* bottom (processor) board MUST be removed!
*/
#undef CONFIG_WATCHDOG
-#undef CONFIG_HW_WATCHDOG
+#define CONFIG_HW_WATCHDOG
/*-----------------------------------------------------------------------
* Serial Configuration
*/
#define CONFIG_SERIAL_MULTI
-#undef CONFIG_SERIAL_SOFTWARE_FIFO
#define CONFIG_CONS_INDEX 1
#define CONFIG_SYS_NS16550
#define CONFIG_SYS_NS16550_SERIAL
#define CONFIG_CMD_LOADS /* loads */
#define CONFIG_CMD_MEMORY /* md mm nm mw cp cmp crc base loop mtest */
#define CONFIG_CMD_MISC /* Misc functions like sleep etc*/
-#undef CONFIG_CMD_NET /* bootp, tftpboot, rarpboot */
+#define CONFIG_CMD_NET /* bootp, tftpboot, rarpboot */
#undef CONFIG_CMD_NFS /* NFS support */
#define CONFIG_CMD_PCI /* PCI support */
+#define CONFIG_CMD_PING /* ICMP echo support */
#define CONFIG_CMD_RUN /* run command in env variable */
#define CONFIG_CMD_SAVEENV /* saveenv */
#define CONFIG_CMD_SETGETDCR /* DCR support on 4xx */
#define CONFIG_SYS_LOAD_ADDR 0x100000 /* default load address */
-#define CONFIG_SYS_HZ 1024 /* incrementer freq: 1kHz */
+#define CONFIG_SYS_HZ 1000 /* incrementer freq: 1kHz */
/*-----------------------------------------------------------------------
* SDRAM Configuration
* CPU Features
*/
#define CONFIG_SYS_SC520_HIGH_SPEED 0 /* 100 or 133MHz */
-#undef CONFIG_SYS_SC520_RESET /* use SC520 MMCR's to reset cpu */
+#define CONFIG_SYS_SC520_RESET /* use SC520 MMCR's to reset cpu */
#define CONFIG_SYS_SC520_TIMER /* use SC520 swtimers */
#undef CONFIG_SYS_GENERIC_TIMER /* use the i8254 PIT timers */
#undef CONFIG_SYS_TSC_TIMER /* use the Pentium TSC timers */
#define CONFIG_SYS_THIRD_PCI_IRQ 11
#define CONFIG_SYS_FORTH_PCI_IRQ 15
-/*-----------------------------------------------------------------------
- * Hardware watchdog configuration
+ /*
+ * Network device (TRL8100B) support
*/
-#define CONFIG_SYS_WATCHDOG_PIO_BIT 0x8000
-#define CONFIG_SYS_WATCHDIG_PIO_DATA SC520_PIODATA15_0
-#define CONFIG_SYS_WATCHDIG_PIO_CLR SC520_PIOCLR15_0
-#define CONFIG_SYS_WATCHDIG_PIO_SET SC520_PIOSET15_0
+#define CONFIG_NET_MULTI
+#define CONFIG_RTL8139
/*-----------------------------------------------------------------------
* FPGA configuration