+/* SPDX-License-Identifier: GPL-2.0+ */
/*
* Copyright (C) 2010 Texas Instruments Incorporated - http://www.ti.com/
*
* Based on davinci_dvevm.h. Original Copyrights follow:
*
* Copyright (C) 2007 Sergey Kubushyn <ksi@koi8.net>
- *
- * SPDX-License-Identifier: GPL-2.0+
*/
#ifndef __CONFIG_H
/*
* Board
*/
-#define CONFIG_DRIVER_TI_EMAC
/* check if direct NOR boot config is used */
#ifndef CONFIG_DIRECT_NOR_BOOT
#define CONFIG_USE_SPIFLASH
#endif
/*
+* Disable DM_* for SPL build and can be re-enabled after adding
+* DM support in SPL
+*/
+#ifdef CONFIG_SPL_BUILD
+#undef CONFIG_DM_I2C
+#undef CONFIG_DM_I2C_COMPAT
+#endif
+/*
* SoC Configuration
*/
-#define CONFIG_MACH_DAVINCI_DA850_EVM
-#define CONFIG_SOC_DA8XX /* TI DA8xx SoC */
-#define CONFIG_SOC_DA850 /* TI DA850 SoC */
#define CONFIG_SYS_EXCEPTION_VECTORS_HIGH
#define CONFIG_SYS_CLK_FREQ clk_get(DAVINCI_ARM_CLKID)
#define CONFIG_SYS_OSCIN_FREQ 24000000
#define CONFIG_SYS_TIMERBASE DAVINCI_TIMER0_BASE
#define CONFIG_SYS_HZ_CLOCK clk_get(DAVINCI_AUXCLK_CLKID)
+#define CONFIG_SKIP_LOWLEVEL_INIT
#ifdef CONFIG_DIRECT_NOR_BOOT
#define CONFIG_ARCH_CPU_INIT
-#define CONFIG_DA8XX_GPIO
-#define CONFIG_SYS_TEXT_BASE 0x60000000
#define CONFIG_SYS_DV_NOR_BOOT_CFG (0x11)
-#define CONFIG_DA850_LOWLEVEL
-#else
-#define CONFIG_SYS_TEXT_BASE 0xc1080000
#endif
/*
#define PHYS_SDRAM_1 DAVINCI_DDR_EMIF_DATA_BASE /* DDR Start */
#define PHYS_SDRAM_1_SIZE (64 << 20) /* SDRAM size 64MB */
#define CONFIG_MAX_RAM_BANK_SIZE (512 << 20) /* max size from SPRS586*/
-
+#define CONFIG_SPL_BSS_START_ADDR DAVINCI_DDR_EMIF_DATA_BASE
+#define CONFIG_SPL_BSS_MAX_SIZE 0x1080000
/* memtest start addr */
#define CONFIG_SYS_MEMTEST_START (PHYS_SDRAM_1 + 0x2000000)
/* memtest will be run on 16MB */
#define CONFIG_SYS_MEMTEST_END (PHYS_SDRAM_1 + 0x2000000 + 16*1024*1024)
-#define CONFIG_NR_DRAM_BANKS 1 /* we have 1 bank of DRAM */
-
#define CONFIG_SYS_DA850_SYSCFG_SUSPSRC ( \
DAVINCI_SYSCFG_SUSPSRC_TIMER0 | \
DAVINCI_SYSCFG_SUSPSRC_SPI1 | \
/*
* PLL configuration
*/
-#define CONFIG_SYS_DV_CLKMODE 0
-#define CONFIG_SYS_DA850_PLL0_POSTDIV 1
-#define CONFIG_SYS_DA850_PLL0_PLLDIV1 0x8000
-#define CONFIG_SYS_DA850_PLL0_PLLDIV2 0x8001
-#define CONFIG_SYS_DA850_PLL0_PLLDIV3 0x8002
-#define CONFIG_SYS_DA850_PLL0_PLLDIV4 0x8003
-#define CONFIG_SYS_DA850_PLL0_PLLDIV5 0x8002
-#define CONFIG_SYS_DA850_PLL0_PLLDIV6 CONFIG_SYS_DA850_PLL0_PLLDIV1
-#define CONFIG_SYS_DA850_PLL0_PLLDIV7 0x8005
-
-#define CONFIG_SYS_DA850_PLL1_POSTDIV 1
-#define CONFIG_SYS_DA850_PLL1_PLLDIV1 0x8000
-#define CONFIG_SYS_DA850_PLL1_PLLDIV2 0x8001
-#define CONFIG_SYS_DA850_PLL1_PLLDIV3 0x8002
