/* SPL Loader Configuration */
#if defined(CONFIG_TARGET_J721E_A72_EVM) || defined(CONFIG_TARGET_J7200_A72_EVM)
-#define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SPL_TEXT_BASE + SZ_4M)
#define CONFIG_SYS_UBOOT_BASE 0x50280000
/* Image load address in RAM for DFU boot*/
#else
#define CONFIG_SYS_UBOOT_BASE 0x50080000
-/*
- * Maximum size in memory allocated to the SPL BSS. Keep it as tight as
- * possible (to allow the build to go through), as this directly affects
- * our memory footprint. The less we use for BSS the more we have available
- * for everything else.
- */
-#define CONFIG_SPL_BSS_MAX_SIZE 0xA000
-/*
- * Link BSS to be within SPL in a dedicated region located near the top of
- * the MCU SRAM, this way making it available also before relocation. Note
- * that we are not using the actual top of the MCU SRAM as there is a memory
- * location filled in by the boot ROM that we want to read out without any
- * interference from the C context.
- */
-#define CONFIG_SPL_BSS_START_ADDR (CONFIG_SYS_K3_BOOT_PARAM_TABLE_INDEX -\
- CONFIG_SPL_BSS_MAX_SIZE)
-/* Set the stack right below the SPL BSS section */
-#define CONFIG_SYS_INIT_SP_ADDR CONFIG_SPL_BSS_START_ADDR
-/* Configure R5 SPL post-relocation malloc pool in DDR */
-#define CONFIG_SYS_SPL_MALLOC_START 0x84000000
-#define CONFIG_SYS_SPL_MALLOC_SIZE SZ_16M
-/* Image load address in RAM for DFU boot*/
#endif
-#ifdef CONFIG_SYS_K3_SPL_ATF
-#define CONFIG_SPL_FS_LOAD_PAYLOAD_NAME "tispl.bin"
-#endif
-
-#define CONFIG_SPL_MAX_SIZE CONFIG_SYS_K3_MAX_DOWNLODABLE_IMAGE_SIZE
-
#define CONFIG_SYS_BOOTM_LEN SZ_64M
/* HyperFlash related configuration */
projects / platform / kernel / u-boot.git / blobdiff