* Although the default iss 64, we still define it
* to be on the safe side once the default is changed.
*/
-#define CONFIG_SYS_CACHELINE_SIZE 64
#define CONFIG_EMIF4 /* The chip has EMIF4 controller */
#define CONFIG_MISC_INIT_R
-#define CONFIG_OF_LIBFDT
/*
* The early kernel mapping on ARM currently only maps from the base of DRAM
* to the end of the kernel image. The kernel is loaded at DRAM base + 0x8000.
#define CONFIG_OMAP_EHCI_PHY1_RESET_GPIO 146
#define CONFIG_OMAP_EHCI_PHY2_RESET_GPIO 147
#else /* !CONFIG_USB_MUSB_AM35X */
-#define CONFIG_USB_MUSB_HOST
#define CONFIG_USB_MUSB_PIO_ONLY
#endif /* CONFIG_USB_MUSB_AM35X */
-#define CONFIG_USB_STORAGE
-#define CONFIG_CMD_USB
-
/* commands to include */
-#define CONFIG_CMD_CACHE
-#define CONFIG_CMD_EXT2 /* EXT2 Support */
-#define CONFIG_CMD_FAT /* FAT support */
#define CONFIG_CMD_MTDPARTS /* Enable MTD parts commands */
#define CONFIG_MTD_DEVICE /* needed for mtdparts commands */
#define CONFIG_MTD_PARTITIONS
"1920k(u-boot),256k(u-boot-env),"\
"4m(kernel),-(fs)"
-#define CONFIG_CMD_I2C /* I2C serial bus support */
-#define CONFIG_CMD_MMC /* MMC support */
#define CONFIG_CMD_NAND /* NAND support */
-#define CONFIG_CMD_DHCP
-#define CONFIG_CMD_PING
-
#define CONFIG_SYS_NO_FLASH
#define CONFIG_SYS_I2C
/* devices */
/* Environment information */
-#define CONFIG_BOOTDELAY 3
-#define CONFIG_ZERO_BOOTDELAY_CHECK
-
#define CONFIG_EXTRA_ENV_SETTINGS \
"loadaddr=0x82000000\0" \
"baudrate=115200\0" \
"nand read ${loadaddr} 2a0000 400000; " \
"bootm ${loadaddr}\0" \
-#define CONFIG_CMD_BOOTZ
#define CONFIG_BOOTCOMMAND \
"mmc dev ${mmcdev}; if mmc rescan; then " \
"if run loadbootscript; then " \
#define CONFIG_TIMESTAMP
#define CONFIG_SYS_AUTOLOAD "no"
#define CONFIG_SYS_LONGHELP /* undef to save memory */
-#define CONFIG_SYS_HUSH_PARSER /* use "hush" command parser */
#define CONFIG_SYS_CBSIZE 512 /* Console I/O Buffer Size */
/* Print Buffer Size */
#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE + \
#define CONFIG_OMAP3_SPI
+/* EEPROM */
+#define CONFIG_CMD_EEPROM
+#define CONFIG_ENV_EEPROM_IS_ON_I2C
+#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
+#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 4
+#define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
+#define CONFIG_SYS_EEPROM_SIZE 256
+
+#define CONFIG_CMD_EEPROM_LAYOUT
+#define CONFIG_EEPROM_LAYOUT_HELP_STRING "v1, v2, v3"
+
#endif /* __CONFIG_H */