#ifndef __CONFIG_H
#define __CONFIG_H
+#define CONFIG_ADS5121 1
/*
* Memory map for the ADS5121 board:
*
*/
#define CONFIG_E300 1 /* E300 Family */
#define CONFIG_MPC512X 1 /* MPC512X family */
+#define CONFIG_FSL_DIU_FB 1 /* FSL DIU */
+
+/* video */
+#undef CONFIG_VIDEO
+
+#if defined(CONFIG_VIDEO)
+#define CONFIG_CFB_CONSOLE
+#define CONFIG_VGA_AS_SINGLE_DEVICE
+#endif
/* CONFIG_PCI is defined at config time */
+#ifdef CONFIG_ADS5121_REV2
#define CFG_MPC512X_CLKIN 66000000 /* in Hz */
+#else
+#define CFG_MPC512X_CLKIN 33333333 /* in Hz */
+#define CONFIG_PCI
+#endif
#define CONFIG_BOARD_EARLY_INIT_F /* call board_early_init_f() */
+#define CONFIG_MISC_INIT_R
#define CFG_IMMR 0x80000000
+#define CFG_DIU_ADDR (CFG_IMMR+0x2100)
#define CFG_MEMTEST_START 0x00200000 /* memtest region */
#define CFG_MEMTEST_END 0x00400000
/*
* DDR Setup - manually set all parameters as there's no SPD etc.
*/
+#ifdef CONFIG_ADS5121_REV2
#define CFG_DDR_SIZE 256 /* MB */
+#else
+#define CFG_DDR_SIZE 512 /* MB */
+#endif
#define CFG_DDR_BASE 0x00000000 /* DDR is system memory*/
#define CFG_SDRAM_BASE CFG_DDR_BASE
* [09:05] DRAM tRP:
* [04:00] DRAM tRPA
*/
-
+#ifdef CONFIG_ADS5121_REV2
#define CFG_MDDRC_SYS_CFG 0xF8604A00
#define CFG_MDDRC_SYS_CFG_RUN 0xE8604A00
+#define CFG_MDDRC_TIME_CFG1 0x54EC1168
+#define CFG_MDDRC_TIME_CFG2 0x35210864
+#else
+#define CFG_MDDRC_SYS_CFG 0xFA804A00
+#define CFG_MDDRC_SYS_CFG_RUN 0xEA804A00
+#define CFG_MDDRC_TIME_CFG1 0x68EC1168
+#define CFG_MDDRC_TIME_CFG2 0x34310864
+#endif
#define CFG_MDDRC_SYS_CFG_EN 0xF0000000
#define CFG_MDDRC_TIME_CFG0 0x00003D2E
#define CFG_MDDRC_TIME_CFG0_RUN 0x06183D2E
-#define CFG_MDDRC_TIME_CFG1 0x54EC1168
-#define CFG_MDDRC_TIME_CFG2 0x35210864
#define CFG_MICRON_NOP 0x01380000
#define CFG_MICRON_PCHG_ALL 0x01100400
#define CFG_MICRON_OCD_DEFAULT 0x01010780
/* DDR Priority Manager Configuration */
-#define CFG_MDDRCGRP_PM_CFG1 0x000777AA
-#define CFG_MDDRCGRP_PM_CFG2 0x00000055
-#define CFG_MDDRCGRP_HIPRIO_CFG 0x00000000
-#define CFG_MDDRCGRP_LUT0_MU 0x11111117
-#define CFG_MDDRCGRP_LUT0_ML 0x7777777A
-#define CFG_MDDRCGRP_LUT1_MU 0x4444EEEE
-#define CFG_MDDRCGRP_LUT1_ML 0xEEEEEEEE
-#define CFG_MDDRCGRP_LUT2_MU 0x44444444
+#define CFG_MDDRCGRP_PM_CFG1 0x00077777
+#define CFG_MDDRCGRP_PM_CFG2 0x00000000
+#define CFG_MDDRCGRP_HIPRIO_CFG 0x00000001
+#define CFG_MDDRCGRP_LUT0_MU 0xFFEEDDCC
+#define CFG_MDDRCGRP_LUT0_ML 0xBBAAAAAA
+#define CFG_MDDRCGRP_LUT1_MU 0x66666666
+#define CFG_MDDRCGRP_LUT1_ML 0x55555555
+#define CFG_MDDRCGRP_LUT2_MU 0x44444444
#define CFG_MDDRCGRP_LUT2_ML 0x44444444
