#include "tegra124-common.h"
-#define CONFIG_ARCH_MISC_INIT
-
/* Board-specific serial config */
#define CONFIG_TEGRA_ENABLE_UARTA
#define CONFIG_SYS_NS16550_COM1 NV_PA_APB_UARTA_BASE
-/* SD/MMC support */
-#define CONFIG_SUPPORT_EMMC_BOOT /* eMMC specific */
-
-/* Environment in eMMC, before config block at the end of 1st "boot sector" */
-#define CONFIG_ENV_OFFSET (-CONFIG_ENV_SIZE + \
- CONFIG_TDX_CFG_BLOCK_OFFSET)
-#define CONFIG_SYS_MMC_ENV_DEV 0
-#define CONFIG_SYS_MMC_ENV_PART 1
+#define FDT_MODULE "apalis-v1.2"
+#define FDT_MODULE_V1_0 "apalis"
/* PCI host support */
#undef CONFIG_PCI_SCAN_SHOW
#define CONFIG_E1000_NO_NVM
/* General networking support */
-#define CONFIG_IP_DEFRAG
-#define CONFIG_TFTP_BLOCKSIZE 16352
#define CONFIG_TFTP_TSIZE
+/*
+ * Custom Distro Boot configuration:
+ * 1. 8bit SD port (MMC1)
+ * 2. 4bit SD port (MMC2)
+ * 3. eMMC (MMC0)
+ */
+#define BOOT_TARGET_DEVICES(func) \
+ func(MMC, mmc, 1) \
+ func(MMC, mmc, 2) \
+ func(MMC, mmc, 0) \
+ func(USB, usb, 0) \
+ func(PXE, pxe, na) \
+ func(DHCP, dhcp, na)
+
#undef CONFIG_IPADDR
#define CONFIG_IPADDR 192.168.10.2
#define CONFIG_NETMASK 255.255.255.0
#define DFU_ALT_EMMC_INFO "apalis-tk1.img raw 0x0 0x500 mmcpart 1; " \
"boot part 0 1 mmcpart 0; " \
"rootfs part 0 2 mmcpart 0; " \
- "uImage fat 0 1 mmcpart 0; " \
+ "zImage fat 0 1 mmcpart 0; " \
"tegra124-apalis-eval.dtb fat 0 1 mmcpart 0"
-#define EMMC_BOOTCMD \
- "emmcargs=ip=off root=/dev/mmcblk0p2 rw rootfstype=ext3 rootwait\0" \
- "emmcboot=run setup; setenv bootargs ${defargs} ${emmcargs} " \
- "${setupargs} ${vidargs}; echo Booting from internal eMMC " \
- "chip...; run emmcdtbload; load mmc 0:1 ${kernel_addr_r} " \
- "${boot_file} && run fdt_fixup && " \
- "bootm ${kernel_addr_r} - ${dtbparam}\0" \
- "emmcdtbload=setenv dtbparam; load mmc 0:1 ${fdt_addr_r} " \
- "${soc}-apalis-${fdt_board}.dtb && " \
- "setenv dtbparam ${fdt_addr_r}\0"
+#define UBOOT_UPDATE \
+ "uboot_hwpart=1\0" \
+ "uboot_blk=0\0" \
+ "set_blkcnt=setexpr blkcnt ${filesize} + 0x1ff && " \
+ "setexpr blkcnt ${blkcnt} / 0x200\0" \
+ "update_uboot=run set_blkcnt && mmc dev 0 ${uboot_hwpart} && " \
+ "mmc write ${loadaddr} ${uboot_blk} ${blkcnt}\0" \
#define NFS_BOOTCMD \
"nfsargs=ip=:::::eth0:on root=/dev/nfs rw\0" \
"nfsboot=pci enum; run setup; setenv bootargs ${defargs} ${nfsargs} " \
"${setupargs} ${vidargs}; echo Booting via DHCP/TFTP/NFS...; " \
"run nfsdtbload; dhcp ${kernel_addr_r} " \
- "&& run fdt_fixup && bootm ${kernel_addr_r} - ${dtbparam}\0" \