#define CONFIG_SYS_DA850_PLL0_PLLM 24
#define CONFIG_SYS_DA850_PLL1_PLLM 21
/*
* Serial Driver info
*/
+
+#if !CONFIG_IS_ENABLED(DM_SERIAL)
#define CONFIG_SYS_NS16550_SERIAL
-#define CONFIG_SYS_NS16550_REG_SIZE -4 /* NS16550 register size */
#define CONFIG_SYS_NS16550_COM1 DAVINCI_UART2_BASE /* Base address of UART2 */
+#endif
#define CONFIG_SYS_NS16550_CLK clk_get(DAVINCI_UART2_CLKID)
-#define CONFIG_CONS_INDEX 1 /* use UART0 for console */
-#define CONFIG_SPI
-#define CONFIG_DAVINCI_SPI
-#define CONFIG_SYS_SPI_BASE DAVINCI_SPI1_BASE
#define CONFIG_SYS_SPI_CLK clk_get(DAVINCI_SPI1_CLKID)
-#define CONFIG_SF_DEFAULT_SPEED 30000000
-#define CONFIG_ENV_SPI_MAX_HZ CONFIG_SF_DEFAULT_SPEED
+#ifdef CONFIG_SPL_BUILD
+#define CONFIG_SYS_SPI_BASE DAVINCI_SPI1_BASE
+#endif
#ifdef CONFIG_USE_SPIFLASH
-#define CONFIG_SPL_SPI_LOAD
#define CONFIG_SYS_SPI_U_BOOT_OFFS 0x8000
#define CONFIG_SYS_SPI_U_BOOT_SIZE 0x40000
#endif
/*
* I2C Configuration
*/
-#define CONFIG_SYS_I2C
-#define CONFIG_SYS_I2C_DAVINCI
-#define CONFIG_SYS_DAVINCI_I2C_SPEED 25000
-#define CONFIG_SYS_DAVINCI_I2C_SLAVE 10 /* Bogus, master-only in U-Boot */
+#ifndef CONFIG_SPL_BUILD
#define CONFIG_SYS_I2C_EXPANDER_ADDR 0x20
+#endif
/*
* Flash & Environment
*/
-#ifdef CONFIG_USE_NAND
-#define CONFIG_NAND_DAVINCI
+#ifdef CONFIG_NAND
+#ifdef CONFIG_ENV_IS_IN_NAND
#define CONFIG_ENV_OFFSET 0x0 /* Block 0--not used by bootcode */
#define CONFIG_ENV_SIZE (128 << 10)
+#define CONFIG_ENV_SECT_SIZE (128 << 10)
+#endif
#define CONFIG_SYS_NAND_USE_FLASH_BBT
#define CONFIG_SYS_NAND_4BIT_HW_ECC_OOBFIRST
#define CONFIG_SYS_NAND_PAGE_2K
#define CONFIG_SYS_NAND_5_ADDR_CYCLE
#define CONFIG_SYS_NAND_PAGE_SIZE (2 << 10)
#define CONFIG_SYS_NAND_BLOCK_SIZE (128 << 10)
-#define CONFIG_SYS_NAND_U_BOOT_OFFS 0x28000
-#define CONFIG_SYS_NAND_U_BOOT_SIZE 0x60000
+#define CONFIG_SYS_NAND_U_BOOT_SIZE 0x40000
#define CONFIG_SYS_NAND_U_BOOT_DST 0xc1080000
#define CONFIG_SYS_NAND_U_BOOT_START CONFIG_SYS_NAND_U_BOOT_DST
#define CONFIG_SYS_NAND_U_BOOT_RELOC_SP (CONFIG_SYS_NAND_U_BOOT_DST - \
#define CONFIG_SPL_NAND_BASE
#define CONFIG_SPL_NAND_DRIVERS
#define CONFIG_SPL_NAND_ECC
-#define CONFIG_SPL_NAND_SIMPLE
#define CONFIG_SPL_NAND_LOAD
#endif
* Network & Ethernet Configuration
*/
#ifdef CONFIG_DRIVER_TI_EMAC
-#define CONFIG_MII
-#define CONFIG_BOOTP_DNS
#define CONFIG_BOOTP_DNS2
#define CONFIG_BOOTP_SEND_HOSTNAME
#define CONFIG_NET_RETRY_COUNT 10
#endif
#ifdef CONFIG_USE_NOR
-#define CONFIG_FLASH_CFI_DRIVER
-#define CONFIG_SYS_FLASH_CFI
-#define CONFIG_SYS_FLASH_PROTECTION
