* Common ARM Integrator configuration settings
*/
-#define CONFIG_SYS_TIMERBASE 0x13000100 /* Timer1 */
-
-/*
- * There are various dependencies on the core module (CM) fitted
- * Users should refer to their CM user guide
- */
-#include "armcoremodule.h"
-
-/*
- * Initialize and remap the core module, use SPD to detect memory size
- * If CONFIG_SKIP_LOWLEVEL_INIT is not defined &
- * the core module has a CM_INIT register
- * then the U-Boot initialisation code will
- * e.g. ARM Boot Monitor or pre-loader is repeated once
- * (to re-initialise any existing CM_INIT settings to safe values).
- *
- * This is usually not the desired behaviour since the platform
- * will either reboot into the ARM monitor (or pre-loader)
- * or continuously cycle thru it without U-Boot running,
- * depending upon the setting of Integrator/CP switch S2-4.
- *
- * However it may be needed if Integrator/CP switch S2-1
- * is set OFF to boot direct into U-Boot.
- * In that case comment out the line below.
- */
-#define CONFIG_CM_INIT
-#define CONFIG_CM_REMAP
-#define CONFIG_CM_SPD_DETECT
+#define CFG_SYS_TIMERBASE 0x13000100 /* Timer1 */
/*
* The ARM boot monitor initializes the board.
*/
#define PHYS_SDRAM_1 0x00000000 /* SDRAM Bank #1 */
#define PHYS_SDRAM_1_SIZE 0x08000000 /* 128 MB */
-#define CONFIG_SYS_SDRAM_BASE PHYS_SDRAM_1
-#define CONFIG_SYS_INIT_RAM_SIZE PHYS_SDRAM_1_SIZE
-#define CONFIG_SYS_GBL_DATA_OFFSET (CONFIG_SYS_SDRAM_BASE + \
- CONFIG_SYS_INIT_RAM_SIZE - \
- GENERATED_GBL_DATA_SIZE)
-#define CONFIG_SYS_INIT_SP_ADDR CONFIG_SYS_GBL_DATA_OFFSET
+#define CFG_SYS_SDRAM_BASE PHYS_SDRAM_1
/*
* FLASH and environment organization
* - SIB block
* - U-Boot environment
*/
-#define CONFIG_SYS_FLASH_BASE 0x24000000
-#define CONFIG_SYS_MAX_FLASH_BANKS 1
+#define CFG_SYS_FLASH_BASE 0x24000000
/* Timeout values in ticks */
-#define CONFIG_SYS_FLASH_ERASE_TOUT (2 * CONFIG_SYS_HZ) /* Erase Timeout */
-#define CONFIG_SYS_FLASH_WRITE_TOUT (2 * CONFIG_SYS_HZ) /* Write Timeout */
-#define CONFIG_SYS_FLASH_EMPTY_INFO /* flinfo indicates empty blocks */