-#define CFG_MDDRCGRP_LUT3_MU 0x55555555
+#define CFG_MDDRCGRP_LUT3_MU 0x55555555
#define CFG_MDDRCGRP_LUT3_ML 0x55555558
-#define CFG_MDDRCGRP_LUT4_MU 0x11111111
-#define CFG_MDDRCGRP_LUT4_ML 0x1111117C
-#define CFG_MDDRCGRP_LUT0_AU 0x33333377
-#define CFG_MDDRCGRP_LUT0_AL 0x7777EEEE
-#define CFG_MDDRCGRP_LUT1_AU 0x11111111
-#define CFG_MDDRCGRP_LUT1_AL 0x11111111
-#define CFG_MDDRCGRP_LUT2_AU 0x11111111
+#define CFG_MDDRCGRP_LUT4_MU 0x11111111
+#define CFG_MDDRCGRP_LUT4_ML 0x11111122
+#define CFG_MDDRCGRP_LUT0_AU 0xaaaaaaaa
+#define CFG_MDDRCGRP_LUT0_AL 0xaaaaaaaa
+#define CFG_MDDRCGRP_LUT1_AU 0x66666666
+#define CFG_MDDRCGRP_LUT1_AL 0x66666666
+#define CFG_MDDRCGRP_LUT2_AU 0x11111111
#define CFG_MDDRCGRP_LUT2_AL 0x11111111
-#define CFG_MDDRCGRP_LUT3_AU 0x11111111
+#define CFG_MDDRCGRP_LUT3_AU 0x11111111
#define CFG_MDDRCGRP_LUT3_AL 0x11111111
-#define CFG_MDDRCGRP_LUT4_AU 0x11111111
+#define CFG_MDDRCGRP_LUT4_AU 0x11111111
#define CFG_MDDRCGRP_LUT4_AL 0x11111111
/*
* NOR FLASH on the Local Bus
*/
+#undef CONFIG_BKUP_FLASH
#define CFG_FLASH_CFI /* use the Common Flash Interface */
-#define CFG_FLASH_CFI_DRIVER /* use the CFI driver */
+#define CONFIG_FLASH_CFI_DRIVER /* use the CFI driver */
+#ifdef CONFIG_BKUP_FLASH
+#define CFG_FLASH_BASE 0xFF800000 /* start of FLASH */
+#define CFG_FLASH_SIZE 0x00800000 /* max flash size in bytes */
+#else
#define CFG_FLASH_BASE 0xFC000000 /* start of FLASH */
#define CFG_FLASH_SIZE 0x04000000 /* max flash size in bytes */
+#endif
#define CFG_FLASH_USE_BUFFER_WRITE
-
#define CFG_MAX_FLASH_BANKS 1 /* number of banks */
-#define CFG_FLASH_BANKS_LIST {CFG_FLASH_BASE}
+#define CFG_FLASH_BANKS_LIST {CFG_FLASH_BASE}
#define CFG_MAX_FLASH_SECT 256 /* max sectors per device */
#undef CFG_FLASH_CHECKSUM
#define CFG_CS0_CFG 0x05059310 /* ALE active low, data size 4bytes */
#define CFG_CS2_CFG 0x05059010 /* ALE active low, data size 1byte */
+#define CFG_CS_ALETIMING 0x00000005 /* Use alternative CS timing for CS0 and CS2 */
/* Use SRAM for initial stack */
#define CFG_INIT_RAM_ADDR CFG_SRAM_BASE /* Initial RAM address */
#define CFG_MONITOR_BASE TEXT_BASE /* Start of monitor */
#define CFG_MONITOR_LEN (256 * 1024) /* Reserve 256 kB for Mon */
-#define CFG_MALLOC_LEN (512 * 1024) /* Reserved for malloc */
+#ifdef CONFIG_FSL_DIU_FB
+#define CFG_MALLOC_LEN (6 * 1024 * 1024) /* Reserved for malloc */
+#else
+#define CFG_MALLOC_LEN (512 * 1024)
+#endif
/*
* Serial Port
#define CONFIG_NET_MULTI
#define CONFIG_PHY_ADDR 0x1
#define CONFIG_MII 1 /* MII PHY management */
+#define CONFIG_FEC_AN_TIMEOUT 1
+#define CONFIG_HAS_ETH0
-#if 0
/*
