km/rgmii: port Ethernet interface of KM Kirkwood boards to driver model

[platform/kernel/u-boot.git] / include / configs / km / kmp204x-common.h

diff --git a/include/configs/km/kmp204x-common.h b/include/configs/km/kmp204x-common.h
index 08e08ab..421a03e 100644 (file)
--- a/include/configs/km/kmp204x-common.h
+++ b/include/configs/km/kmp204x-common.h
@@ -39,10 +39,6 @@
 #define CONFIG_SYS_DPAA_RMAN           /* RMan */
 
 /* Environment in SPI Flash */
-#define CONFIG_ENV_SPI_BUS              0
-#define CONFIG_ENV_SPI_CS               0
-#define CONFIG_ENV_SPI_MAX_HZ           20000000
-#define CONFIG_ENV_SPI_MODE             0
 #define CONFIG_ENV_OFFSET               0x100000       /* 1MB for u-boot */
 #define CONFIG_ENV_SIZE                        0x004000        /* 16K env */
 #define CONFIG_ENV_SECT_SIZE            0x010000
@@ -94,7 +90,6 @@ unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_CHIP_SELECTS_PER_CTRL   (4 * CONFIG_DIMM_SLOTS_PER_CTLR)
 
 #define CONFIG_DDR_SPD
-#define CONFIG_FSL_DDR_INTERACTIVE
 
 #define CONFIG_SYS_SPD_BUS_NUM 0
 #define SPD_EEPROM_ADDRESS     0x54
@@ -118,21 +113,10 @@ unsigned long get_board_sys_clk(unsigned long dummy);
 
 /* size of rootfs in RAM */
 #define CONFIG_KM_ROOTFSSIZE   0x0
-/* pseudo-non volatile RAM [hex] */
-#define CONFIG_KM_PNVRAM       0x80000
-/* physical RAM MTD size [hex] */
-#define CONFIG_KM_PHRAM                0x100000
-/* reserved pram area at the end of memory [hex]
- * u-boot reserves some memory for the MP boot page */
-#define CONFIG_KM_RESERVED_PRAM        0x1000
 /* set the default PRAM value to at least PNVRAM + PHRAM when pram env variable
  * is not valid yet, which is the case for when u-boot copies itself to RAM */
 #define CONFIG_PRAM            ((CONFIG_KM_PNVRAM + CONFIG_KM_PHRAM)>>10)
 
-#define CONFIG_KM_CRAMFS_ADDR  0x2000000
-#define CONFIG_KM_KERNEL_ADDR  0x1000000       /* max kernel size 15.5Mbytes */
-#define CONFIG_KM_FDT_ADDR     0x1F80000       /* max dtb    size  0.5Mbytes */
-
 /*
  * Local Bus Definitions
  */
@@ -222,8 +206,6 @@ unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_SYS_NS16550_COM3        (CONFIG_SYS_CCSRBAR+0x11D500)
 #define CONFIG_SYS_NS16550_COM4        (CONFIG_SYS_CCSRBAR+0x11D600)
 
-#define CONFIG_KM_CONSOLE_TTY  "ttyS0"
-
 /* I2C */
 
 #define CONFIG_SYS_I2C
@@ -248,14 +230,9 @@ int get_sda(void);
 int get_scl(void);
 #endif
 
-#define CONFIG_KM_IVM_BUS              1       /* I2C1 (Mux-Port 1)*/
-
 /*
  * eSPI - Enhanced SPI
  */
-#define CONFIG_SPI_FLASH_BAR   /* 4 byte-addressing */
-#define CONFIG_SF_DEFAULT_SPEED         20000000
-#define CONFIG_SF_DEFAULT_MODE          0
 
 /*
  * General PCI
@@ -314,12 +291,10 @@ int get_scl(void);
  * env is stored at 0x100000, sector size is 0x10000, x2 (redundant)
  * ucode is stored after env, so we got 0x120000.
  */
-#define CONFIG_SYS_QE_FW_IN_SPIFLASH
 #define CONFIG_SYS_FMAN_FW_ADDR        0x120000
 #define CONFIG_SYS_QE_FMAN_FW_LENGTH   0x10000
 #define CONFIG_SYS_FDT_PAD             (0x3000 + CONFIG_SYS_QE_FMAN_FW_LENGTH)
 
-#define CONFIG_FMAN_ENET
 #define CONFIG_PHYLIB_10G
 
 #define CONFIG_PCI_INDIRECT_BRIDGE
@@ -350,7 +325,6 @@ int get_scl(void);
  */
 
 /* we don't need flash support */
-#undef CONFIG_FLASH_CFI_MTD
 #undef CONFIG_JFFS2_CMDLINE
 
 /*