-boot.git] / include / configs / linkstation.h

diff --git a/include/configs/linkstation.h b/include/configs/linkstation.h
index 2feb3ae..aaf663a 100644 (file)
--- a/include/configs/linkstation.h
+++ b/include/configs/linkstation.h
@@ -20,6 +20,22 @@
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
+/*
+ * Valid values for CONFIG_SYS_TEXT_BASE are:
+ *
+ * Standard configuration - all models
+ * 0xFFF00000  boot from flash
+ *
+ * Test configuration (boot from RAM using uloader.o)
+ * LinkStation HD-HLAN and KuroBox Standard
+ * 0x03F00000  boot from RAM
+ * LinkStation HD-HGLAN and KuroBox HG
+ * 0x07F00000  boot from RAM
+ */
+#ifndef CONFIG_SYS_TEXT_BASE
+#define CONFIG_SYS_TEXT_BASE   0xFFF00000
+#endif
+
 #if 0
 #define DEBUG
 #endif
@@ -96,8 +112,6 @@
 
 #define CONFIG_OF_LIBFDT       1
 
-#define OF_CPU                 "PowerPC,603e"
-#define OF_SOC                 "soc10x@80000000"
 #define OF_STDOUT_PATH         "/soc10x/serial@80004600"
 
 /* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
@@ -219,7 +233,7 @@
 
 #define CONFIG_SYS_FLASH_BASE          0xFFC00000
 #define CONFIG_SYS_FLASH_SIZE          0x00400000
-#define CONFIG_SYS_MONITOR_BASE        TEXT_BASE
+#define CONFIG_SYS_MONITOR_BASE        CONFIG_SYS_TEXT_BASE
 
 #define CONFIG_SYS_RESET_ADDRESS       0xFFF00100
 #define CONFIG_SYS_EUMB_ADDR           0x80000000
@@ -242,7 +256,7 @@
 #endif
 
 /*-----------------------------------------------------------------------
- * Change TEXT_BASE in bord/linkstation/config.mk to get a RAM build
+ * Change CONFIG_SYS_TEXT_BASE in bord/linkstation/config.mk to get a RAM build
  *
  * RAM based builds are for testing purposes. A Linux module, uloader.o,
  * exists to load U-Boot and pass control to it
@@ -292,7 +306,7 @@
  * taken from the orignal Linkstation boot code
  *
  * Most of the low level configuration setttings are normally used
- * in cpu/mpc824x/cpu_init.c which is NOT used by this implementation.
+ * in arch/powerpc/cpu/mpc824x/cpu_init.c which is NOT used by this implementation.
  * Low level initialisation is done in board/linkstation/early_init.S
  * The values below are included for reference purpose only
  */
@@ -497,12 +511,4 @@
  */
 #define CONFIG_DOS_PARTITION
 
-/*-----------------------------------------------------------------------
- * Internal Definitions
- *
- * Boot Flags
- */
-#define BOOTFLAG_COLD          0x01    /* Normal Power-On: Boot from FLASH     */
-#define BOOTFLAG_WARM          0x02    /* Software reboot                      */
-
 #endif /* __CONFIG_H */