* Configure on-board RTC
*/
-#define CONFIG_RTC_DS1374 /* use ds1374 rtc via i2c */
+#define CONFIG_RTC_M41T62 /* use M41T62 rtc via i2 */
#define CFG_I2C_RTC_ADDR 0x68 /* at address 0x68 */
-#endif
/*
* Environment
*/
-#define CFG_ENV_IS_IN_FLASH 1
+#define CONFIG_ENV_IS_IN_FLASH 1
/* This has to be a multiple of the Flash sector size */
-#define CFG_ENV_ADDR (CFG_MONITOR_BASE + CFG_MONITOR_LEN)
-#define CFG_ENV_SIZE 0x2000
-#define CFG_ENV_SECT_SIZE 0x40000 /* one sector (256K) for env */
+#define CONFIG_ENV_ADDR (CFG_MONITOR_BASE + CFG_MONITOR_LEN)
+#define CONFIG_ENV_SIZE 0x2000
+#ifdef CONFIG_BKUP_FLASH
+#define CONFIG_ENV_SECT_SIZE 0x20000 /* one sector (256K) for env */
+#else
+#define CONFIG_ENV_SECT_SIZE 0x40000 /* one sector (256K) for env */
+#endif
/* Address and size of Redundant Environment Sector */
-#define CFG_ENV_ADDR_REDUND (CFG_ENV_ADDR + CFG_ENV_SECT_SIZE)
-#define CFG_ENV_SIZE_REDUND (CFG_ENV_SIZE)
+#define CONFIG_ENV_ADDR_REDUND (CONFIG_ENV_ADDR + CONFIG_ENV_SECT_SIZE)
+#define CONFIG_ENV_SIZE_REDUND (CONFIG_ENV_SIZE)
#define CONFIG_LOADS_ECHO 1 /* echo on for serial download */
#define CFG_LOADS_BAUD_CHANGE 1 /* allow baudrate change */
#define CONFIG_CMD_PING
#define CONFIG_CMD_REGINFO
#define CONFIG_CMD_EEPROM
+#define CONFIG_CMD_DATE
#if defined(CONFIG_PCI)
#define CONFIG_CMD_PCI
#define CFG_HID0_FINAL HID0_ENABLE_MACHINE_CHECK
#define CFG_HID2 HID2_HBE
+#define CONFIG_HIGH_BATS 1 /* High BATs supported */
+
/*
* Internal Definitions
*
#define CONFIG_EXTRA_ENV_SETTINGS \
"u-boot_addr_r=200000\0" \
- "kernel_addr_r=300000\0" \
- "fdt_addr_r=400000\0" \
- "ramdisk_addr_r=500000\0" \
+ "kernel_addr_r=600000\0" \
+ "fdt_addr_r=880000\0" \
+ "ramdisk_addr_r=900000\0" \
"u-boot_addr=FFF00000\0" \
- "kernel_addr=FC040000\0" \
- "fdt_addr=FC2C0000\0" \
- "ramdisk_addr=FC300000\0" \
+ "kernel_addr=FFC40000\0" \
+ "fdt_addr=FFEC0000\0" \
+ "ramdisk_addr=FC040000\0" \
"ramdiskfile=ads5121/uRamdisk\0" \
- "fdtfile=ads5121/ads5121.dtb\0" \
"u-boot=ads5121/u-boot.bin\0" \
+ "bootfile=ads5121/uImage\0" \
+ "fdtfile=ads5121/ads5121.dtb\0" \
+ "rootpath=/opt/eldk/ppc_6xx\n" \
"netdev=eth0\0" \
"consdev=ttyPSC0\0" \
"nfsargs=setenv bootargs root=/dev/nfs rw " \
#define CONFIG_OF_LIBFDT 1
#define CONFIG_OF_BOARD_SETUP 1
+#define CONFIG_OF_SUPPORT_OLD_DEVICE_TREES 1
#define OF_CPU "PowerPC,5121@0"
-#define OF_SOC "soc@80000000"
-#define OF_SOC_OLD "soc5121@80000000"
+#define OF_SOC_COMPAT "fsl,mpc5121-immr"
#define OF_TBCLK (bd->bi_busfreq / 4)
#define OF_STDOUT_PATH "/soc@80000000/serial@11300"
projects / platform / kernel / u-boot.git / blobdiff