pci: introduce CONFIG_PCI_INDIRECT_BRIDGE option

[platform/kernel/u-boot.git] / include / configs / alpr.h

diff --git a/include/configs/alpr.h b/include/configs/alpr.h
index 74a0781..d93d5e2 100644 (file)
--- a/include/configs/alpr.h
+++ b/include/configs/alpr.h
@@ -64,10 +64,9 @@
 #define CONFIG_SYS_TEMP_STACK_OCM  1
 #define CONFIG_SYS_OCM_DATA_ADDR   CONFIG_SYS_ISRAM_BASE
 #define CONFIG_SYS_INIT_RAM_ADDR   CONFIG_SYS_ISRAM_BASE  /* Initial RAM address       */
-#define CONFIG_SYS_INIT_RAM_END    0x2000          /* End of used area in RAM  */
-#define CONFIG_SYS_GBL_DATA_SIZE   128             /* num bytes initial data   */
+#define CONFIG_SYS_INIT_RAM_SIZE    0x2000         /* Size of used area in RAM */
 
-#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_END - CONFIG_SYS_GBL_DATA_SIZE)
+#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 #define CONFIG_SYS_INIT_SP_OFFSET      (CONFIG_SYS_GBL_DATA_OFFSET - 0x4)
 
 #define CONFIG_SYS_MONITOR_LEN     (256 * 1024)    /* Reserve 256 kB for Mon   */
@@ -207,7 +206,6 @@
 
 #define CONFIG_PPC4xx_EMAC
 #define CONFIG_MII             1       /* MII PHY management           */
-#define CONFIG_NET_MULTI       1
 #define CONFIG_PHY_ADDR                0x02    /* dummy setting, no EMAC0 used */
 #define CONFIG_PHY1_ADDR       0x03    /* dummy setting, no EMAC1 used */
 #define CONFIG_PHY2_ADDR       0x01    /* PHY address for EMAC2        */
@@ -289,6 +287,7 @@
  */
 /* General PCI */
 #define CONFIG_PCI                     /* include pci support          */
+#define CONFIG_PCI_INDIRECT_BRIDGE     /* indirect PCI bridge support */
 #define CONFIG_PCI_PNP                 /* do pci plug-and-play         */
 #define CONFIG_PCI_SCAN_SHOW           /* show pci devices on startup  */
 #define CONFIG_SYS_PCI_TARGBASE    0x80000000  /* PCIaddr mapped to CONFIG_SYS_PCI_MEMBASE */
@@ -365,14 +364,6 @@
  */
 #define CONFIG_SYS_BOOTMAPSZ           (8 << 20)       /* Initial Memory map for Linux */
 
-/*
- * Internal Definitions
- *
- * Boot Flags
- */
-#define BOOTFLAG_COLD  0x01            /* Normal Power-On: Boot from FLASH     */
-#define BOOTFLAG_WARM  0x02            /* Software reboot                      */
-
 #if defined(CONFIG_CMD_KGDB)
 #define CONFIG_KGDB_BAUDRATE   230400  /* speed to run kgdb serial port */
 #define CONFIG_KGDB_SER_INDEX  2       /* which serial port to use */