#define CONFIG_SYS_MAX_FLASH_BANKS 1 /* max number of flash banks */
#define CONFIG_SYS_FLASH_SECT_SZ (128 << 10) /* 128KB */
#define CONFIG_ENV_OFFSET (CONFIG_SYS_FLASH_SECT_SZ * 3)
#endif
#ifdef CONFIG_USE_SPIFLASH
+#ifdef CONFIG_ENV_IS_IN_SPI_FLASH
#define CONFIG_ENV_SIZE (64 << 10)
#define CONFIG_ENV_OFFSET (512 << 10)
-#define CONFIG_ENV_SECT_SIZE (64 << 10)
+#define CONFIG_ENV_SECT_SIZE (64 << 10)
+#endif
+#ifdef CONFIG_SPL_BUILD
+#undef CONFIG_SPI_FLASH_MTD
+#endif
#endif
/*
* U-Boot general configuration
*/
-#define CONFIG_MISC_INIT_R
#define CONFIG_BOOTFILE "uImage" /* Boot file name */
#define CONFIG_SYS_CBSIZE 1024 /* Console I/O Buffer Size */
#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot Args Buffer Size */
#define CONFIG_SYS_LOAD_ADDR (PHYS_SDRAM_1 + 0x700000)
-#define CONFIG_AUTO_COMPLETE
-#define CONFIG_CMDLINE_EDITING
-#define CONFIG_SYS_LONGHELP
#define CONFIG_MX_CYCLIC
/*
#define CONFIG_CMDLINE_TAG
#define CONFIG_REVISION_TAG
#define CONFIG_SETUP_MEMORY_TAGS
-#define CONFIG_EXTRA_ENV_SETTINGS "hwconfig=dsp:wake=yes"
+
+#define CONFIG_BOOTCOMMAND \
+ "run envboot; " \
+ "run mmcboot; "
+
+#define DEFAULT_LINUX_BOOT_ENV \
+ "loadaddr=0xc0700000\0" \
+ "fdtaddr=0xc0600000\0" \
+ "scriptaddr=0xc0600000\0"
+
+#include <environment/ti/mmc.h>
+
+#define CONFIG_EXTRA_ENV_SETTINGS \
+ DEFAULT_LINUX_BOOT_ENV \
+ DEFAULT_MMC_TI_ARGS \
+ "bootpart=0:2\0" \
+ "bootdir=/boot\0" \
+ "bootfile=zImage\0" \
+ "fdtfile=da850-evm.dtb\0" \
+ "boot_fdt=yes\0" \
+ "boot_fit=0\0" \
+ "console=ttyS2,115200n8\0" \
+ "hwconfig=dsp:wake=yes"
#ifdef CONFIG_CMD_BDI
#define CONFIG_CLOCKS
#endif
-#ifndef CONFIG_DRIVER_TI_EMAC
-#endif
-
-#ifdef CONFIG_USE_NAND
-#define CONFIG_MTD_DEVICE
-#define CONFIG_MTD_PARTITIONS
-#endif
-
-#ifdef CONFIG_USE_SPIFLASH
-#endif
-
-#if !defined(CONFIG_USE_NAND) && \
+#if !defined(CONFIG_NAND) && \
!defined(CONFIG_USE_NOR) && \
!defined(CONFIG_USE_SPIFLASH)
#define CONFIG_ENV_SIZE (16 << 10)
#ifndef CONFIG_DIRECT_NOR_BOOT
/* defines for SPL */
-#define CONFIG_SPL_FRAMEWORK
#define CONFIG_SYS_SPL_MALLOC_START (CONFIG_SYS_TEXT_BASE - \
CONFIG_SYS_MALLOC_LEN)
#define CONFIG_SYS_SPL_MALLOC_SIZE CONFIG_SYS_MALLOC_LEN
-#define CONFIG_SPL_SPI_LOAD
#define CONFIG_SPL_STACK 0x8001ff00
-#define CONFIG_SPL_TEXT_BASE 0x80000000
#define CONFIG_SPL_MAX_FOOTPRINT 32768
#define CONFIG_SPL_PAD_TO 32768
#endif
/* Load U-Boot Image From MMC */
-#ifdef CONFIG_SPL_MMC_LOAD
-#undef CONFIG_SPL_SPI_LOAD
-#endif
/* additions for new relocation code, must added to all boards */
#define CONFIG_SYS_SDRAM_BASE 0xc0000000
projects / platform / kernel / u-boot.git / blobdiff