+ "&& run fdt_fixup && bootz ${kernel_addr_r} - ${dtbparam}\0" \
"nfsdtbload=setenv dtbparam; tftp ${fdt_addr_r} " \
- "${soc}-apalis-${fdt_board}.dtb " \
- "&& setenv dtbparam ${fdt_addr_r}\0"
-
-#define SD_BOOTCMD \
- "sdargs=ip=off root=/dev/mmcblk1p2 rw rootfstype=ext4 rootwait\0" \
- "sdboot=run setup; setenv bootargs ${defargs} ${sdargs} ${setupargs} " \
- "${vidargs}; echo Booting from SD card in 8bit slot...; " \
- "run sddtbload; load mmc 1:1 ${kernel_addr_r} " \
- "${boot_file} && run fdt_fixup && " \
- "bootm ${kernel_addr_r} - ${dtbparam}\0" \
- "sddtbload=setenv dtbparam; load mmc 1:1 ${fdt_addr_r} " \
- "${soc}-apalis-${fdt_board}.dtb " \
- "&& setenv dtbparam ${fdt_addr_r}\0"
-
-#define USB_BOOTCMD \
- "usbargs=ip=off root=/dev/sda2 rw rootfstype=ext4 rootwait\0" \
- "usbboot=run setup; setenv bootargs ${defargs} ${setupargs} " \
- "${usbargs} ${vidargs}; echo Booting from USB stick...; " \
- "usb start && run usbdtbload; load usb 0:1 ${kernel_addr_r} " \
- "${boot_file} && run fdt_fixup && " \
- "bootm ${kernel_addr_r} - ${dtbparam}\0" \
- "usbdtbload=setenv dtbparam; load usb 0:1 ${fdt_addr_r} " \
- "${soc}-apalis-${fdt_board}.dtb " \
+ "${soc}-${fdt_module}-${fdt_board}.dtb " \
"&& setenv dtbparam ${fdt_addr_r}\0"
#define BOARD_EXTRA_ENV_SETTINGS \
- "boot_file=uImage\0" \
+ "boot_file=zImage\0" \
"console=ttyS0\0" \
"defargs=lp0_vec=2064@0xf46ff000 core_edp_mv=1150 core_edp_ma=4000 " \
- "usb_port_owner_info=2 lane_owner_info=6 emc_max_dvfs=0\0" \
+ "usb_port_owner_info=2 lane_owner_info=6 emc_max_dvfs=0 " \
+ "user_debug=30 pcie_aspm=off\0" \
"dfu_alt_info=" DFU_ALT_EMMC_INFO "\0" \
- EMMC_BOOTCMD \
"fdt_board=eval\0" \
"fdt_fixup=;\0" \
+ "fdt_module=" FDT_MODULE "\0" \
NFS_BOOTCMD \
- SD_BOOTCMD \
+ UBOOT_UPDATE \
"setethupdate=if env exists ethaddr; then; else setenv ethaddr " \
"00:14:2d:00:00:00; fi; pci enum && tftpboot ${loadaddr} " \
"flash_eth.img && source ${loadaddr}\0" \
"setusbupdate=usb start && setenv interface usb; setenv drive 0; " \
"load ${interface} ${drive}:1 ${loadaddr} flash_blk.img && " \
"source ${loadaddr}\0" \
- USB_BOOTCMD \
- "vidargs=video=tegrafb0:640x480-16@60 fbcon=map:1\0"
+ "vidargs=fbcon=map:1\0"
/* Increase console I/O buffer size */
#undef CONFIG_SYS_CBSIZE
#undef CONFIG_SYS_MAXARGS
#define CONFIG_SYS_MAXARGS 32
-#define CONFIG_CMD_TIME
-
-#define CONFIG_SYS_BOOT_RAMDISK_HIGH
-
#include "tegra-common-usb-gadget.h"
#include "tegra-common-post.h"
projects / platform / kernel / u-boot.git / blobdiff