powerpc, 8xx: remove support for 8xx

[platform/kernel/u-boot.git] / include / configs / digsy_mtc.h

diff --git a/include/configs/digsy_mtc.h b/include/configs/digsy_mtc.h
index 71068a8..6710507 100644 (file)
--- a/include/configs/digsy_mtc.h
+++ b/include/configs/digsy_mtc.h
@@ -85,14 +85,6 @@
 /*
  * Command line configuration.
  */
-#ifdef CONFIG_VIDEO
-#define CONFIG_CMD_BMP
-#endif
-#define CONFIG_CMD_DATE
-#define CONFIG_CMD_DIAG
-#define CONFIG_CMD_EEPROM
-#define CONFIG_CMD_IDE
-#define CONFIG_CMD_IRQ
 #define CONFIG_CMD_PCI
 #define CONFIG_CMD_REGINFO
 #define CONFIG_CMD_SAVES
@@ -211,36 +203,6 @@
 #define CONFIG_BOOTCOMMAND     "run mtcb_start"
 
 /*
- * I2C configuration
- */
-#define CONFIG_HARD_I2C                1
-#define CONFIG_SYS_I2C_MODULE  1
-#define CONFIG_SYS_I2C_SPEED   100000
-#define CONFIG_SYS_I2C_SLAVE   0x7F
-
-/*
- * EEPROM configuration
- */
-#define CONFIG_SYS_I2C_EEPROM_ADDR             0x50    /* 1010000x */
-#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN         1
-#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS      3
-#define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS  70
-
-/*
- * RTC configuration
- */
-#if defined(CONFIG_DIGSY_REV5)
-#define CONFIG_SYS_I2C_RTC_ADDR        0x56
-#define CONFIG_RTC_RV3029
-/* Enable 5k Ohm trickle charge resistor */
-#define CONFIG_SYS_RV3029_TCR  0x20
-#else
-#define CONFIG_RTC_DS1337
-#define CONFIG_SYS_I2C_RTC_ADDR        0x68
-#define CONFIG_SYS_DS1339_TCR_VAL      0xAB    /* diode + 4k resistor */
-#endif
-
-/*
  * Flash configuration
  */
 #define        CONFIG_SYS_FLASH_CFI            1