#define CONFIG_ASTRO5373L /* define board type */
/* Command line configuration */
-#include <config_cmd_default.h>
-
/*
* CONFIG_RAM defines if u-boot is loaded via BDM (or started from
* a different bootloader that has already performed RAM setup) or
#define ENABLE_JFFS 1
#endif
-/* Define which commmands should be available at u-boot command prompt */
+/* Define which commands should be available at u-boot command prompt */
-#define CONFIG_CMD_CACHE
#define CONFIG_CMD_DATE
-#define CONFIG_CMD_ELF
-#define CONFIG_CMD_FLASH
-#define CONFIG_CMD_I2C
-#define CONFIG_CMD_MEMORY
-#define CONFIG_CMD_MISC
-#define CONFIG_CMD_XIMG
-#undef CONFIG_CMD_NET
-#undef CONFIG_CMD_NFS
#if ENABLE_JFFS
#define CONFIG_CMD_JFFS2
#endif
#define CONFIG_CMD_REGINFO
-#define CONFIG_CMD_LOADS
-#define CONFIG_CMD_LOADB
-#define CONFIG_CMD_FPGA
#define CONFIG_CMD_FPGA_LOADMK
#define CONFIG_CMDLINE_EDITING
-#define CONFIG_SYS_HUSH_PARSER
-
#define CONFIG_MCFRTC
#undef RTC_DEBUG
/* AUTOBOOT settings - booting images automatically by u-boot after power on */
/*
- * used for autoboot, delay in seconds u-boot will wait before starting
- * defined (auto-)boot command, setting to -1 disables delay, setting to
- * 0 will too prevent access to u-boot command interface: u-boot then has
- * to be reflashed
- * beware - watchdog is not serviced during autoboot delay time!
- */
-#ifdef CONFIG_MONITOR_IS_IN_RAM
-#define CONFIG_BOOTDELAY 1
-#else
-#define CONFIG_BOOTDELAY 1
-#endif
-
-/*
* The following settings will be contained in the environment block ; if you
* want to use a neutral environment all those settings can be manually set in
* u-boot: 'set' command
#define CONFIG_BOOTARGS " console=ttyS2,115200 rootfstype=romfs"\
" loaderversion=$loaderversion"
-#define CONFIG_SYS_PROMPT "URMEL > "
-
/* default RAM address for user programs */
#define CONFIG_SYS_LOAD_ADDR 0x20000