Makefile: move all Power Architecture boards into boards.cfg

[platform/kernel/u-boot.git] / include / configs / ep8248.h

diff --git a/include/configs/ep8248.h b/include/configs/ep8248.h
index f7b3fde..1576533 100644 (file)
--- a/include/configs/ep8248.h
+++ b/include/configs/ep8248.h
@@ -31,6 +31,8 @@
 
 #define CONFIG_EP8248                  /* Embedded Planet EP8248 board */
 
+#define        CONFIG_SYS_TEXT_BASE    0xFFF00000
+
 #define CONFIG_BOARD_EARLY_INIT_F 1    /* Call board_early_init_f      */
 
 /* Allow serial number (serial#) and MAC address (ethaddr) to be overwritten */
@@ -50,50 +52,41 @@
 
 #define CONFIG_SYS_BCSR                0xFA000000
 
-/*
- * Select ethernet configuration
- *
- * If either CONFIG_ETHER_ON_SCC or CONFIG_ETHER_ON_FCC is selected,
- * then CONFIG_ETHER_INDEX must be set to the channel number (1-4 for
- * SCC, 1-3 for FCC)
- *
- * If CONFIG_ETHER_NONE is defined, then either the ethernet routines
- * must be defined elsewhere (as for the console), or CONFIG_CMD_NET
- * must be unset.
- */
+/* Pass open firmware flat device tree */
+#define CONFIG_OF_LIBFDT       1
+#define CONFIG_OF_BOARD_SETUP  1
+
+#define OF_TBCLK        (bd->bi_busfreq / 4)
+#define OF_STDOUT_PATH  "/soc/cpm/serial <at> 11a80"
+
+/* Select ethernet configuration */
 #undef CONFIG_ETHER_ON_SCC             /* Ethernet is not on SCC */
 #define CONFIG_ETHER_ON_FCC            /* Ethernet is on FCC     */
 #undef CONFIG_ETHER_NONE               /* No external Ethernet   */
 
-#ifdef CONFIG_ETHER_ON_FCC
-
-#define CONFIG_ETHER_INDEX     1       /* FCC1 is used for Ethernet */
-
-#if   (CONFIG_ETHER_INDEX == 1)
+#define CONFIG_NET_MULTI
+#define CONFIG_SYS_CPMFCR_RAMTYPE      0
+#define CONFIG_SYS_FCC_PSMR            (FCC_PSMR_FDE | FCC_PSMR_LPB)
 
+#define CONFIG_HAS_ETH0
+#define CONFIG_ETHER_ON_FCC1           1
 /* - Rx clock is CLK10
  * - Tx clock is CLK11
  * - BDs/buffers on 60x bus
  * - Full duplex
  */
-#define CONFIG_SYS_CMXFCR_MASK (CMXFCR_FC1 | CMXFCR_RF1CS_MSK | CMXFCR_TF1CS_MSK)
-#define CONFIG_SYS_CMXFCR_VALUE        (CMXFCR_RF1CS_CLK10 | CMXFCR_TF1CS_CLK11)
-#define CONFIG_SYS_CPMFCR_RAMTYPE      0
-#define CONFIG_SYS_FCC_PSMR            (FCC_PSMR_FDE | FCC_PSMR_LPB)
-
-#elif (CONFIG_ETHER_INDEX == 2)
+#define CONFIG_SYS_CMXFCR_MASK1        (CMXFCR_FC1 | CMXFCR_RF1CS_MSK | CMXFCR_TF1CS_MSK)
+#define CONFIG_SYS_CMXFCR_VALUE1       (CMXFCR_RF1CS_CLK10 | CMXFCR_TF1CS_CLK11)
 
+#define CONFIG_HAS_ETH1
+#define CONFIG_ETHER_ON_FCC2           1
 /* - Rx clock is CLK13
  * - Tx clock is CLK14
  * - BDs/buffers on 60x bus
  * - Full duplex
  */
-#define CONFIG_SYS_CMXFCR_MASK (CMXFCR_FC2 | CMXFCR_RF2CS_MSK | CMXFCR_TF2CS_MSK)
-#define CONFIG_SYS_CMXFCR_VALUE        (CMXFCR_RF2CS_CLK13 | CMXFCR_TF2CS_CLK14)
-#define CONFIG_SYS_CPMFCR_RAMTYPE      0
-#define CONFIG_SYS_FCC_PSMR            (FCC_PSMR_FDE | FCC_PSMR_LPB)
-
-#endif /* CONFIG_ETHER_INDEX */
+#define CONFIG_SYS_CMXFCR_MASK2        (CMXFCR_FC2 | CMXFCR_RF2CS_MSK | CMXFCR_TF2CS_MSK)
+#define CONFIG_SYS_CMXFCR_VALUE2       (CMXFCR_RF2CS_CLK13 | CMXFCR_TF2CS_CLK14)
 
 #define CONFIG_MII                     /* MII PHY management        */
 #define CONFIG_BITBANGMII              /* Bit-banged MDIO interface */
@@ -101,6 +94,7 @@
  * GPIO pins used for bit-banged MII communications
  */
 #define MDIO_PORT              0       /* Not used - implemented in BCSR */
+
 #define MDIO_ACTIVE            (*(vu_char *)(CONFIG_SYS_BCSR + 8) &= 0xFB)
 #define MDIO_TRISTATE          (*(vu_char *)(CONFIG_SYS_BCSR + 8) |= 0x04)
 #define MDIO_READ              (*(vu_char *)(CONFIG_SYS_BCSR + 8) & 1)
@@ -113,8 +107,6 @@
 
 #define MIIDELAY               udelay(1)
 
-#endif /* CONFIG_ETHER_ON_FCC */
-
 #ifndef CONFIG_8260_CLKIN
 #define CONFIG_8260_CLKIN      66000000        /* in Hz */
 #endif
@@ -207,7 +199,7 @@
 #define CONFIG_SYS_I2C_SLAVE           0x7F    /* I2C slave address            */
 #endif
 
-#define CONFIG_SYS_MONITOR_BASE        TEXT_BASE
+#define CONFIG_SYS_MONITOR_BASE        CONFIG_SYS_TEXT_BASE
 #if (CONFIG_SYS_MONITOR_BASE < CONFIG_SYS_FLASH_BASE)
 #define CONFIG_SYS_RAMBOOT
 #endif