#define BOOTFLAG_COLD 0x01 /* Normal Power-On: Boot from FLASH */
#define BOOTFLAG_WARM 0x02 /* Software reboot */
-#define CFG_CACHELINE_SIZE 32 /* For MPC5xxx CPUs */
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
-# define CFG_CACHELINE_SHIFT 5 /* log base 2 of the above value */
-#endif
-
/*
* Serial console configuration
*/
#define CONFIG_BAUDRATE 115200 /* ... at 115200 bps */
#define CFG_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200, 230400 }
+/*
+ * Video console
+ */
+#define CONFIG_VIDEO
+#define CONFIG_VIDEO_SED13806
+#define CONFIG_VIDEO_SED13806_16BPP
+
+#define CONFIG_CFB_CONSOLE
+#define CONFIG_VIDEO_LOGO
+/* #define CONFIG_VIDEO_BMP_LOGO */
+#define CONFIG_CONSOLE_EXTRA_INFO
+#define CONFIG_VGA_AS_SINGLE_DEVICE
+#define CONFIG_VIDEO_SW_CURSOR
+#define CONFIG_SPLASH_SCREEN
+
#ifdef CONFIG_MPC5200 /* MGT5100 PCI is not supported yet. */
/*
#define CONFIG_PCI_IO_SIZE 0x01000000
#define CONFIG_NET_MULTI 1
+#define CONFIG_MII 1
#define CONFIG_EEPRO100 1
#define CFG_RX_ETH_BUFFER 8 /* use 8 rx buffer on eepro100 */
#define CONFIG_NS8382X 1
-#define ADD_PCI_CMD CFG_CMD_PCI
-
#else /* MGT5100 */
-#define ADD_PCI_CMD 0 /* no CFG_CMD_PCI */
+#define CONFIG_MII 1
#endif
#define CONFIG_DOS_PARTITION
/* USB */
-#if 1
#define CONFIG_USB_OHCI
-#define ADD_USB_CMD CFG_CMD_USB | CFG_CMD_FAT
#define CONFIG_USB_STORAGE
-#else
-#define ADD_USB_CMD 0
-#endif
+
+
+/*
+ * BOOTP options
+ */
+#define CONFIG_BOOTP_BOOTFILESIZE
+#define CONFIG_BOOTP_BOOTPATH
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_HOSTNAME
+
/*
- * Supported commands
+ * Command line configuration.
*/
-#define CONFIG_COMMANDS (CONFIG_CMD_DFL | \
- CFG_CMD_PING | \
- CFG_CMD_I2C | \
- CFG_CMD_EEPROM | \
- CFG_CMD_FAT | \
- CFG_CMD_IDE | \
- ADD_PCI_CMD | \
- ADD_USB_CMD)
-
-/* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
-#include <cmd_confdefs.h>
+#include <config_cmd_default.h>
+
+#if defined(CONFIG_MPC5200)
+ #define CONFIG_CMD_PCI
+#endif
+
+#define CONFIG_CMD_BMP
+#define CONFIG_CMD_EEPROM
+#define CONFIG_CMD_FAT
+#define CONFIG_CMD_I2C
+#define CONFIG_CMD_IDE
+#define CONFIG_CMD_PING
+#define CONFIG_CMD_USB
+
#if (TEXT_BASE == 0xFE000000) /* Boot low */
# define CFG_LOWBOOT 1
*/
#define CONFIG_BOOTDELAY 5 /* autoboot after 5 seconds */
-#define CONFIG_PREBOOT "echo;" \
- "echo Type \"run flash_nfs\" to mount root filesystem over NFS;" \
+#define CONFIG_PREBOOT \
+ "setenv stdout serial;setenv stderr serial;" \
+ "echo;" \
+ "echo Type \\\"run flash_nfs\\\" to mount root filesystem over NFS;" \
"echo"
#undef CONFIG_BOOTARGS
#define CONFIG_EXTRA_ENV_SETTINGS \
