#if defined(CONFIG_KMCOGE4)
#define CONFIG_HOSTNAME "kmcoge4"
-#define CONFIG_KM_BOARD_NAME "kmcoge4"
#else
#error ("Board not supported")
#define CONFIG_KMP204X
-#define CONFIG_KM_DEF_NETDEV "netdev=eth0\0"
-
/* an additionnal option is required for UBI as subpage access is
* supported in u-boot
*/
#define CONFIG_ENABLE_36BIT_PHYS
-#define CONFIG_ADDR_MAP
-#define CONFIG_SYS_NUM_ADDR_MAP 64 /* number of TLB1 entries */
-
#define CONFIG_POST CONFIG_SYS_POST_MEM_REGIONS /* POST memory regions test */
/*
*/
#define CONFIG_PRAM ((CONFIG_KM_PNVRAM + CONFIG_KM_PHRAM) >> 10)
-#define CONFIG_KM_CRAMFS_ADDR 0x2000000
-#define CONFIG_KM_KERNEL_ADDR 0x1000000 /* max kernel size 15.5Mbytes */
-#define CONFIG_KM_FDT_ADDR 0x1F80000 /* max dtb size 0.5Mbytes */
-
/*
* Local Bus Definitions
*/
#define CONFIG_KM_CONSOLE_TTY "ttyS0"
/* I2C */
+/* QRIO GPIOs used for deblocking */
+#define KM_I2C_DEBLOCK_PORT QRIO_GPIO_A
+#define KM_I2C_DEBLOCK_SCL 20
+#define KM_I2C_DEBLOCK_SDA 21
#define CONFIG_SYS_I2C
#define CONFIG_SYS_I2C_INIT_BOARD
#define CONFIG_SYS_QE_FMAN_FW_LENGTH 0x10000
#define CONFIG_SYS_FDT_PAD (0x3000 + CONFIG_SYS_QE_FMAN_FW_LENGTH)
-#define CONFIG_PHYLIB_10G
-
#define CONFIG_PCI_INDIRECT_BRIDGE
#define CONFIG_PCI_SCAN_SHOW /* show pci devices on startup */
* additionnal command line configuration.
*/
-/* we don't need flash support */
-#undef CONFIG_JFFS2_CMDLINE
-
/*
* For booting Linux, the board info and command line data
* have to be in the first 64 MB of memory, since this is
/*
* Environment Configuration
*/
-#define CONFIG_ENV_OVERWRITE
#ifndef CONFIG_KM_DEF_ENV /* if not set by keymile-common.h */
#define CONFIG_KM_DEF_ENV "km-common=empty\0"
#endif