configs: Migrate CONFIG_SYS_MAX_FLASH_BANKS to Kconfig

[platform/kernel/u-boot.git] / include / configs / T4240RDB.h

diff --git a/include/configs/T4240RDB.h b/include/configs/T4240RDB.h
index 87e3e67..6923774 100644 (file)
--- a/include/configs/T4240RDB.h
+++ b/include/configs/T4240RDB.h
@@ -60,7 +60,6 @@
 #define CONFIG_PCIE1                   /* PCIE controller 1 */
 #define CONFIG_PCIE2                   /* PCIE controller 2 */
 #define CONFIG_PCIE3                   /* PCIE controller 3 */
-#define CONFIG_SYS_PCI_64BIT           /* enable 64-bit PCI resources */
 
 /*
  * These can be toggled for performance analysis, otherwise use default.
@@ -225,12 +224,6 @@
        "setenv bootargs config-addr=0x60000000; "      \
        "bootm 0x01000000 - 0x00f00000"
 
-#define CONFIG_SYS_CLK_FREQ    66666666
-
-#ifndef __ASSEMBLY__
-unsigned long get_board_sys_clk(void);
-#endif
-
 /*
  * DDR Setup
  */
@@ -274,7 +267,6 @@ unsigned long get_board_sys_clk(void);
 #define CONFIG_SYS_FLASH_QUIET_TEST
 #define CONFIG_FLASH_SHOW_PROGRESS     45 /* count down from 45/5: 9..1 */
 
-#define CONFIG_SYS_MAX_FLASH_BANKS     2       /* number of banks */
 #define CONFIG_SYS_MAX_FLASH_SECT      1024    /* sectors per device */
 #define CONFIG_SYS_FLASH_ERASE_TOUT    60000   /* Flash Erase Timeout (ms) */
 #define CONFIG_SYS_FLASH_WRITE_TOUT    500     /* Flash Write Timeout (ms) */
@@ -408,12 +400,6 @@ unsigned long get_board_sys_clk(void);
 #define I2C_VOL_MONITOR_BUS_V_OVF      0x1
 #define I2C_VOL_MONITOR_BUS_V_SHIFT    3
 
-#define CONFIG_VID_FLS_ENV             "t4240rdb_vdd_mv"
-#ifndef CONFIG_SPL_BUILD
-#define CONFIG_VID
-#endif
-#define CONFIG_VOL_MONITOR_IR36021_SET
-#define CONFIG_VOL_MONITOR_IR36021_READ
 /* The lowest and highest voltage allowed for T4240RDB */
 #define VDD_MV_MIN                     819
 #define VDD_MV_MAX                     1212
@@ -456,24 +442,6 @@ unsigned long get_board_sys_clk(void);
 #define CONFIG_SYS_DPAA_RMAN
 #define CONFIG_SYS_INTERLAKEN
 
-/* Default address of microcode for the Linux Fman driver */
-#if defined(CONFIG_SPIFLASH)
-/*
- * env is stored at 0x100000, sector size is 0x10000, ucode is stored after
- * env, so we got 0x110000.
- */
-#define CONFIG_SYS_FMAN_FW_ADDR        0x110000
-#elif defined(CONFIG_SDCARD)
-/*
- * PBL SD boot image should stored at 0x1000(8 blocks), the size of the image is
- * about 1MB (2048 blocks), Env is stored after the image, and the env size is
- * 0x2000 (16 blocks), 8 + 2048 + 16 = 2072, enlarge it to 2080.
- */
-#define CONFIG_SYS_FMAN_FW_ADDR        (512 * 0x820)
-#else
-#define CONFIG_SYS_FMAN_FW_ADDR        0xEFF00000
-#endif
-#define CONFIG_SYS_QE_FMAN_FW_LENGTH   0x10000
 #define CONFIG_SYS_FDT_PAD             (0x3000 + CONFIG_SYS_QE_FMAN_FW_LENGTH)
 #endif /* CONFIG_NOBQFMAN */
 
@@ -516,7 +484,6 @@ unsigned long get_board_sys_clk(void);
 /*
 * USB
 */
-#define CONFIG_USB_EHCI_FSL
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
 #define CONFIG_HAS_FSL_DR_USB
 
@@ -565,40 +532,6 @@ unsigned long get_board_sys_clk(void);
        "setenv bootargs config-addr=0x60000000; "      \
        "bootm 0x01000000 - 0x00f00000"
 
-#define LINUXBOOTCOMMAND                                       \
-       "setenv bootargs root=/dev/ram rw "             \
-       "console=$consoledev,$baudrate $othbootargs;"   \
-       "setenv ramdiskaddr 0x02000000;"                \
-       "setenv fdtaddr 0x00c00000;"                    \
-       "setenv loadaddr 0x1000000;"                    \
-       "bootm $loadaddr $ramdiskaddr $fdtaddr"
-
-#define HDBOOT                                 \
-       "setenv bootargs root=/dev/$bdev rw "           \
-       "console=$consoledev,$baudrate $othbootargs;"   \
-       "tftp $loadaddr $bootfile;"                     \
-       "tftp $fdtaddr $fdtfile;"                       \
-       "bootm $loadaddr - $fdtaddr"
-
-#define NFSBOOTCOMMAND                 \
-       "setenv bootargs root=/dev/nfs rw "     \
-       "nfsroot=$serverip:$rootpath "          \
-       "ip=$ipaddr:$serverip:$gatewayip:$netmask:$hostname:$netdev:off " \
-       "console=$consoledev,$baudrate $othbootargs;"   \
-       "tftp $loadaddr $bootfile;"             \
-       "tftp $fdtaddr $fdtfile;"               \
-       "bootm $loadaddr - $fdtaddr"
-
-#define RAMBOOTCOMMAND                         \
-       "setenv bootargs root=/dev/ram rw "             \
-       "console=$consoledev,$baudrate $othbootargs;"   \
-       "tftp $ramdiskaddr $ramdiskfile;"               \
-       "tftp $loadaddr $bootfile;"                     \
-       "tftp $fdtaddr $fdtfile;"                       \
-       "bootm $loadaddr $ramdiskaddr $fdtaddr"
-
-#define CONFIG_BOOTCOMMAND             LINUXBOOTCOMMAND
-
 #include <asm/fsl_secure_boot.h>
 
 #endif /* __CONFIG_H */