disk: convert CONFIG_DOS_PARTITION to Kconfig

[platform/kernel/u-boot.git] / include / configs / devkit3250.h

diff --git a/include/configs/devkit3250.h b/include/configs/devkit3250.h
index 99d9148..2f3a20e 100644 (file)
--- a/include/configs/devkit3250.h
+++ b/include/configs/devkit3250.h
@@ -24,7 +24,6 @@
 #if !defined(CONFIG_SPL_BUILD)
 #define CONFIG_SKIP_LOWLEVEL_INIT
 #endif
-#define CONFIG_BOARD_EARLY_INIT_F
 
 /*
  * Memory configurations
@@ -61,7 +60,6 @@
 #define CONFIG_SYS_I2C
 #define CONFIG_SYS_I2C_LPC32XX
 #define CONFIG_SYS_I2C_SPEED           100000
-#define CONFIG_CMD_I2C
 
 /*
  * GPIO
@@ -73,7 +71,6 @@
  */
 #define CONFIG_LPC32XX_SSP
 #define CONFIG_LPC32XX_SSP_TIMEOUT     100000
-#define CONFIG_CMD_SPI
 
 /*
  * Ethernet
@@ -84,9 +81,6 @@
 #define CONFIG_PHYLIB
 #define CONFIG_PHY_ADDR                        0x1F
 #define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
-#define CONFIG_CMD_MII
-#define CONFIG_CMD_PING
-#define CONFIG_CMD_DHCP
 
 /*
  * NOR Flash
@@ -129,9 +123,6 @@
  */
 #define CONFIG_USB_OHCI_LPC32XX
 #define CONFIG_USB_ISP1301_I2C_ADDR            0x2d
-#define CONFIG_USB_STORAGE
-#define CONFIG_CMD_FAT
-#define CONFIG_CMD_USB
 
 /*
  * U-Boot General Configurations
@@ -145,14 +136,10 @@
 
 #define CONFIG_AUTO_COMPLETE
 #define CONFIG_CMDLINE_EDITING
-#define CONFIG_VERSION_VARIABLE
-#define CONFIG_DISPLAY_CPUINFO
-#define CONFIG_DOS_PARTITION
 
 /*
  * Pass open firmware flat tree
  */
-#define CONFIG_OF_LIBFDT
 
 /*
  * Environment
@@ -180,15 +167,12 @@
 /*
  * U-Boot Commands
  */
-#define CONFIG_CMD_CACHE
 
 /*
  * Boot Linux
  */
 #define CONFIG_CMDLINE_TAG
 #define CONFIG_SETUP_MEMORY_TAGS
-#define CONFIG_ZERO_BOOTDELAY_CHECK
-#define CONFIG_BOOTDELAY               1
 
 #define CONFIG_BOOTFILE                        "uImage"
 #define CONFIG_BOOTARGS                        "console=ttyS0,115200n8"
@@ -206,16 +190,12 @@
 
 /* Use the framework and generic lib */
 #define CONFIG_SPL_FRAMEWORK
-#define CONFIG_SPL_LIBGENERIC_SUPPORT
-#define CONFIG_SPL_LIBCOMMON_SUPPORT
 
 /* SPL will use serial */
-#define CONFIG_SPL_SERIAL_SUPPORT
 
 /* SPL loads an image from NAND */
 #define CONFIG_SPL_NAND_SIMPLE
 #define CONFIG_SPL_NAND_RAW_ONLY
-#define CONFIG_SPL_NAND_SUPPORT
 #define CONFIG_SPL_NAND_DRIVERS
 
 #define CONFIG_SPL_NAND_ECC