/* auto boot */
-/*
- * For booting Linux, the board info and command line data
- * have to be in the first 8 MB of memory, since this is
- * the maximum mapped by the Linux kernel during initialization.
- */
-#define CONFIG_CMDLINE_TAG 1 /* enable passing of ATAGs */
-#define CONFIG_INITRD_TAG 1 /* enable INITRD tag */
-#define CONFIG_SETUP_MEMORY_TAGS 1 /* enable memory tag */
-
#define CONFIG_SYS_CBSIZE 1024 /* Console I/O Buff Size */
-/*
- * Commands configuration
- */
/*
* Network
#define CONFIG_SKIP_LOCAL_MAC_RANDOMIZATION /* don't randomize MAC */
#define CONFIG_PHY_BASE_ADR 0x8
#define CONFIG_RESET_PHY_R /* use reset_phy() to init mv8831116 PHY */
-#define CONFIG_NETCONSOLE /* include NetConsole support */
#define CONFIG_SYS_FAULT_ECHO_LINK_DOWN /* detect link using phy */
-#define CONFIG_ENV_OVERWRITE /* ethaddr can be reprogrammed */
#endif
/*
*/
#ifdef CONFIG_IDE
#define __io
-#define CONFIG_IDE_PREINIT
-/* ED Mini V has an IDE-compatible SATA connector for port 1 */
-#define CONFIG_MVSATA_IDE_USE_PORT1
/* Needs byte-swapping for ATA data register */
#define CONFIG_IDE_SWAP_IO
/* Data, registers and alternate blocks are at the same offset */
* I2C related stuff
*/
#ifdef CONFIG_CMD_I2C
-#define CONFIG_SYS_I2C
-#define CONFIG_SYS_I2C_MVTWSI
#define CONFIG_I2C_MVTWSI_BASE0 ORION5X_TWSI_BASE
-#define CONFIG_SYS_I2C_SLAVE 0x0
-#define CONFIG_SYS_I2C_SPEED 100000
#endif
/*
*/
/*
- * Size of malloc() pool
- */
-#define CONFIG_SYS_MALLOC_LEN (1024 * 256) /* 256kB for malloc() */
-
-/*
* Other required minimal configurations
*/
-#define CONFIG_SYS_LOAD_ADDR 0x00800000
-#define CONFIG_SYS_MEMTEST_START 0x00400000
-#define CONFIG_SYS_MEMTEST_END 0x007fffff
#define CONFIG_SYS_RESET_ADDRESS 0xffff0000
/* Enable command line editing */