#define CONFIG_MCFUART
#define CONFIG_SYS_UART_PORT (0)
-#define CONFIG_BAUDRATE 19200
/* ---
* set "#if 0" to "#if 1" if (Hardware)-WATCHDOG should be enabled & change
#ifndef CONFIG_MONITOR_IS_IN_RAM
#define CONFIG_ENV_OFFSET 0x4000
#define CONFIG_ENV_SECT_SIZE 0x2000
-#define CONFIG_ENV_IS_IN_FLASH 1
#else
#define CONFIG_ENV_ADDR 0xffe04000
#define CONFIG_ENV_SECT_SIZE 0x2000
-#define CONFIG_ENV_IS_IN_FLASH 1
#endif
#define LDS_BOARD_TEXT \
- . = DEFINED(env_offset) ? env_offset : .; \
- common/env_embedded.o (.text);
+ . = DEFINED(env_offset) ? env_offset : .; \
+ env/embedded.o(.text);
/*
* BOOTP options
/*AUTOBOOT settings - booting images automatically by u-boot after power on*/
-seconds u-boot will wait before starting defined (auto-)boot command, setting
-to -1 disables delay, setting to 0 will too prevent access to u-boot command
-interface: u-boot then has to reflashed */
-
/* The following settings will be contained in the environment block ; if you
want to use a neutral environment all those settings can be manually set in
u-boot: 'set' command */
#define CONFIG_BOOTCOMMAND "bootm 0xffe80000" /*Autoboto command, please
enter a valid image address in flash */
-#define CONFIG_BOOTARGS " " /* default bootargs that are
-considered during boot */
-
/* User network settings */
#define CONFIG_IPADDR 192.168.100.2 /* default board IP address */