/* CPU, chip, mach, etc */
#define CONFIG_KONA
#define CONFIG_SKIP_LOWLEVEL_INIT
-#define CONFIG_SYS_GENERIC_BOARD
/*
* Memory configuration
#define CONFIG_NR_DRAM_BANKS 1
#define CONFIG_SYS_MALLOC_LEN SZ_4M /* see armv7/start.S. */
-#define CONFIG_STACKSIZE SZ_256K
/* GPIO Driver */
#define CONFIG_KONA_GPIO
/* MMC/SD Driver */
-#define CONFIG_SDHCI
-#define CONFIG_MMC_SDMA
-#define CONFIG_KONA_SDHCI
-#define CONFIG_MMC
-#define CONFIG_GENERIC_MMC
-
#define CONFIG_SYS_SDIO_BASE0 SDIO1_BASE_ADDR
#define CONFIG_SYS_SDIO_BASE1 SDIO2_BASE_ADDR
#define CONFIG_SYS_SDIO_BASE2 SDIO3_BASE_ADDR
#define CONFIG_SYS_LOAD_ADDR CONFIG_SYS_SDRAM_BASE
/* No mtest functions as recommended */
-#undef CONFIG_CMD_MEMORY
/*
* This is the initial SP which is used only briefly for relocating the u-boot
#define CONFIG_SYS_INIT_SP_ADDR CONFIG_SYS_TEXT_BASE
/* Serial Info */
-#define CONFIG_SYS_NS16550
#define CONFIG_SYS_NS16550_SERIAL
/* Post pad 3 bytes after each reg addr */
#define CONFIG_SYS_NS16550_REG_SIZE (-4)
#define CONFIG_CONS_INDEX 1
#define CONFIG_SYS_NS16550_COM1 0x3e000000
-#define CONFIG_BAUDRATE 115200
-
-#define CONFIG_ENV_SIZE 0x10000
-#define CONFIG_ENV_IS_NOWHERE
-
-#define CONFIG_SYS_NO_FLASH /* Not using NAND/NOR unmanaged flash */
+/* must fit into GPT:u-boot-env partition */
+#define CONFIG_ENV_IS_IN_MMC
+#define CONFIG_SYS_MMC_ENV_DEV 0
+#define CONFIG_ENV_OFFSET (0x00011a00 * 512)
+#define CONFIG_ENV_SIZE (8 * 512)
/* console configuration */
#define CONFIG_SYS_CBSIZE 1024 /* Console buffer size */
* This is necessary for the fatls command to work on an SD card
* for example.
*/
-#define CONFIG_DOS_PARTITION
/* version string, parser, etc */
-#define CONFIG_VERSION_VARIABLE
#define CONFIG_AUTO_COMPLETE
-#define CONFIG_SYS_HUSH_PARSER
#define CONFIG_CMDLINE_EDITING
#define CONFIG_SYS_LONGHELP
-#define CONFIG_CRC32_VERIFY
#define CONFIG_MX_CYCLIC
/* Initial upstream - boot to cmd prompt only */
#define CONFIG_BOOTCOMMAND ""
-/* Commands */
-#include <config_cmd_default.h>
-#define CONFIG_CMD_ASKENV
-#define CONFIG_CMD_CACHE
-#define CONFIG_CMD_FAT
-#define CONFIG_CMD_GPIO
-#define CONFIG_CMD_I2C
-#define CONFIG_CMD_MMC
-#define CONFIG_CMD_BOOTZ
-#define CONFIG_FAT_WRITE
-
-#undef CONFIG_CMD_NFS
+#define CONFIG_USBID_ADDR 0x34052c46
#endif /* __BCM28155_AP_H */