"netdev=eth0\0" \
"nfsargs=setenv bootargs root=/dev/nfs rw " \
- "nfsroot=$(serverip):$(rootpath)\0" \
+ "nfsroot=${serverip}:${rootpath}\0" \
"ramargs=setenv bootargs root=/dev/ram rw\0" \
- "addip=setenv bootargs $(bootargs) " \
- "ip=$(ipaddr):$(serverip):$(gatewayip):$(netmask)" \
- ":$(hostname):$(netdev):off panic=1\0" \
+ "addip=setenv bootargs ${bootargs} " \
+ "ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}" \
+ ":${hostname}:${netdev}:off panic=1\0" \
"flash_nfs=run nfsargs addip;" \
- "bootm $(kernel_addr)\0" \
+ "bootm ${kernel_addr}\0" \
"flash_self=run ramargs addip;" \
- "bootm $(kernel_addr) $(ramdisk_addr)\0" \
- "net_nfs=tftp 200000 $(bootfile);run nfsargs addip;bootm\0" \
+ "bootm ${kernel_addr} ${ramdisk_addr}\0" \
+ "net_nfs=tftp 200000 ${bootfile};run nfsargs addip;bootm\0" \
"rootpath=/opt/eldk/ppc_82xx\0" \
"bootfile=/tftpboot/MPC5200/uImage\0" \
""
/*
* IPB Bus clocking configuration.
*/
-#undef CFG_IPBSPEED_133 /* define for 133MHz speed */
+#undef CFG_IPBCLK_EQUALS_XLBCLK /* define for 133MHz speed */
#endif
/*
# define CFG_FLASH_SIZE 0x06000000
#endif /* CONFIG_TOTAL5200_REV */
-#if !defined(CFG_LOWBOOT)
+#if defined(CFG_LOWBOOT)
# define CFG_ENV_ADDR 0xFE040000
#else /* CFG_LOWBOOT */
# define CFG_ENV_ADDR 0xFFF40000
#define CFG_MBAR 0xF0000000 /* 64 kB */
#define CFG_FPGA_BASE 0xF0010000 /* 64 kB */
#define CFG_CPLD_BASE 0xF0020000 /* 64 kB */
-#define CFG_LCD_BASE 0xF0100000 /* 2048 kB */
+#define CFG_LCD_BASE 0xF1000000 /* 4096 kB */
/* Use SRAM until RAM will be available */
#define CFG_INIT_RAM_ADDR MPC5XXX_SRAM
*/
#define CFG_LONGHELP /* undef to save memory */
#define CFG_PROMPT "=> " /* Monitor Command Prompt */
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
+#if defined(CONFIG_CMD_KGDB)
#define CFG_CBSIZE 1024 /* Console I/O Buffer Size */
#else
#define CFG_CBSIZE 256 /* Console I/O Buffer Size */
#define CFG_HZ 1000 /* decrementer freq: 1 ms ticks */
+#define CFG_CACHELINE_SIZE 32 /* For MPC5xxx CPUs */
+#if defined(CONFIG_CMD_KGDB)
+# define CFG_CACHELINE_SHIFT 5 /* log base 2 of the above value */
+#endif
+
+
/*
* Various low-level settings
*/
#define CFG_CS1_CFG 0x0019FF00 /* 25WS, MX, AL, AA, CE, AS_25, DS_32 */
#define CFG_CS2_START CFG_LCD_BASE
-#define CFG_CS2_SIZE 0x00200000 /* 2048 kB */
-#define CFG_CS2_CFG 0x0019FD00 /* 25WS, MX, AL, AA, CE, AS_25, DS_16 */
+#define CFG_CS2_SIZE 0x00400000 /* 4096 kB */
+#define CFG_CS2_CFG 0x0032FD0C /* 50WS, MX, AL, AA, CE, AS_25, DS_16, endian swapping */
#if CONFIG_TOTAL5200_REV==1
# define CFG_CS3_START CFG_CPLD_BASE
projects / platform / kernel / u-boot.git / blobdiff