#define CONFIG_MAX_RAM_BANK_SIZE (1024 << 20) /* 1GB */
/* Timer information */
-#define CONFIG_SYS_PTV 2 /* Divisor: 2^(PTV+1) => 8 */
#define CONFIG_SYS_TIMERBASE 0x48040000 /* Use Timer2 */
-#define CONFIG_POWER_TPS65217
#include <asm/arch/omap.h>
* Y-MODEM to load u-boot.img, when booted over UART. We must also include
* the scratch space that U-Boot uses in SRAM.
*/
-#define CONFIG_SPL_MAX_SIZE (SRAM_SCRATCH_SPACE_ADDR - \
- CONFIG_SPL_TEXT_BASE)
/*
* Since SPL did pll and ddr initialization for us,
* we don't need to do it twice.
*/
-#if !defined(CONFIG_SPL_BUILD) && !defined(CONFIG_NOR_BOOT)
-#define CONFIG_SKIP_LOWLEVEL_INIT
-#endif /* !CONFIG_SPL_BUILD, ... */
-/*
- * Our DDR memory always starts at 0x80000000 and U-Boot shall have
- * relocated itself to higher in memory by the time this value is used.
- */
-#define CONFIG_SYS_LOAD_ADDR 0x80000000
/*
* ----------------------------------------------------------------------------
* DDR information. We say (for simplicity) that we have 1 bank,
* and we place the initial stack pointer in our SRAM.
*/
#define CONFIG_SYS_SDRAM_BASE 0x80000000
-#define CONFIG_SYS_INIT_SP_ADDR (NON_SECURE_SRAM_END - \
- GENERATED_GBL_DATA_SIZE)
/*
* Our platforms make use of SPL to initalize the hardware (primarily
*
* ----------------------------------------------------------------------------
*/
-#define CONFIG_SPL_BSS_START_ADDR 0x80A00000
-#define CONFIG_SPL_BSS_MAX_SIZE 0x80000 /* 512 KB */
-#define CONFIG_SYS_SPL_MALLOC_START (CONFIG_SPL_BSS_START_ADDR + \
- CONFIG_SPL_BSS_MAX_SIZE)
-#define CONFIG_SYS_SPL_MALLOC_SIZE CONFIG_SYS_MALLOC_LEN
/* General parts of the framework, required. */