#define __IMX7_SPL_CONFIG_H
#ifdef CONFIG_SPL
-/*
- * see figure 6-22 in i.MX 7Dual/Solo Reference manuals:
- * - IMX7D/S OCRAM free area RAM (OCRAM) is from 0x00910000 to
- * 0x00946C00.
- * - Set the stack at the end of the free area section, at 0x00946BB8.
- * - The BOOT ROM loads what they consider the firmware image
- * which consists of a 4K header in front of us that contains the IVT, DCD
- * and some padding thus 'our' max size is really 0x00946BB8 - 0x00911000.
- * 64KB is more then enough for the SPL.
- */
-#define CONFIG_SPL_TEXT_BASE 0x00911000
-#define CONFIG_SPL_MAX_SIZE 0x10000
-#define CONFIG_SPL_STACK 0x00946BB8
-/*
- * Pad SPL to 68KB (4KB header + 64KB max size). This allows to write the
- * SPL/U-Boot combination generated with u-boot-with-spl.imx directly to a
- * boot media (given that boot media specific offset is configured properly).
- */
-#define CONFIG_SPL_PAD_TO 0x11000
/* MMC support */
-#if defined(CONFIG_SPL_MMC_SUPPORT)
-#define CONFIG_SYS_MMCSD_FS_BOOT_PARTITION 1
+#if defined(CONFIG_SPL_MMC)
#define CONFIG_SYS_MONITOR_LEN 409600 /* 400 KB */
#endif
-/* Define the payload for FAT/EXT support */
-#if defined(CONFIG_SPL_FS_FAT) || defined(CONFIG_SPL_EXT_SUPPORT)
-# ifdef CONFIG_OF_CONTROL
-# define CONFIG_SPL_FS_LOAD_PAYLOAD_NAME "u-boot-dtb.img"
-# else
-# define CONFIG_SPL_FS_LOAD_PAYLOAD_NAME "u-boot.img"
-# endif
-#endif
-
-#define CONFIG_SPL_BSS_START_ADDR 0x88200000
-#define CONFIG_SPL_BSS_MAX_SIZE 0x100000 /* 1 MB */
-#define CONFIG_SYS_SPL_MALLOC_START 0x88300000
-#define CONFIG_SYS_SPL_MALLOC_SIZE 0x100000 /* 1 MB */
-
#endif /* CONFIG_SPL */
#endif /* __IMX7_SPL_CONFIG_H */