/* Define which commands should be available at u-boot command prompt */
-#define CONFIG_CMD_DATE
-#if ENABLE_JFFS
-#define CONFIG_CMD_JFFS2
-#endif
#define CONFIG_CMD_REGINFO
-#define CONFIG_CMD_FPGA_LOADMK
#define CONFIG_CMDLINE_EDITING
#define CONFIG_MCFRTC
* in u-boot command interface
*/
-#define CONFIG_BAUDRATE 115200
-
#define CONFIG_MCFUART
#define CONFIG_SYS_UART_PORT (2)
#define CONFIG_SYS_UART2_ALT3_GPIO
/* AUTOBOOT settings - booting images automatically by u-boot after power on */
/*
- * used for autoboot, delay in seconds u-boot will wait before starting
- * defined (auto-)boot command, setting to -1 disables delay, setting to
- * 0 will too prevent access to u-boot command interface: u-boot then has
- * to be reflashed
- * beware - watchdog is not serviced during autoboot delay time!
- */
-#ifdef CONFIG_MONITOR_IS_IN_RAM
-#define CONFIG_BOOTDELAY 1
-#else
-#define CONFIG_BOOTDELAY 1
-#endif
-
-/*
* The following settings will be contained in the environment block ; if you
* want to use a neutral environment all those settings can be manually set in
* u-boot: 'set' command