Kconfig: Migrate CONFIG_BAUDRATE

[platform/kernel/u-boot.git] / include / configs / cm_t35.h

diff --git a/include/configs/cm_t35.h b/include/configs/cm_t35.h
index 201711d..8e6571b 100644 (file)
--- a/include/configs/cm_t35.h
+++ b/include/configs/cm_t35.h
@@ -25,11 +25,6 @@
 #define CONFIG_OMAP    /* in a TI OMAP core */
 #define CONFIG_OMAP_GPIO
 #define CONFIG_CM_T3X  /* working with CM-T35 and CM-T3730 */
-#define CONFIG_OMAP_COMMON
-/* Common ARM Erratas */
-#define CONFIG_ARM_ERRATA_454179
-#define CONFIG_ARM_ERRATA_430973
-#define CONFIG_ARM_ERRATA_621766
 
 #define CONFIG_SDRC    /* The chip has SDRC controller */
 
@@ -77,15 +72,9 @@
 
 /* allow to overwrite serial and ethaddr */
 #define CONFIG_ENV_OVERWRITE
-#define CONFIG_BAUDRATE                        115200
 #define CONFIG_SYS_BAUDRATE_TABLE      {4800, 9600, 19200, 38400, 57600,\
                                        115200}
 
-#define CONFIG_GENERIC_MMC
-#define CONFIG_MMC
-#define CONFIG_OMAP_HSMMC
-#define CONFIG_DOS_PARTITION
-
 /* USB */
 #define CONFIG_USB_OMAP3
 #define CONFIG_USB_EHCI
@@ -108,7 +97,6 @@
 
 #define CONFIG_CMD_NAND                /* NAND support                 */
 
-#define CONFIG_SYS_NO_FLASH
 #define CONFIG_SYS_I2C
 #define CONFIG_SYS_OMAP24_I2C_SPEED    100000
 #define CONFIG_SYS_OMAP24_I2C_SLAVE    1
@@ -257,20 +245,12 @@
                                         GENERATED_GBL_DATA_SIZE)
 
 /* Status LED */
-#define CONFIG_STATUS_LED              /* Status LED enabled */
-#define CONFIG_BOARD_SPECIFIC_LED
-#define CONFIG_GPIO_LED
 #define GREEN_LED_GPIO                 186 /* CM-T35 Green LED is GPIO186 */
-#define GREEN_LED_DEV                  0
-#define STATUS_LED_BIT                 GREEN_LED_GPIO
-#define STATUS_LED_STATE               STATUS_LED_ON
-#define STATUS_LED_PERIOD              (CONFIG_SYS_HZ / 2)
-#define STATUS_LED_BOOT                        GREEN_LED_DEV
 
 #define CONFIG_SPLASHIMAGE_GUARD
 
 /* GPIO banks */
-#ifdef CONFIG_STATUS_LED
+#ifdef CONFIG_LED_STATUS
 #define CONFIG_OMAP3_GPIO_6    /* GPIO186 is in GPIO bank 6  */
 #endif
 
@@ -300,7 +280,7 @@
 #define CONFIG_SPL_NAND_DRIVERS
 #define CONFIG_SPL_NAND_ECC
 #define CONFIG_SPL_OMAP3_ID_NAND
-#define CONFIG_SPL_LDSCRIPT            "$(CPUDIR)/omap-common/u-boot-spl.lds"
+#define CONFIG_SPL_LDSCRIPT            "arch/arm/mach-omap2/u-boot-spl.lds"
 
 /* NAND boot config */
 #define CONFIG_SYS_NAND_5_ADDR_CYCLE