/*
- * U-boot - Configuration file for BF533 STAMP board
+ * U-Boot - Configuration file for BF533 STAMP board
*/
#ifndef __CONFIG_BF533_STAMP_H__
#include <asm/config-pre.h>
-
/*
* Processor Settings
*/
#define CONFIG_SYS_MONITOR_LEN (256 * 1024)
#define CONFIG_SYS_MALLOC_LEN (384 * 1024)
-
/*
* Network Settings
*/
SSYNC(); \
} while (0)
#define CONFIG_HOSTNAME bf533-stamp
-/* Uncomment next line to use fixed MAC address */
-/* #define CONFIG_ETHADDR 02:80:ad:20:31:b8 */
-
/* I2C */
#define CONFIG_SYS_I2C
#define CONFIG_ENV_SPI_MAX_HZ 30000000
/*
#define CONFIG_SF_DEFAULT_SPEED 30000000
-#define CONFIG_SPI_FLASH
#define CONFIG_SPI_FLASH_ALL
*/
common/env_embedded.o (.text*);
#endif
-
/*
* I2C Settings
*/
/* #define CONFIG_STAMP_CF */
#if defined(CONFIG_STAMP_CF)
#define CONFIG_MISC_INIT_R
-#define CONFIG_DOS_PARTITION 1
#undef CONFIG_IDE_8xx_DIRECT /* no pcmcia interface required */
#undef CONFIG_IDE_LED /* no led for ide supported */
#undef CONFIG_IDE_RESET /* no reset for ide supported */
#define CONFIG_EBIU_AMBCTL1_VAL 0x99B3ffc2
#endif
-
/*
* Misc Settings
*/
#define CONFIG_RTC_BFIN
#define CONFIG_UART_CONSOLE 0
-#define CONFIG_CC_OPTIMIZE_LIBS_FOR_SPEED
/* FLASH/ETHERNET uses the same async bank */
#define SHARED_RESOURCES 1
/* #define CONFIG_SHOW_BOOT_PROGRESS */
/* define to enable run status via led */
-/* #define CONFIG_STATUS_LED */
-#ifdef CONFIG_STATUS_LED
-#define CONFIG_GPIO_LED
-#define CONFIG_BOARD_SPECIFIC_LED
-/* use LED0 to indicate booting/alive */
-#define STATUS_LED_BOOT 0
-#define STATUS_LED_BIT GPIO_PF2
-#define STATUS_LED_STATE STATUS_LED_ON
-#define STATUS_LED_PERIOD (CONFIG_SYS_HZ / 4)
-/* use LED1 to indicate crash */
-#define STATUS_LED_CRASH 1
-#define STATUS_LED_BIT1 GPIO_PF3
-#define STATUS_LED_STATE1 STATUS_LED_ON
-#define STATUS_LED_PERIOD1 (CONFIG_SYS_HZ / 2)
-/* #define STATUS_LED_BIT2 GPIO_PF4 */
-#endif
/* define to enable splash screen support */
-/* #define CONFIG_VIDEO */
-
/*
* Pull in common ADI header for remaining command/environment setup